Hilti 2047044 - User Manual

Page 6 - ORIGINAL OPERATING INSTRUCTIONS; General information

ORIGINAL OPERATING INSTRUCTIONS PM 2-L line laser It is essential that the operating instruc-tions are read before the tool is operatedfor the first time. Always keep these operating instructionstogether with the tool. Ensure that the operating instructions arewith the tool when it is given to other...

Page 7 - C A U T I O N

620-690nm/0.95mW max. CLASS II LASER PRODUCT LASER RADIATION - DO NOT STARE INTO BEAM C A U T I O N >1/4s Symbols Read the operating instructions before use. Disposal of power tools or appliances and batteries together with household waste is not permissible. On the tool Do not stare into the bea...

Page 10 - Safety instructions

5. Safety instructions WARNING: Ensure that you read all safety precau-tions and instructions. Failure to observe the safety precautions and instructions may result in electricshock, fire and/or serious injury. Retain all safety precautions and instructions for future reference. 5.1 General safety m...

Page 12 - The tool switches between the operating

7. Operation NOTE To achieve maximum accuracy, project the line ontoa vertical, flat surface. When doing so, set up the toolat 90° to the surface. 7.1 Operation 7.1.1 Switching the laser beams on 1. Unlock the pendulum. 2. Press the on/off button once or repeatedly untilthe desired operating mode is...

Page 13 - Care and maintenance

8. Mark the mid points of d1 and d2.If the reference points 1 and 3 are located ondifferent sides of the mid point, then subtract d2from d1.If the reference points 1 and 3 are located on thesame side of the mid point, then add d1 and d2together. 9. Divide the result by twice the length of the room(r...

Page 14 - The battery is exhausted.

cleaned and dried (at maximum 63°C / 145°F). Repackthe equipment only once it has dried completely andthen store it in a dry place.Check the accuracy of the equipment before it is usedafter a long period of storage or transportation.Remove the batteries from the tool before storing itfor a long peri...

Page 15 - WARNING; For EC countries only; Manufacturer’s warranty

10. Disposal WARNING Improper disposal of the equipment may have serious consequences:The burning of plastic components generates toxic fumes which may present a health hazard.Batteries may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burnsor environmental ...

Page 16 - CAUTION; Re-orient or relocate the receiving antenna.; NOTE; Line laser; Technical documentation filed at:

12. FCC statement (applicable in USA) CAUTION This equipment has been tested and found to complywith the limits for a class B digital device, pursuantto part 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful in-terference in a residential installation. Th...

Page 17 - Hilti Corporation

Hilti Corporation LI-9494 Schaan Tel.: +423 / 234 21 11 Fax: +423 / 234 29 65 www.hilti.com *2049117* 2049117 Hilti = registered trademark of Hilti Corp., Schaan W 4209 | 0612 | 00-Pos. 1 | 1 Printed in China © 2012 Right of technical and programme changes reserved S. E. & O. 2049117 / A2

Hilti 2047044 - User Manual

Table of Contents:

Summary

Other Hilti Laser Levels Models