LG LD1484T4 - User Manual

5 IMPORTANT SAFETY INSTRUCTIONS Read all instructions before use WARNING To reduce the risk of fire, electric shock, or injury to persons when using the dishwasher, follow basic precautions, including the following: • Do not use any kinds of solvent in your dishwasher. They may cause an explosion or...

6 IMPORTANT SAFETY INSTRUCTIONS CAUTION The instructions shall state the substance of the following : This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervi...

• A qualified electrician/plumber or competent person should carry out any electrical/ plumbing work required to install this appliance. WARNING 1. This appliance must be supplied with correct rating voltage and hertz as shown on instruction manual, and connected to an individual, properly earthed b...

• If the height of the cupboard is below 850mm, you can remove the top table by unscrewing the 2 screws. (Two from rear) CAUTION 1. Lay the dishwasher on its back. 2. Adjust the legs to the required height as shown in below figure. 1. Before sliding the dishwasher into the cupboard opening, all nece...

9 1. If the end of drain hose does not fit to the drain line, use a rubber connector(not supplied) that is resistant to heat and detergent. 2. This should be available from a plumbing shop or a hardware store. 3. There are two typical connections as shown in Figure A, B. The S trap spigot must be dr...

10 • This dishwasher may be fed with either hot or cold water. If the water can not be maintained below 65ºC, the dishwasher must be connected to cold water. • When connecting, you may use sealant tape or sealing compound to avoid water leaks. • Make sure that the line is not kinked or sharply bent....

PARTS NAME 11 1. Control Panel2. Door Handle 3. Front Cover4. Lower Cover5. Display Window6. Power Button7. Drain Hose8. Inlet Hose9. Power Cord10. Adjustable Leg 11. Upper Rack12. Cutlery Basket13. Detergent And Rinse Aid Dispenser14. Vapor Vent Cover15. Upper Spray Arm16. Lower Spray Arm17. Filter...

12 MODEL : LD-1485T(W,L,M,B,C,S)4 FUNCTION OF CONTROL BUTTON ① Programme • Press the cycle that corresponds to your desired wash cycle. ② Rinse • Repeated pressing of the Rinse button will select Extra Hot, Rinse+, Extra Hot & Rinse+. • If you select the Extra Hot( ) function, the operating temp...

13 SMARTDIAGNOSIS ™ function is available only for the products with a SMARTDIAGNOSIS ™ mark. (Refer to Page 36.) ⑥ Delay Start • If you want to delay the start of the selected programme, press this button. • Pressing this button will increase the starting time by 1 hour increments. • The delay star...

■ Method 1 1) Check the water hardness in your area. (Your water utility company can help you with this.) 2) Set the softening system level of your dishwasher according to the water hardness level. Refer to Step 2. ■ Method 2 1) Check your water hardness by using a test strip. ( ) 2) Test Procedure ...

Water softer salt can be purchased from Salt distributors. 19 Step 4. Adding Rinse Aid ■ For filling Step 3. Salt Filling Fill the regenerating salt container before starting the washing programme . Once you have filled with salt you must run the Quick course immediately to remove salt and salt wate...

21 Daily use load 1. Cutlery Basket 2. Cutlery Rack 3. Upper Rack 4. Lower Rack HOW TO USE AND OPERATE • Do not place pots or pans with plastic handles in the washer as the handles may deteriorate due to the heat and detergent. • Water proof or long lasting lipstick smudges on glasses may not be rem...

22 NOTE Non Dishwasher Safe Items The combination of high water temperatures and dishwasher detergent may damage particular items, therefore we do not recommend using the dishwasher to wash the following: Copper or anodised aluminium Hand painted silver or gold leaf crockery Wood or bone handled ute...

• To prevent injuries, place knives and other utensils with sharp points on the cutlery rack. • If you want to load them in the cutlery basket, place them with the pointed edges facing downwards. WARNING 23 3. Lower Rack The lower rack is suitable for dinner plates, soup bowls, dishes, pots, pans, l...

25 How to fold down Long stem glassware can be placed without interference from the lowered tines. • Pull up the tine • Rotate the tine Take care not to obstruct the rotation of the spray arm under the upper rack. To make it easier to load larger cups or glasses, the left side row of tines can be fo...

26 Place proper detergent into this compartment Push button to open When using tablets, place them onto the inside surface of the door, or the base of the washer. The use of some combined detergent/rinse aid tablets can cause the dispenser to remain shut during the wash due to their size. Do not use...

27 6. Refilling ■ For refilling Rinse Aid Depending on the dosage setting and the number of washes, the chamber may need to be topped up, approximately once a month. The rinse aid level can be checked by two methods.• By the indicator window on the dispenser when the dishwasher door is fully open. ●...

28 7. Drying ■ To assist drying, we recommend that the door be partially opened after the cycle. The display will indicate Cd(cool dry) for a further 60 minutes after the end of the cycle time. It can be interrupted or terminated by simply opening the door. ■ The use of rinse aid is recommended for ...

29 1. Press the Power button2. Check there is rinse aid and salt The corresponding indicator light will illuminate if refilling is required. 3. Open the door and check the filters Ensure they are clean and properly positioned. (See User Maintenance Instructions) 4. Load the dishes Remove any excess ...

30 30 ▶ Running time may vary according to the water temperature, water pressure and voltage. ▶ Running time doesn’t include Cool Dry - 60min. washing time, temperature, level of water jet and the number of rinses. As a result, the energy and water consumption is kept as low as possible. The "F&...

31 31 ▶ Running time may vary according to the water temperature, water pressure and voltage. ▶ Running time doesn’t include Cool Dry - 60min. This program offers the most efficient energy and water consumption for a good washing performance on a moderately soiled load, but compromises the drying re...

32 32 To prevent trouble and poor operation, it is important to check filters and spray arms at regular intervals. Storing the dishwasher • If you are not using the dishwasher for a long time, run a Quick & Dry cycle without detergent. When the cycle is finished, clean the dishwasher according t...

33 33 • If a problem occurs check below to see whether this can be solved. • In the unlikely event that the problem cannot be rectified, please contact the manufacturer. TROUBLE SHOOTING GUIDE Before calling for service Problem Possible Causes Solution No lights come on when the power is turned on. ...

35 Code Description The display shows PF code This indicates there was a power failure. This function protects the dishwasher in the event that the power goes out or the power to the unit is disrupted. When power is returned, and a button is pushed, this will display for 3 seconds and then go away. ...

36 Only use this feature when instructed to do so by the call centre. The transmission sounds similar to a fax machine, and so has no meaning except to the call centre. SMARTDIAGNOSIS™ can not be activated if the dishwasher does not power up. If this happens, then troubleshooting must be done withou...

37 SPECIFICATION Capacity Weight Power Supply Power Consumption Water Feed Pressure 14 Place settings See rating label See rating label See rating label 0.05 ~ 0.6 MPa The maximum permissible inlet water pressure, in megapascals The minimum permissible inlet water pressure, in megapascals (This is n...