Miele DA 249-4 - Manual

Technical safety ~ Before installation, check the cooker hood for visible signs of damage.Under no circumstances should youuse a damaged appliance. A damagedappliance is dangerous. ~ Before connecting the appliance to the mains supply, make sure that thevoltage and frequency details given onthe data...

~ Do not connect the appliance to the mains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of the appliance (e.g. danger ofoverheating). ~ For appliances with an external fan motor fitted (...EXT models) theconnection of the two units must bem...

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and the heater are in operationsimultaneously, an underpressure of0.04 mbar (4 pa) is the maximumpermissible in the room. Ventilation can be maintained by ...

~ Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. ~ All ducting, pipework and fittings must be of non-flammable material.These can be obtained from the MieleSpare Parts department or frombuilders' merchants. ~ The appliance must not be connected to a chimney or vent ...

The cooker hood works with . . . air extraction: The air is drawn in and cleaned by thestainless steel outer filter and thegrease filter, and then directed outside. If the on-site ventilation system doesnot have a non-return flap , then the non-return flap supplied with theappliance must be fitted H...

Con | ctivity This cooker hood is communicationenabled. Communication module XKM 2000 DA a , available as an optional extra, enables the operation of the cookerhood to be automatically controlled bythe operating status of a Miele electrichob with onset controls. For communication to take place, theh...

To switch the fan on ^ Press the On/Off control. The fan will come on at power level "II". The indicator lamp will come on. To select a power level ^ Use the – / + controls to select the power level required. + control = higher setting – control = lower setting Depending on the intensity of ...

The indicator lamps for fan power levelsI and IV will flash if the automaticswitch-off for the Intensive setting is notactivated. ^ Press the + control to activate auto- matic switch-off.The indicator lamps for fan powerlevels I and IV will now light upconstantly.Press the – control to deactivate th...

To switch the hob lighting on The hob lighting can be switched onand off independently of the fan. ^ Briefly press the lighting control toswitch on the hob lighting. The indicator lamp will come on. The hob lighting will switch on atmaximum brightness. To dim the hob lighting The brightness of the l...

The – / + indicator lamps show the time which has been set:1st lamp from the left = 20 hours2nd lamp from the left = 30 hours3rd lamp from the left = 40 hours4th lamp from the left = 50 hours ^ Use the – / + controls to select the desired time. ^ Confirm the selection by pressing thegrease filter co...

A range of Miele branded cleaning andconditioning agents are available toorder through your Miele Dealer /Chartered Agent, the Miele Spare PartsDepartment, or via the internet onwww.miele-shop.com. , Before any cleaning or maintenance work is carried out,disconnect the cooker hood fromthe mains supp...

Important for appliances withstainless steel housing (This infomation does not apply to thecontrols). Stainless steel surfaces can be cleanedusing the Miele E-Cloth, or with aproprietary non-abrasive cleaningagent designed specifically for use onstainless steel. To help prevent re-soiling, aconditio...

To remove the stainless steel outerfilter ^ To remove the outer filter pull downon the quick-release catches. Whendoing this, hold the filter securely sothat it does not fall on the hob surfacebelow. To remove the grease filter ^ Hold the grease filter by the grip, andpull it downwards to remove it....

^ After cleaning, leave the filters to dryfor a while on an absorbent surfacebefore putting them back in place. ^ When removing the filters forcleaning, also clean off any residuesof oil or fat from the now accessiblehousing to prevent the risk of thesecatching fire. ^ After cleaning the filters, pr...

Fitting and replacing thecharcoal filter If the cooker hood is connected forrecirculation, a charcoal filter must beinserted in addition to the grease filter.This is designed to absorb cookingodours.It is fitted in the chimney above thegrease filter. Replacement charcoal filters can beobtained from ...

Changing a halogen lamp ^ Before any cleaning or maintenancework, disconnect the cooker hoodfrom the mains supply. , Exercise caution when changing halogen lamps. They get very hotduring use and remain hot for sometime after being switched off. Letthem cool down before you changethem. ^ Remove the s...

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele,please quote the model and serialnumber of your ...

The diagram is not drawn to scale. 1) Extraction 2) Recirculation 3) Ventilation grille positioned at the topfor recirculation 4) and 5):(5 is not required for recirculation modecooker hoods)The shaded area represents the wall or ceiling area for the vent cut-out, forfitting the connection socket an...

– If the exhaust air is to be ducted into the open air, the installation of atelescopic wall vent or roof vent isrecommended. – If the exhaust air is to be ducted into a vent flue, the ducting must bedirected in the flow direction of theflue. Important. If the exhaust ducting is to run throughrooms,...

Silencer (optional accessory) To achieve even further reductions innoise levels, a special silencer can befitted in the ducting system... ...with air extraction: The silencer not only reduces noisefrom the fan, but also sounds fromoutside (e.g. traffic noise).For this reason the silencer must beposi...

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulations(BS 7671 in the UK). Installation, repairs and other workby unqualified persons could bedangerous, for which themanufacturer cannot be held liable....

The Miele DSM 400 control module canbe used to combine the cooker hoodwith other components. It enables the following: Potential free connection This can be used to operate a furtherappliance via the On/Off button s on the cooker hood. The potential free contact on theDSM 400 a can, for example, be ...

Total connected load* . . . . . . . . . 240 W– Fan motor* . . . . . . . . . . . . . . . . 200 W– Hob lighting . . . . . . . . . . . . . 2 x 20 W Halogen lampsOsram type 44890 WFL, 20 W Voltage . . . . . . . . . . . . . . . . . . . . 230 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rati...