DeLonghi PAC WE 110 - Manual

5 • If you have a sash window, place the win- dow bracket (T) on the window sill, extend the window bracket fully within the window frame, fix the window bracket by using the locking pin then lower the window onto the window bracket. Insert the window outlet (N) of the exhaust hose (K) into the slot...

6 Keep the air hose as short and free of cur- ves as possible to avoid bottlenecks. Air-conditioning with installation If required, your appliance can be installed semi-permanently (Fig. 7).Proceed as follows:• Drill a 5.27 inch (134 mm) dia. hole in an outside wall or through a window pane, re-spec...

7 PREPARING fOR OPERATION IN WA-TER MODE Once the appliance has been installed, it is ready for use. However, its efficiency can be enhanced by ope-rating it in De’Longhi’s patented water mode. The water in the tank increases the cooling po-wer of your Pinguino and at the same time redu-ces noise le...

8 Replace the cap correctly and close the tank, pu- shing it in as far as it will go. The tank hole has a mesh filter to prevent the introduction of foreign matter. If necessary, this filter can be unscrewed and removed for cleaning under running water. • The tank does not have to be full to use the...

9 DESCRIPTION Of THE CONTROL PA-NEL WITH ADVANCED LCD DISPLAY 1 Air conditioning symbol2 Dehumidifying symbol3 fan symbol4 SMART symbol5 BOOST symbol6 SLEEP symbol7 Alarm symbol8 Temperature indicator9 “No water” symbol10 Timer symbol11 fan speed indicator12 AUTOfAN indicator13 fAN button14 Increase...

12 USING THE REMOTE CONTROL • Point the remote control at the receiver on the appliance. The remote control must be no more than 23 ft (7 meters) away from the appliance (without obstacles between the re-mote control and the receiver). • The remote control must be handled with extreme care. Do not d...

13 BOOST function (fig. 27) Ideal for the summer to cool rooms rapidly. Activate by simply pressing the button. The appliance operates in air conditioning mode at maximum fan speed and maximum power. While this function is selected, it is not possible to set the temperature or change fan speed. When...

14 If you need to disable the timer program (on or off) in advance, press the or button respectively twice. PROGRAMMING THE TIMER The timer can be programmed to start and stop the appliance when required. Programming start up • Press the button. The start-up time and symbol flashes on the remote con...

15 SELf-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display. If ... IS DISPLAYED, ...WHAT SHOULD I DO? Low Temperature (frost prevention) The appliance is fitted with a frost protection device to avoid excess...

17 Certain models have a silver ion dust filter and an additional electrostatic filter in the grill at the back Silver ion filter This dust filter is treated with silver ions which not just retain dust particles, but also have an efficient antibacterial action. It also greatly redu- ces concentratio...

18 Cleaning of the silver ion filter and of the electrostatic filter (certain models only) To clean the silver ion dust filter, the electrostatic filter must be temporarily removed. To clean the filters, use a vacuum cleaner at me- dium power. The silver ion filter can be washed with lukewarm water....

19 TECHNICAL CHARACTERISTICS: Power supply voltage Maximum absorbed power in air conditioning Refrigerant Cooling capacity see rating plate “ “ “ Limit conditions Room temperature for air conditioning 70÷95 °F (21÷35°C) GUARANTEE The terms of the guarantee and technical assi- stance are given in the...

20 PROBLEM CAUSE SOLUTION The air conditioner does not come on • there is no current • it is not plugged into the outlet • the internal safety device has tripped • wait • plug into the outlet • call the Service Center The air conditioner works for a short time only • there are bends or kinks in the ...