DeLonghi Fully Automatic Coffee Center Machine ESAM6700- User Manual

10 coffee. C5. oK icon: to enable and confirm the selected function. C6. icon: to rinse or deliver hot water. C7. hot mILK icon: to deliver a cup of steamed milk. C8. ItALIAn mACChIAto icon: to deliver a shot of espresso with a small amount of foam on top. C9. LonG icon: to deliver one cup of C10. C...

11 Setting up the appliance Information : • Coffee has been used to factory test the appliance and it is therefore completely normal for there to be traces of coffee in the mill. The machine is, however, guaranteed to be new. • You should customize water hardness as soon as possible following the in...

12 ChAnGInG thE mEnu SEttInGS Setting the language To modify the language on the display, proceed as follows: 1. Press the p icon to enter the programming menu; 2. Press the or icon until “Set language” is displayed; 3. Press the oK icon; 4. Press the or icon until the required language is displayed...

13 number of hours of operation (30 minutes, 1 or 2 hours) is displayed; 5. Press the oK icon to confirm (or the ESC icon to cancel the operation); 6. Press the ESC icon to exit the menu. resetting default values (reset) This resets all menu settings and programmed quantities back to the default val...

15 the cup used. Put the cup for long coffee under the spouts (fig. 18); 3. Choose the strength by hitting the and size by hitting the . 4. Press the LonG icon (fig. 10). Preparation begins. A progress bar appears on the display and gradually advances as the procedure progresses. Information: • Whil...

17 6. As soon as the coffee in the cup reaches the required level, press the icon. Coffee delivery stops. The machine is now reprogrammed with the new quantities. hot WAtEr preparation Important! Danger of burns. Never leave the machine unsupervised while delivering hot water. The hot water spout be...

18 Cleaning the drip tray Important! If the drip tray is not emptied regularly, the water could overflow from the edge and seep inside or around the machine. This could damage the machine, the surface it rests on or the surrounding area. The drip tray is fitted with a level indicator (red) showing t...

19 Information! If the brew group is difficult to insert, you must first adapt it to the right dimension by pressing it forcefully from the bottom and top as shown in the figure. 7. Once inserted, make sure the two red buttons have snapped out. 8. Replace the drip tray and grounds container. 9. Clos...

20 Setting water hardness 1. Press the p icon to enter the programming menu. 2. Press the or icon and select “Water hardness”. 3. Confirm the selection by pressing the oK icon. 4. Press the or icon to set the number of squares formed on the reactive strip (see figure in the previous section). 5. Pre...

21 DISpLAyED mESSAGES DISpLAyED mESSAGE poSSIBLE CAuSE rEmEDy FILL TANK! • The water tank is empty or positioned incorrectly. • Fill the tank with water and/or insert it correctly, pushing it as far as it will go. GROUND TOO FINE ADJUST MILL! Insert water spout and press OK • The grinding is too fin...

22 DISpLAyED mESSAGE poSSIBLE CAuSE rEmEDy GENERAL ALARM! • The inside of the appliance is very dirty. • Clean the inside of the appliance thoroughly as described in the section “Cleaning the inside of the machine”. If the message is still displayed after cleaning, contact customer services. PRESS C...

23 proBLEm poSSIBLE CAuSE rEmEDy The milk contains bubbles or squirts out of the milk spout • The milk is not cold enough or is not semi-skimmed. • You should ideally use skimmed or semi- skimmed milk at refrigerator temperature (about 41°F). If the result is still disappointing, try another brand o...

24 This warranty applies to Super Automatic Espresso Machines with the De’Longhi brand name. LImItED WArrAnty What does the warranty cover? We warrant each appliance to be free from defects in material and workmanship. Our obligation under this warranty is limited to repair at our factory or authori...