Milwaukee LSM40MP-2 - Manual
Milwaukee LSM40MP-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Please read and understand these; stone; INTRODUCTION; WARNING; GENERAL INFORMATION
- Page 3 – Table 1
- Page 4 – Flame appearance will diminish 4% per; Table 4; Figure 1; Table 2; REQUIREMENTS FOR THE COMMON-; Figure 2
- Page 5 – LOCATION; Figure 3; Figure 3 - Typical Installation; COLD CLIMATE INSULATION; Cross Corner
- Page 6 – Figure 6 - Side Elevation View; Termination Heights For Vents; Vertical Vent Termination Clearances; These instructions should be used as a; Vertical Vent Termination Clearances; Figure 4; Horizontal Vent Termination Clearances; Figure 6; Minimum; Figure 4 - Multiple Terminations
- Page 7 – ExTERIOR HORIZONTAL VENT TERMINATION CLEARANCE REQUIREMENTS; Minimum Clearances; condensation; Figure 7; NOTE: Local Codes Or Regulations May Require
- Page 8 – Shelf Height; Figure 8; MINIMUM CLEARANCES TO COMBUSTIBLES; When the; Figure 9; Top Vent - with 2 Feet Vertical Vent and One 90 Degree Elbow
- Page 9 – Figure; DO NOT; DETAILED INSTALLATION STEPS; Page 9
- Page 10 – Fireplace Dimensions; FIREPLACE AND FRAMING SPECIFICATIONS; Framing Dimensions
- Page 11 – Back wall of chase/enclosure; Schedule 40 Pipe; Table 6; Proper Sizing of Gas Line; Right Side; Step 2. ROUTING GAS LINE
- Page 12 – VENT RESTRICTOR INSTALLATION; Step 3. INSTALL THE VENT SYSTEM; See Approved Vent Components on; These fireplaces must be vented directly; Note: The restrictor is included within the
- Page 13 – Figure 17 and Figures 25 through 27 on; Secure VentTM; Figure 5 on Page 6; Effective Vent Length; Model; Table 7
- Page 15 – Figure 22 - Roof Framing; on; Swivel Joint; Storm
- Page 16 – Table B; Ceiling; Table A; Maximum; VERTICAL VENT FIGURES/TABLES; • Secure VentTM (rigid vent pipe) is shown; A Vent Restrictor, as shown in Figure 15 on Page
- Page 17 – TYPICAL HORIZONTAL VENT INSTALLATION; Support the vertical portion of the venting system; to
- Page 18 – For wall thicknesses greater than; Venting Connection and Exterior Wall Recessing; See Figure 12 on Page 10 for Minimum; Distance to Base of Appliance; Step B; IMPORTANT: The vent termination is hot
- Page 19 – Table 8; range of exterior wall thicknesses.; zontal vent run is needed, then; HORIZONTAL VENT FIGURES/TABLES; • Secure VentTM
- Page 21 – CAUTION; Figures 35 and; the current CSA C22-1 Canadian; Verify proper operation after servicing.; ELECTRONIC; See Figure 36 for detailed; drawing of junction box /; see Figure 12 on Page
- Page 22 – Gas; WIRING
- Page 23 – Never use an open flame to; Millivolt Appliance Checkout
- Page 24 – Excessive use of embers may result in sooting or poor flame.; Place logs 2 and 3; Mixture Of Volcanic Stone And Vermiculite
- Page 27 – adjust the flame height as desired, by sliding; Main Burner Factory Air Shutter; Burner Air Shutter Adjustment Procedure
- Page 28 – FINISHING REQUIREMENTS; door track and the surface of the finish material.
- Page 29 – LENNOx HEARTH PRODUCTS; La chimenea caliente; Un foyer chaud peut causer; ADVERTENCIA; ATTACHING SAFETY IN OPERATION WARNINGS; Hot Fireplace Will Cause; LENNOx HEARTH PRODUCTS; AVERTISSEMENT
- Page 31 – this installation assumes responsibility for this conversion.; assume les responsabilités liées à la conversion.; Burner Assembly
- Page 32 – VERIFY THE PROPER ORIFICE SIZE BE-; Millivolt & Electronic Gas Valves; Millivolt & Electronic Pilot Assemblies; Table 9
DR
AF
T
3/0
8/2
01
0
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
INSTALLATEUR: Laissez cette notice avec l'appareil.
CONSOMMATEUR: Conservez cette notice pour consul-
tation ultérieure.
- Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
- Installation and service must be performed by a quali-
fied installer, service agency or the gas supplier.
WARNING: If the information in these instructions is
not followed exactly, a fire or explosion may result
causing property damage, personal injury or death.
- Ne pas entreposer ni utilizer d’essence ni d’autres
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d’allumer d’appareil.
• Ne touchez à aucan interrupteur. Ne pas vous servir
des téléphones se trouvant dans le bâtiment où vous
trouvez.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du fournis-
seur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incindies.
- L’installation et l’entretien doivent être assurés par un
installateur ou un service d’entretien qualifié ou par
le fournisseur de gaz.
AVERTISSEMENT: Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire
au minimum le risque d’incindie ou d’explosion ou
pour éviter tout dommage matériel, toute blessure
ou la mort.
INSTALLATION INSTRUCTIONS
Ce manuel d’installation est disponible en francais, s implement en faire
la demande. Numéro de la pièce 850,026CF.
MODELS
OTL Report No. 116-F-22-5
US
Portland
P/N 850,026M REV. E 03/2010
Direct
-
Vent
MONTEBELLO™
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating
plate. This appliance is not convertible for use with other gases, unless a certified kit is used.
WARNING AVERTISSEMENT
UNE SURFACE VITR E CHAUDE PEUT
CAUSER DES BR LURES.
LAISSER REFROIDIR LA SURFACE
VITRE AVANT D'Y TOUCHER.
NE PERMETTEZ JAMAIS UN ENFANT
DE TOUCHER LA SURFACE VITRE.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
TM
Millivolt Models
Electronic Models
LSM40MN-2
LSM40EN-2
LSM40MP-2
LSM45EN-2
LSM45MN-2
LSM45MP-2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Milwaukee LSM40MP-2
Summary
2 TABLE OF CONTENTS Packaging..........................................Page. 2Introduction.......................................Page. 2General.Information...........................Page. 2Massachusetts.and.New.York....Requirements.................................Page. 4Cold.Climate.Insulation.........
3 Note: Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bed- ding material, etcetera. It is imperati...
4 NOTE:.DIAGRAMS.&.ILLUSTRATIONS.ARE.NOT.TO.SCALE. These.appliances.must.be.isolated.from.the. gas.supply.piping.system.(by.closing.their. individual.manual.shut-off.valve).during.any. pressure. testing. of. the. gas. supply. piping. system. at. test. pressures. equal. to. or. less than .1/2.psi...