Honeywell PM65 User Manual - Free PDF Download

Page 2 - CO N TEN TS

Page 2 of 28 CO N TEN TS Introduction: ......................................................................................................................................................................................... 3 Block diagram ..............................................................

Page 4 - HWBPM11AX-PRTM – System on Module Features; Bluetooth-WLAN coexistence

Page 4 of 28 HWBPM11AX-PRTM – System on Module Features • IEEE 802.11a/b/g/n/ac/ax 2x2 MIMO • Bluetooth 5.1 + HS • Bluetooth-WLAN coexistence • Wi-Fi Wake on Wireless (WoW) • 20MHz /40MHz bandwidth at 2.4GHz • 20/40/80 MHz bandwidth at 5GHz • Internal PA/LNA • RF SOM Size: 15 mm x 15 mm, LGA Package...

Page 5 - B L OCK DI AG RA M

Page 5 of 28 B L OCK DI AG RA M HWBPM11AX-PRTM module is designed based on WM-BAX-BM-57 USI SiP module with Broadcom BCM43752 chipset solution. It supports generic SDIO, UART interface to connect the WLAN/BT to the host processor. A simplified block diagram of the HWBPM11AX-PRTM module is depicted i...

Page 6 - T ECH NI CAL SPECI F I CAT I ONS

Page 6 of 28 T ECH NI CAL SPECI F I CAT I ONS R ECOM MEN D ED OP ER ATIN G CON DITION S ( MOD UL E) Operating Temperature: -20° to 60°C Humidity Max 95% (Non-condensing, relative humidity) Storage Temperature: - 30° to +70°C Power Supply: +5.0V DC, <1.0 A I/O Voltage levels 3.3v for Digital IOs, ...

Page 7 - OP ERATIN G CO N DITIO N S F OR B LUE TOOTH

Page 7 of 28 Active Receive 1 Mbps, 1 RX core 20 2.4 57.4 0.91 mA 1 Mbps, 2 RX cores 20 2.4 67 1.31 mA MCS7, HT20 1 RX core 20 2.4 59.8 0.91 mA MCS7, HT20 2 RX cores 20 2.4 71.7 1.31 mA MCS15, HT20 20 2.4 72.1 1.33 mA MCS7, SGI 1 RX core 20 5 68.1 1.21 mA MCS7, SGI 2 RX core 20 5 86.2 1.3 mA MCS15, ...

Page 9 - MODUL E PI N DE T A IL S & CONF I G URA TI ON S

Page 9 of 28 MODUL E PI N DE T A IL S & CONF I G URA TI ON S S.No PINOUT Signal Type 1 GND Ground 2 GND Ground 3 BT_UART_CTS_3V3 Input/Output 4 1.8V Dig I/O PS Input/Output 5 BT_UART_RTS_3V3 Input/Output 6 BT_HOST_WAKE_3V3 Input/Output 7 BT_UART_TX_3V3 Input/Output 8 EEPROM_SDA Input/Output 9 BT...

Page 10 - W I REL ESS SPECI F I CAT I ONS; WLAN specifications :; BLUETOOTH specifications :

Page 10 of 28 W I REL ESS SPECI F I CAT I ONS WLAN specifications : Features Description WLAN Standards IEEE 802 11a/b/g/n/ac/ax Antenna Port Support 2x2 MIMO streaming Frequency Band 2.400 GHz – 2.484 GHz 4.900 GHz – 5.845 GHz * Number of Sub Channels 1~ 11Channels 36~ 48,52~ 64, 100~ 140, 149~ 165...

Page 11 - W L A N SPECI F I CA T I ON S

Page 11 of 28 W L A N SPECI F I CA T I ON S Wi-Fi Power Table at 2.4GHz Band.

Page 18 - B L UET OOT H SP EC I F I CAT I ONS

Page 18 of 28 B L UET OOT H SP EC I F I CAT I ONS Parameter Conditions Min. Typ. Max Unit Basic Rate (Normal Power Mode) Frequency Range 2402 … 2480 MHz Sensitivity (BER) BER ≦0.1% -91.0 dBm Maximum Input Level BER ≦0.1% -17 dBm EDR (Normal Power Mode) EDR Sensitivity (BER) π/4-DQPSK … -93.0 dBm BER...

Page 19 - A NTE N N A SP ECI F ICAT I ONS

Page 19 of 28 A NTE N N A SP ECI F ICAT I ONS Antenna 1: Flex PCB Antenna , Part no: 1001932PT

Page 24 - A NTE N N A R ECO M MEN DA TI ON S

Page 24 of 28 A NTE N N A R ECO M MEN DA TI ON S This radio transmitter [IC:1693B-PM11AX] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed above, with the maximum permissiblegain indicated. Antenna types not included in this list that ...

Page 25 - L A YOUT G UI DEL I N ES; Do not run any high-speed digital lines below the radio.

Page 25 of 28 L A YOUT G UI DEL I N ES  Do not run antenna cables directly above or directly below the radio module.  Do not run any high-speed digital lines below the radio.  Use proper electro-static-discharge (ESD) procedures when installing the HWBPM11AX-PRTM module.  Use non-conductive labe...

Page 26 - A GENCY A PP R OVA L S

Page 26 of 28 A GENCY A PP R OVA L S FCC ID: HD5-PM11AX Model Name: HWBPM11AX-PRTM This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfe...

Page 27 - Industry Canada

Page 27 of 28 Industry Canada Model: HWBPM11AX-PRTM IC: 1693B-PM11AX This device complies with Industry Canada RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference t...

Page 28 - L A BEL L I NG G UI DEL I NES F OR PR ODU CT

Page 28 of 28 L A BEL L I NG G UI DEL I NES F OR PR ODU CT The proposed FCC IC label format is to be placed on the module. If it is not visible when the module is installed into the system, “Contains FCC ID: HD5-PM11AX, Contains IC:1693B-PM11AX” shall be placed on the outside of final host system. É...