Gasmate BQ1090B - User Manual

7 6 LIGHTING PROCEDURE Burner Operation & Ignition System Check 1. Turn the control knobs clockwise to “OFF” position. 2. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the cylinder. Check with the use of soapy water for any gas leakage between the bottle and the regulator ...

9 8 Problem Possible Reason Solution Food is not cooking or is taking too long Burner has gone out Check that the gas bottle is not empty and re-ignite the burner Cooking surface was not given enough time to warm up before the food was applied Remove the food and give the burner time to warm the coo...

11 10 WARNING Beware of spiders and wasps. Burner tube should be inspected and cleaned periodically.To avoid any flare-ups, it is recommended that the drip tray be checked and emptied regularly. Contents of the drip tray may be very hot during cooking. If emptied during extended cooking extreme caut...

13 12 ASSEMBLY INSTRUCTIONS IMPORTANT: Remove any transit protection material before use. Tools required: 3. Unscrew ignition cap and place a Battery (Size: AA) into place withthe (+) end facing outwards. Screw cap back on. Upon pressing the ignition button, you should hear a clicking sound. 4. For ...

15 14 BUILT-IN BBQ DIMENSIONS 1488 (BQ1090B) 770mm MINIMUM GAS CYLINDER NOT TO BE INSTALLED UNDERNEATH 150mm MINIMUM NOTE: TO BE INSTALLED BY AN AUTHORISED PERSON. PLEASE NOTE: MINIMUM CLEARANCE TO COMBUSTIBLES UNDER FAT TRAY IS 150mm. THE MATERIAL FOR THE CABINET (ISLAND) MUST NOT BE COMBUSTIBLE.

17 16 NATURAL GAS CONVERSION TO BE INSTALLED ONLY ON OR IN A NON-COMBUSTIBLE ENCLOSURE Note: Recommended clearances must be maintained. Tools Required: 7mm Drill, Thin (2.5mm diameter) flat Screw Driver, Adjustable spanner, Phillips head screw driver. GAS PIPING 1. THIS APPLIANCE IS ONLY TO BE INSTA...

17 16 This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the follow...

19 18 ASSEMBLY INSTRUCTIONS Tools Required Standard Phillips-head screw driver.To join your kitchen together use 2 wing screws and nuts as shown. IMPORTANT Remove all packing and transit protection before assembly. CAUTION: Ensure no packing material is left in BBQ before lighting.

23 22 BQ1095 - TOP FOR 2 DOOR BAR FRIDGE Rest the Frame top onto the fridge, with the front fascia overhanging at the front. Push the frame backwards until the front of the frame catches under the front of the fridge. Attach the brackets to the underside of the frame using the screws provided (as sh...

24 24 For any queries or assistance call Customer Service (Australia Only) 1300 174 876 Hours of operation: Monday to Friday 8.30am - 5.30pm EST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty.