Epson XP 4105 - Installation Manual

Start Here

9

Follow the on-screen instructions to adjust the print
quality of your product.

Note:

• You need to load paper before you can adjust the print quality.

See “Load paper” below for details.

• Select

Adjust Later if you want to adjust the print quality later.

For more information, see the online User’s Guide.

4

Load paper

See the online User’s Guide for information about loading
capacity, available paper types and sizes, and loading
envelopes.

1

Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.

2

Slide the edge guides all the way out.

3

Load paper, glossy or printable side up and short edge
first, in the middle of the rear paper feed slot.

4

Slide the edge guides against the paper, but not too
tightly.

5

Pull out the output tray.

6

Follow the instructions on the LCD screen to select your
paper settings.

IMPORTANT: Before using this product, make sure you read
these instructions and the safety instructions in the online
User’s Guide.

Note:

This printer is designed for use with Epson

®

cartridges only, not

third-party cartridges or ink. For important ink information, visit
www.epson.com/epsonink (U.S.) or www.epson.ca/epsonink (Canada)
or see your printer box.

1

Unpack

Note:

Do not open ink cartridge packages until you are ready to install

the ink. Cartridges are vacuum packed to maintain reliability.

1

Remove all protective materials from the product.

2

Lift up the scanner unit until it locks into place and
remove all protective materials from inside the product.

Caution:

Do not touch the flat white cable.

3

Lift the scanner unit up slightly and lower it. When
the scanner unit catches, lift it up again and lower it
completely.

2

Turn on and configure

1

Connect the power cord to the back of the product and to
an electrical outlet.

Caution:

Do not connect to your computer yet.

2

Raise the control panel and turn on the product.

3

Press or to select your language, then press

OK.

Note:

You can change the language later using the product’s

control panel. For more information, see the online User’s Guide.

3

Install ink cartridges

Caution:

Keep ink cartridges out of the reach of children and do not

drink the ink.

Note:

The included initial cartridges are designed for reliable printer

setup and cannot be used as replacement cartridges or resold. After
setup, the remaining ink is available for printing.

1

Lift up the scanner unit until it locks into place.

2

Gently shake the black ink cartridge.

Note:

Do not shake the other ink cartridges.

3

Unpack the ink cartridges.

4

Remove only the yellow tape from each ink cartridge.

Caution:

Do not remove any other labels or seals, or ink will

leak. Do not touch the green chip on the cartridge.

5

Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.

6

Lift the scanner unit up slightly and lower it. When
the scanner unit catches, lift it up again and lower it
completely.

7

Press

OK to start charging the ink delivery system.

8

The printer starts charging the ink. Ink charging takes
approximately 6 minutes. When you see a completion
message on the printer’s LCD screen, charging is
complete.

Caution:

Don’t turn off the printer or raise the scanner unit while

it is charging or you’ll waste ink.

Note:

As part of setup, your product’s serial number will be sent

to a secure Epson server so that you can be eligible to participate
in programs we may offer from time to time, including the Epson
ink replenishment program. You will have a separate opportunity
to consent to participating in such programs.

XP-4100/XP-4105