Metra 95-7801 - Manual
Metra 95-7801 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS
- Page 3 – Rear Support Tray; Radio
- Page 12 – DOUBLE DIN RADIO PROVISION
- Page 13 – FINAL ASSEMBLY; B) Twist ends together; FINAL WIRING CONNECTIONS; METRA / EIA WIRING CODE; When a Black wire is not present, ground radio to vehicle chassis.
- Page 14 – NOTES
INSTALLATION INSTRUCTIONS FOR PART 95-7801
95-7801
APPLICATIONS
See Application List Inside
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Units Provision
• A) Radio Housing • B) Rear Support Tray • C) ISO Brackets
• D) Mounting Bracket (Acura legend) • E) (2) #8 x 1/2” Phillips Pan Head Screws
• F) (6) #6 x 1/4” Phillips Flat Head Screws
KIT COMPONENTS
TOOLS REQUIRED:
• Phillips Screwdriver • Cutting Tool
1-800-221-0932
© COPYRIGHT 2001-2008 METRA ELECTRONICS CORPORATION
www.metraonline.com
B
A
C
D
E
F
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Dash Disassembly / Kit Preparation - ACURA - CL 1997-99 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - Integra 1990-93 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - Integra 1994-01 . . . . . . . . . . . . . . . . . . . . . . ...
95-7801 DASH DISASSEMBLY ACURA CL 1997-1999 1 Unclip the radio trim bezel and disconnect theclock and climate control wiring. Remove (2)8mm hex-head screws securing the factoryhead unit and disconnect the wiring. (Fig. A) 2 Cut and remove all mounting clips on the Radio Housing EXCEPT clips "A&#...
95-7801 KIT ASSEMBLY 10 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 3 DOUBLE-DIN HEAD UNITS: Cut and remove the dividing rib from the radio opening. Cut and remove all mounting tabs on the ISO Brackets, align the holes in the Brackets with the holesin the hea...
