Honeywell Thermostat CT31- User Manual

Honeywell Thermostat CT31

Honeywell Thermostat CT31– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – Remove your old thermostat; Did you purchase right thermostat? Count wires to check.
  • Page 3 – Label wires and remove old wallplate; Mark mounting position
  • Page 4 – Connect wires; Existing wires; Mount thermostat base
  • Page 5 – Set adjustment lever; Your system
  • Page 6 – Operation; Fan switch; System switch; Temperature setting
  • Page 7 – Limited Warranty; If the product is defective,
  • Page 8 – Honeywell International Inc.; Automation and Control Solutions; Honeywell Limited-Honeywell Limitée
  • Page 9 – Termostato de bajo voltaje; Lista de comprobación previa a la instalación; Herramientas y materiales necesarios; Asegúrese de que el paquete contenga los siguientes elementos:
  • Page 10 – Remueva su viejo termostato; ¿Compró el termostato correcto? Cuente los cables.
  • Page 11 – Rotule los cables y retire la vieja placa de montaje; Repérez la position de montage
  • Page 12 – Conecte los cables; Cables existentes Conecte a:; Coloque la placa de montaje; ¿Los rótulos no coinciden?
  • Page 13 – Coloque la palanca de ajuste en posición; Finalice la instalación; Su sistema
  • Page 14 – Instrucciones de manejo; Interruptor del sistema
  • Page 15 – Garantía limitada; Si el producto es defectuoso:
Loading the manual

CT31

Low-voltage Thermostat

Owner’s
Manual

Getting started

Before you begin, make sure you have:

•

Screwdriver

•

Hammer

•

Level (optional)

•

Pencil

•

Drill bit (3/16” for drywall, 7/32” for plaster)

® U.S. Registered Trademark. Patents pending.

Copyright © 2005 Honeywell International Inc.

All rights reserved.

Caution card

Wire labels

Wall anchors and
mounting screws
(2 each)

CT31 thermostat

Cover plate

Check to make sure your package includes the following items:

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Remove your old thermostat; Did you purchase right thermostat? Count wires to check.

Owner’s Manual 2 Remove your old thermostat 1 T Tu urrn n o offff p po ow we err at heating/cooling system (or fuse/circuit-breaker panel). 2 Remove cover and thermostat, but leave wallplate with wires attached. Old thermostat Leave wallplate in place Is there a sealed tube containing mercury? If so...

Page 3 - Label wires and remove old wallplate; Mark mounting position

CT31 Low-voltage Thermostat 3 Label wires and remove old wallplate Use a screwdriver to disconnect wires one by one. As you disconnect each wire,wrap it with the label matching the letter on your old thermostat. (Adhesive labelsare supplied in your thermostat package.) Remove the old wallplate only ...

Page 4 - Connect wires; Existing wires; Mount thermostat base

Owner’s Manual 4 Connect wires 1 Match each labeled wirewith same letter on terminal. 2 Use a screwdriver to loosenscrew terminals, wrap barewire securely around termi-nals, then tighten screws. 3 Push any excess wire backinto the wall opening. Labels don’t match? If labels do not match letters onth...

Other Honeywell Models