Page 2 - SYMBOLS
2 electrolux.com.au CONGRATULATIONS Thank you for purchasing an Electrolux cooker. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge tha...
Page 3 - Installation, cleaning and servicing; INFORMATION ON DISPOSAL; GENERAL WARNINGS
3 CAUTION! Read the following carefully to avoid an electric shock or fire. It is important to use your appliance safely. Check these safety points before using your appliance. Installation, cleaning and servicing • An authorised person must install this appliance. (Certificate of Compliance to be r...
Page 4 - IMPORTANT SAFETY INSTRUCTIONS
4 electrolux.com.au WARNING! OVEN • During use the appliance becomes hot. Care should be taken to avoid touching the hot surfaces inside the oven. • Always use gloves when handling hot items inside the oven. • Switch the appliance off before removing the oven light glass for globe replacement. • To ...
Page 8 - BEFORE USING THE APPLIANCE; Preparing the appliance
8 electrolux.com.au BEFORE USING THE APPLIANCE Preparing the appliance 1. Please remove all stickers, leaflets and boxes from the door and from the floor of the oven before operation. 2. Please wipe out the oven interior prior to operation with warm soapy water and polish dry with a soft clean cloth...
Page 9 - Installing the side racks; Then locate the front peg into the front access hole; Positioning the dishes on the grill dish carrier; Drop the front of the shelf/carrier ensuring it sits
9 BEFORE USING THE APPLIANCE Installing the side racks 1. Insert the twin pegged side into the rear access holes provided, ensuring pegs are fully inserted. 2. Then locate the front peg into the front access hole and push in firmly. Fitting the shelves and grill dish carrier between the side rack wi...
Page 10 - BEFORE USING THE APPLIANCE - GAS HOB MODEL; Installing the standard burners
10 electrolux.com.au BEFORE USING THE APPLIANCE - GAS HOB MODEL Installing the standard burners 1. The burner crown must be fitted correctly onto the burner cup or damage will occur during operation. 2. To do this, align the outer hole and outer recess of the burner crown around the spark plug and f...
Page 11 - USING THE OVEN; Turning the oven off; Touch the ‘ON/OFF’ symbol to switch off the oven.; Condensation; symbols to reach the desired setting.
11 USING THE OVEN Turning the oven off Touch the ‘ON/OFF’ symbol to switch off the oven. IMPORTANT! Pre-heating Pre-heating your oven is recommended in several cooking and grilling functions. Pre-heating your appliance allows it to reach the required temperature quickly and efficiently as well as co...
Page 12 - Cooking with the timer
12 electrolux.com.au USING THE OVEN Cooking with the timer Your oven is equipped with a programmable controller that can be used to turn the oven on and off automatically. The ‘cook time’ controls are used to automatically turn the oven off after a set amount of time. The ‘Delay End’ controls are us...
Page 13 - Adjusting the clock
13 USING THE OVEN Adjusting the clock 1. Switch on the oven by touching ‘ON/OFF’ symbol. 2. Select ‘SETTINGS’ from the function list and touch OK. 3. Select ‘SET CLOCK’ from the list and touch OK.4. ‘Set Clock’ will illuminate under the clock display.5. Use the timer and to set the hour portion of t...
Page 15 - OVEN COOKING FUNCTIONS
15 OVEN COOKING FUNCTIONS Symbol Function Description Fan cook Heat comes from the element surrounding the fan. This fan circulates the hot air around the oven cavity so that you can put your food in different places in the oven and still cook them at the same time. You can use the ‘Fan Cooking’ fun...
Page 16 - OVEN COOKING FUNCTIONS CONTINUED
16 electrolux.com.au Left grill The ‘Left Grill’ directs radiant heat from only one of the powerful upper elements onto the food. The ‘Left Grill’ function is used instead of ‘Full Grill’ when only half the amount of grill area is needed. Left Grill has 2 temperature settings, ‘LO’ and ‘HI’.Grill wi...
Page 17 - OVEN BAKING GUIDE
17 OVEN BAKING GUIDE Choosing the best oven settings The following table is intended as a guide and experience may show some variation in cooking times necessary to meet individual requirements. We recommend that you preheat your oven for 30 minutes. Modes without Oven Fan Food Temperature ˚C Oven s...
Page 18 - OVEN COOKING GUIDE
18 electrolux.com.au OVEN COOKING GUIDE Roasting meat 1. Place the meat in the oven and set the temperature between 180°C and 200°C. (It is recommended to wrap your meats in an oven roasting bag or foil to prevent fats and oils from splattering, making it easier to clean your oven.) 2. Use the grill...
Page 19 - DEALING WITH COOKING PROBLEMS
19 Problem Causes Remedies Uneven cooking: Incorrect shelf position. Oven tray too large. Trays not centralised. Air flow in oven uneven. Grill dish affecting thermostat. Select shelf that puts food in the centre of the oven. Experiment with other trays or dishes. Centre trays. Rotate food during co...
Page 20 - OVEN COOKING TIPS; Simple Test Cake; Sift flour and salt into the mixture and beat until
20 electrolux.com.au • For best baking results preheat oven for 30 minutes. • Select the correct shelf location for food being cooked. • One of the grill trays can be used in the oven as a baking dish. • Make sure dishes will fit into the oven before you switch it on. • Keep edges of baking dishes a...
Page 21 - OVEN TROUBLESHOOTING; Problem
21 OVEN TROUBLESHOOTING Problem Possible cause Remedy Oven or grill not working Time of day is not set Set time of day Power is not turned on Switch on electricity Controls are incorrectly set Reset controls Oven is in ‘Demo’ mode Exit Demo mode (page 14) Household fuse has blown or circuit breaker ...
Page 22 - USING THE INDUCTION HOB; Sensor field
22 electrolux.com.au Use the sensor fields to operate the appliance. The displays, indicators and sounds tell which functions operate. USING THE INDUCTION HOB Sensor field Function 1 Activates and deactivates the hob. 2 Locks and unlocks the control panel. 3 Activates and deactivates the STOP + GO f...
Page 25 - The count up timer
25 Power management Power management divides the power between the front and rear zones for each of the 2 outer modules. See illustration below: This allows either the front or rear zone to draw power from the other, if maximum power is required. The timer The count down timer Use the count down tim...
Page 26 - Child safety lock
26 electrolux.com.au Deactivating the beep sound The beeping sound can be deactivated if required. • First deactivate the hob. • Then hold down for 3 seconds. The displays will come on and then go out. Then hold down for 3 seconds. 60 will now be displayed. • Touch and change display to 61. The soun...
Page 28 - INDUCTION HOB TROUBLESHOOTING
28 electrolux.com.au INDUCTION HOB TROUBLESHOOTING Problem Possible cause Remedy You cannot activate the appliance or operate it. Activate the appliance again and set the heat setting in less than 10 seconds. You touched 2 or more sensor fields at the same time. Touch only one sensor field. The Stop...
Page 30 - USING THE GAS HOB; Control knob for high, medium & low heat burners
30 electrolux.com.au USING THE GAS HOB Control knob for high, medium & low heat burners To light a burner with this knob, firstly depress and turn anti-clockwise to the ‘HI’ flame position. The knob may be released once the flame is established and turned further anti-clockwise to reduce the fla...
Page 31 - Flame safeguard; GAS HOB TROUBLESHOOTING
31 Flame safeguard The gas hob is fitted with a safety system that will stop the flow of gas if for any reason the flame goes out during operation. If this happens, the burner can be restarted, but will require the knob to remain depressed for approximately 5 seconds. WARNING! • Keep hands clear of ...
Page 32 - CLEANING YOUR APPLIANCE - PYROLYTIC OVENS
32 electrolux.com.au EVEP916SB,EFEP955SB & EFEP915SB Cleaning Reminder After a recommended period of time the oven will remind you to clean the oven. Once this period of time has elapsed, when turning the oven off you will get a message “TIME TO CLEAN YOUR OVEN”. Press the on/off button to clear...
Page 33 - CLEANING YOUR APPLIANCE; After cool-down wipe the ash out of the oven with a soft
33 Select the pyrolytic clean function. Use cooking function selector to pick the ‘pyro clean’ function. Selecting the required cleaning cycle Use the ‘cook time’ control to select Light, Medium or Heavy depending on the soiling of the oven. Start Pyrolytic Unlike other cooking functions, you MUST t...
Page 34 - CLEANING OVEN ACCESSORIES
34 electrolux.com.au WARNING! • Always make sure that the appliance is electrically isolated before cleaning. This can be done by the functional switch nearby. • Do not line the bottom of the oven with foil or cookware. • Do not use steam cleaners. Stainless steel parts WARNING! The oven door trim, ...
Page 35 - CLEANING THE OVEN DOOR; Releasing the grill element; Wash the shelves and grill dish in hot soapy water.; Removing the shelf supports; Grasp the shelf support at the front.
35 CLEANING THE OVEN DOOR Releasing the grill element To release the grill element so that the oven roof can be accessed for cleaning.• Push element upwards and rotate the 3 clips backwards and away from the element rod. This will allow the front of the element to drop down. WARNING The door glass o...
Page 36 - Positioning the door for dismantling; NOTE: The door cannot fully close with the locking tab in; Removing the top door trim; INSTALLATION OF THE EFEP955SB & EFEP915SB; Reassembling the glass panes & and top door trim
36 electrolux.com.au Positioning the door for dismantling The door needs to be positioned at an angle to aid in the disassembly of the panes.• Open the door fully to gain access to the hinges. • Push down the hinge locking tab on both hinges. Locking tab up - normal position Locking tab down - for c...
Page 37 - The cooker MUST be checked every five years.; Gas model clearance requirements
37 Installing splashback (Models with hob only) Fit splashback to rear of hob with three screws provided. Cabinet requirements Models EFEP955SB & EFEP915SB are designed to fit into a 900mm wide gap between standard kitchen cabinets. The appliance integrates with the kitchen cabinets by matching ...
Page 39 - Cabinet construction for slot in installation
39 INSTALLATION OF THE EFEP955SB & EFEP915SB Cabinet construction for slot in installation To convert the freestanding appliance to a slot in installation the kick panel provided on the appliance is removed and the appliance is mounted on a plinth. This enables a continuous cupboard kickboard to...
Page 40 - Slot in Installation; Ensure cabinetry has the correct details.
40 electrolux.com.au INSTALLATION OF THE EFEP955SB & EFEP915SB Slot in Installation To remove the appliance kick panel • Remove all loose parts i.e. burner crowns & caps, trivets, and oven shelves. • Carefully lay down the appliance onto one side onto foam packaging and remove the screws as ...
Page 41 - with the; proud fit; INSTALLATION OF EVEP916SB
41 Cabinet construction for built-in installation For the best integration within a kitchen, install this appliance in a cupboard that gives a flush fit with the surrounding cupboard fronts. A recess of 20mm is ideal.The appliance may also be mounted in a proud fit configuration. This will push out ...
Page 42 - NOTE: Your appliance must be mounted on a horizontal; CABINET CONSTRUCTION FOR BUILT IN OVEN
42 electrolux.com.au Oven dimensions 895mm 596mm 586mm 552mm 572mm 20mm 900mm 580mm minimum Infill panel 20mm (see NOTE) cupboard door 100mm max. For the best integration within a kitchen, install this appliance in a cupboard that gives a flush fit with the surrounding cupboard fronts. A recess of 2...
Page 43 - WIRING REQUIREMENTS; NOTE: When connections are made to a multi-phase
43 WIRING REQUIREMENTS The cooker MUST be installed in compliance with:• Wiring connections in AS/NZS 3000 Wiring Rules. • Local regulations, municipal building codes and other statutory regulations. For New Zealand Only: The cooking range must be connected to the supply by a supply cord fitted with...
Page 44 - ELECTRICAL & GAS CONNECTION LOCATIONS
44 electrolux.com.au ELECTRICAL & GAS CONNECTION LOCATIONS Models EFEP915SB 168 95 Electrical connection cable 806 411 Gas connection point to regulator Models: EFEP915SB Electrical cable entry point Models: EFEP915SB, EFEP956SB Installing the gas cooker Gas pressures The following table shows t...
Page 45 - LPG CONVERSION MODEL EFEP915SB
45 • Check that the insert has been fitted correctly. • Check that the turret screw is fully screwed down. • Check that the regulator has been fitted to the gas supply line in the correct orientation, the arrow on the base of the body indicates the direction of gas flow. Flame size adjusted to maxim...
Page 46 - TESTING THE OPERATION OF THE GAS COOKER; Checking gas supply
46 electrolux.com.au TESTING THE OPERATION OF THE GAS COOKER Checking gas supply 1. Check the manometer zero point is correct. 2. Connect the manometer to the cooker pressure test point. This is located on the regulator. 3. Turn on the gas supply and the electricity and try to ignite the gas. NOTE: ...
Page 47 - Warranty
47 This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1. In this warranty: (a) ‘acce...
