Gasmate GM160-018 - User Manual

Page 2 - GENERAL INFORMATION; Gas Installation Codes; Never Store your Gas Cylinder Indoors.

2 3 GENERAL INFORMATION Gas Installation Codes • Smokers must be used in accordance with AS/NZS Standard 5601 “Gas Installations”. • Smokers for use with bottled gas are labelled LPG/ULPG.• Smokers for use with natural gas are labelled ‘natural gas’ and must be installed by an authorised person. Che...

Page 4 - GENERAL ASSEMBLY; Connecting & Disconnecting to Gas Source; Nominal Hourly Gas Consumption

4 5 • DO NOT wear loose clothing while operating the smoker. Tie back long hair while operating the smoker. ALWAYS wear fully-covering shoes while operating the smoker. • Allow the smoker and its components to cool completely before conducting any routine cleaning or maintenance. • NEVER use glasswa...

Page 6 - ASSEMBLY INSTRUCTIONS

6 7 ASSEMBLY INSTRUCTIONS Before assembling the smoker, read these Instructions carefully. Assemble the smoker on a flat, clean surface. The smoker is heavy. NOTE: Do not fully tighten all the nuts during the initial stages of assembly. Caution: Sheet metal can cause injury. Wear gloves when assembl...

Page 7 - CC

6 7 ASSEMBLY INSTRUCTIONS Step 3 Remove the air vent handle, then slot through opening in rear of cabinet. Secure using 4 x M6 x 12 screws (AA) and 4 x M6 tailor-made screws (CC) to assemble the air vent (E). Then re-attach the air vent handle. Step 4 Attach the side carry handles (4) to each side o...

Page 8 - screw; screw; 螺钉; screw; 螺钉; screw

8 9 Step 6 Repeat Step 5 to attach the lower door handle (11) to the lower door (12). ASSEMBLY INSTRUCTIONS Step 5 Remove the pre-assembled screws and attach the upper door handle (11) by inserting it through the holes in upper door (8). Secure door handle bracket to the inside of the door. 11 螺钉 8 ...

Page 9 - EE

8 9 ASSEMBLY INSTRUCTIONS Step 7 Attach the door hinges (4) using 8 x M6 x 40 screws (EE) to the side of the cabinet as shown. Step 8 Use 8 x M6 x 40 screws (EE) to assemble the upper door (8) and lower door (12) to the hinges. 4 EE EE 8 12 4 EE EE 8 12

Page 12 - HH

12 13 ASSEMBLY INSTRUCTIONS Step 13 Use 1 x M5 x 20 screw (HH) to secure the match holder (25) to the bottom of the side panel of the smoker as shown. Step 14 Remove the pre-assembled latch screws, then assemble the latches (29) as shown. HH 25 29 HH 25 29 HH 25 29

Page 14 - OPERATING INSTRUCTIONS; Adding Water

14 15 OPERATING INSTRUCTIONS Pre-Use Procedures Before you cook food in your smoker, it is important to “season” your smoker. Seasoning seals the paint and interior of your smoker to enhance flavoring, durability, and overall performance. This is also referred to as the “breakin” process.If your smo...

Page 15 - LIGHTING PROCEDURES; Igniter Lighting System:

14 15 LIGHTING PROCEDURES Igniter Lighting System: 1. Perform leak test at least twice yearly or after connecting LPG cylinder. Check all connections for leaks using the “soapy water” test as explained on page 13. 2. Open the smoker bottom cabinet door. It must always be open when lighting the smoke...

Page 16 - COOKING INSTRUCTIONS; TEMPERATURE CHART

16 17 COOKING INSTRUCTIONS IMPORTANT: Before each use, clean and inspect the hose and the connection to the LPG cylinder. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced before the smoker is used. Refer to the “leak test” instructions in the LPG cylinder connection p...

Page 17 - AFTER USE SAFETY AND MAINTENANCE; STORAGE; Before Storing Your Smoker:

16 17 AFTER USE SAFETY AND MAINTENANCE • If rust is present on the exterior surface of the smoker, clean the area with steel wool or emery cloth and use heavy duty, heat resistant paint. • NEVER apply additional paint to the interior of the smoker. If rust is present on the interior of the smoker, c...

Page 18 - TROUBLESHOOTING

18 19 TROUBLESHOOTING PROBLEM CAUSE CORRECTION Burner will not light 1. Check LPG cylinder fuel level.2. Bad electrode spark.3. Burner may not be properly seated.4. Burner may be obstructed.5. The cylinder valve may be closed.6. Regulator is not properly seated on cylinder valve. 1. Replace LPG Cyli...

Page 19 - SAFE APPLIANCE LOCATIONS

18 19 DIAGRAMMATIC REPRESENTATIONS OF OUTDOOR AREAS The following figures are diagrammatic representations of outdoor areas. Rectangular areas have been used in these figures – the same principles apply to any other shaped area. SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ...

Page 20 - PB