Honeywell 24DX47 - Manuals - manualsarea.com

Page 3 - Waste Electrical and; EMF Statement

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 3 31-00722-01 ABOUT THIS GUIDE This Guide provides information about the Installation details of the INNCOM direct D1-529 Thermostat and D-X47 Relay to the system integrator, technicians, and end-users. All the electrical...

Page 4 - WARNING; INTRODUCTION

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 4 Professional installation Warning • This device must be professionally installed, this should be noted on grantee. • To maintain compliance, only the antenna types that have been tested shall be used. • This...

Page 5 - DIMENSIONS

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 5 31-00722-01 DIMENSIONS D1-529 Thermostat Fig. 1 D1-529 Thermostat Dimensions D-X47 Relay Fig. 2 D-X47 Relay Dimensions 4.7 inches (119.84 mm) 4.7 inches (119.84 mm) 4.87 inches (123.84 mm) 4.87 inches (123.84 mm) 1.18 i...

Page 6 - SPECIFICATIONS

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 6 SPECIFICATIONS (D1-529 THERMOSTAT) General Electrical Sensors Environmental Specifications Weight and Dimensions Display Communications Table 1 General Specifications Parameter Description Standard Color Opt...

Page 7 - Standards and Approvals; Electrical; Table 8 Standards and Approvals

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 7 31-00722-01 Standards and Approvals SPECIFICATIONS (D-X47 RELAY) Electrical Environmental Specifications Weight and Dimensions Standards and Approvals Table 8 Standards and Approvals FCC ID: GTC202153TXR (FCC Part 15 su...

Page 8 - SYSTEM ARCHITECTURE; Fig. 3 System Architecture

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 8 SYSTEM ARCHITECTURE Fig. 3 System Architecture Firewall D-578Edge Router NIAGARA GATEWAY REMOTE BUILDING MANAGER Legend IP EthernetRF Network Common Area Network Switch RF Network IP Ethernet D1-529 Thermost...

Page 9 - INSTALLATION; Important Safety Information and; CAUTION; Before Installation

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 9 31-00722-01 INSTALLATION Important Safety Information and Installation Precautions Read the below instructions carefully for safety and installation. Local codes and practices Always install equipment in accordance with...

Page 10 - Restricting Access to Network

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 10 guest comfort and unnecessary energy costs. Follow these guidelines to determine the appropriate installation location for the thermostat: • Place thermostats away from windows to avoid bathing the thermost...

Page 15 - GETTING STARTED; Home Screen - User Interface; Table 14 D1-529 Thermostat User Interface

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 15 31-00722-01 GETTING STARTED Home Screen - User Interface (D1-529) The D1-529 thermostat user interface contains 1. LCD display2. Power ON/OFF Button3. Fan Button4. Display Button5. Up arrow Button6. °F|°C Button7. Down...

Page 17 - INITIAL CONFIGURATION; Set the Room ID; rId

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 17 31-00722-01 INITIAL CONFIGURATION This section describes the initial installation and configuration of new D1-529 and D-X47 devices. If the system is already configured and you need to replace the previously configured...

Page 18 - Room Copy

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 18 NOTE: NOTE: Press the POWER button to cycle between the HI, LOW and MED values. 7. Press DISPLAY to store the value, when the desired Room ID is defined. The D1-529 will beep and the new Room ID number scro...

Page 19 - Setup Fan Speed

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 19 31-00722-01 The new D-X47 should now be configured with the same settings as from the configured D-X47 and you should be able to begin using it. Go to the Room Configuration Complete section. • If the room copy had sta...

Page 20 - Checking Functionality:; Room Configuration Complete

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 20 2. Press the UP/DOWN arrow button to set the fan speed by selecting a value 1, 2 or 3: Based on the HVAC type selection from the HAC menu, you will be limited to which of the 3 Fan values can be selected. V...

Page 22 - ADVANCED CONFIGURATION

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 22 ADVANCED CONFIGURATION The D1-529 has a Service Parameter mode with several parameters that can be used to configure, test and troubleshoot the D1-529 and D-X47. NOTE: NOTE: These are advanced features and ...

Page 25 - Tune Energy Savings

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 25 31-00722-01 For example, if you have selected HVAC Type 1 FCU-4, Fan speed options 1-Low, 2 -Low/High and 3 – Low/Med/High will be available. 5. Press DISPLAY to store the setting, the D1-529 beeps to confirm it is set...

Page 31 - Service Parameter SEr

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31 31-00722-01 2. Press the UP/DOWN arrow button and select Uln parameter. 3. Press the DISPLAY button start the test. V --- will appear on the display. 4. Open the window/balcony door and the D1-529 will display the Balc...

Page 32 - Run Menu Parameters rUn

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 32 c. Press F/C button 3 times to exit the service mode. To factory Re-Boot the D-X47 partner: a. Press the UP/DOWN arrow button to change the displayed value to 255. b. Press the POWER button to display V and...

Page 33 - EEr – Read and Display NVRAM of D-

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 33 31-00722-01 Parameter 1 Reset: Reset the D1-529 Parameter 2 WAN Test : Allows you to execute a communication test where a message is sent from the D1-529 through its D-578 edge router to Niagara and back to the room to...

Page 38 - RESETTING AND REBOOTING

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 38 RESETTING AND REBOOTING THE D1-529 AND D-X47 To Reset the D1-529: 1. Press and hold for 4 seconds to enter into service mode. 2. Press the Down arrow button to go to the rUn menu. 3. Press DISPLAY button. P...

Page 40 - TROUBLESHOOTING; during initial installation or while

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 40 c. The D-X47 will get assigned the property key from the D-578 Edge router when it is started after the RESET. This is why you had to first place the D578 into key deployment mode. d. The D-X47 sends a Re-B...

Page 42 - Up or Down; Changes done via RBM do not appear

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 31-00722-01 42 Channel as the D1-529 and the D1-529 and D-X47 are communicating, there should be a dot in the lower right corner of the D1-529. If this Dot is present, the D1-529 and D-X47 are communicating. For further v...

Page 43 - You cannot control the D1-529 or

INNCOM DIRECT D1-529 THERMOSTAT & D-X47 HVAC CONTROLLER INSTALLATION GUIDE 43 31-00722-01 2. The D1-529 is not correctly bound to the D-X47 in the room, or is having trouble communicating the D-X47. Since the D1-529 is battery powered, you can’t interrogate it or send it a command from RBM to se...