DeLonghi DL 48 P6E - Manual

Page 2 - IF THE INFORMATION IN THIS MANUAL IS NOT; WARNING; • ALL RANGES CAN TIP

2 ✓ Do not store or use gasoline or other flammable vapors and liquidsin the vicinity of this or any other appliance. ✓ WHAT TO DO IF YOU SMELL GAS:• Do not try to light any appliance.• Do not touch any electrical switch; do not use any phone in your building. • lmmediately call your gas supplier fr...

Page 4 - U S E R I N S T R U C T I O N S; GENERAL INFORMATION; Electrical Requirement; ELECTRICAL GROUNDING INSTRUCTIONS

4 U S E R I N S T R U C T I O N S GENERAL INFORMATION WARNING!! 1. This appliance shall not be used for space heating. This information is based on safety considerations. 2. AlI openings in the wall behind the appliance and in the floor under the appliance shall be sealed. 3. K e e p a p p l i a n c...

Page 5 - IMPORTANT PRECAUTIONS AND RECOMMENDATIONS; OFF

5 IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FORUSE OF ELECTRICAL APPLIANCES Use of any electrical appliance implies the necessity to follow a series of fundamental rules.In particular: ✓ Never touch the appliance with wet hands or feet; ✓ Do not operate the appliance barefooted; ✓ Do not allow child...

Page 6 - f e a t u r e s; COOKING HOB; WARNING - VERY IMPORTANT NOTICE

6 CAUTION: If the burner is accidentally extinguished, turn the gas offat the control knob and wait at least 1 minute beforeattempting to relight. CAUTION:Gas appliances produce heat and humidity in the environ-ment in which they are installed.Ensure that the cooking area is well ventilated followin...

Page 8 - N.B. When the range is not being used, set the gas knobs to their; h o w t o u s e t h e t o p b u r n e r s; Knob

8 Fig. 2.2 Fig. 2.1 GAS BURNERS (Rapid and triple ring) Gas flow to the burners is adjusted by turning the knobs (illustrated in fig. 2.1) whichcontrol the valves.Turning the knob so that the symbols printed on itself point to the symbol printed onthe control panel achieves the following functions: ...

Page 9 - minute and then repeat the lighting procedure.

9 Caution! The range becomes very hot during operation.Keep children well out of reach. LIGHTING GAS BURNERS FITTED WITH FLAME FAILURESAFETY DEVICE (Rapid and triple ring) In order to light the burner, you must: 1 – Push and turn the knob in an anti-clockwise direction up to the position (maximum ra...

Page 12 - CORRECT USE OF DUAL BURNERS; WRONG; CORRECT; CHOICE OF BURNER; DIAMETERS OF PANS WHICH MAY BE USED ON THE HOB BURNERS

12 CORRECT USE OF DUAL BURNERS (Fig. 2.6a - 2.6b) The flat-bottomed pans are to be placed directly onto the pan-support. When using a WOK you need to place the supplied stand in the burner to avoid anyfaulty operation of the dual burner (Figs. 2.6a - 2.6b). IMPORTANT:The special grille for wok pans ...

Page 13 - h o w t o u s e t h e w a r m e r d r a w e r; USING THE WARMING DRAWER FOR THE FIRST TIME

13 h o w t o u s e t h e w a r m e r d r a w e r USING THE WARMING DRAWER FOR THE FIRST TIME • Switch on the warming drawer empty at maximum power (HI) for about 2 hours to remove traces of grease and smells from the components. • When the warming drawer has cooled down and unplugging the range, cle...

Page 14 - WARNING LIGHT; LO

14 REVERSIBLE RACK The rack shall be positioned as per fig-ures 3.3 and 3.4. MOISTURE SELECTOR (fig. 3.2) MOIST position: Vents closedDRY position: Vents opened To keep foods moist, slide the moistureselector to the left. This closes the ventsand the moisture remains inside thedrawer.In this setting...

Page 15 - USING THE OVENS FOR THE FIRST TIME; OPERATING PRINCIPLES; GENERAL FEATURES; h o w t o u s e t h e s e l f c l e a n i n g o v e n s; NOTES ON OVEN WORKING

15 USING THE OVENS FOR THE FIRST TIME - Put in the shelf and the tray. - Switch the oven on empty (on a cooking function – NOT SELF CLEANING) at maximum power for about 2 hours to remove traces of grease and smells from the components. - When the oven has cooled down and unplugging the range, clean ...

Page 16 - OVEN LIGHT (this is not a cooking function); SELECTING THE FUNCTIONS; If the door stays open “; ” appears on the programmer dis-; door; To silence the audible warning press any programmer pushbutton.; DEFROSTING FROZEN FOODS (this is not a cooking function); dEF; CONVECTION COOKING WITH

16 OVEN LIGHT (this is not a cooking function) On turning the knob to this position only the oven lamp lights up.The lamp is always on in all the cooking functions (not for the self cleaning). SELECTING THE FUNCTIONS (fig. 4.1) The cooking function is selected by turning the function selector knob a...

Page 18 - SELF CLEANING FUNCTION; • do not operates immediately the

18 IMPORTANT NOTES:This is not a cooking function but is only used toclean the oven. Before starting the self cleaning cycle: - Take all the accessories out of the oven (drip tray and shelves). - Clean any traces of liquid which have overflowed.- Close the oven door and make sure that it is closed p...

Page 19 - SETTING THE COOKING

19 The temperature set is shown on the electronic programmer display and can be varied,with 5 °F (5 °C) intervals, by means of the programmer keys.During the cooking the oven temperature (°F or °C) is measured by a sensor inside thecavity and is shown on the programmer display until setted temperatu...

Page 20 - HOW TO START THE SELF CLEANING CYCLE; Turn the oven selector knob to the self cleaning position (CLEAN); AUTO

20 HOW TO START THE SELF CLEANING CYCLE Important: the self cleaning cycle must only be performed with the oven empty;so, before starting the cycle take all the accessories (shelves, drip tray, ...) out ofthe oven cavity and dry any traces of overflowed liquid.Do not use any degreasing products (e.g...

Page 21 - PROBLEMS ON STARTING AND DURING THE SELF CLEANING CYCLE; Steady; with AUTO flashing; flashes and an audible sig-

21 PROBLEMS ON STARTING AND DURING THE SELF CLEANING CYCLE 1. Steady door The function selector has been turned to the self cleaning position with the oven dooropen or not perfectly closed. Or the door has been opened before the cycle has beenstarted with confirmation from key 3 What to do:Close the...

Page 22 - HOW TO STOP THE SELF CLEANING CYCLE; Turn the function selector to; ACCIDENTAL INTERRUPTION OF THE SELF CLEANING CYCLE; The function selector has been turned to any cooking function; WHAT TO DO WHEN THE SELF CLEANING CYCLE HAS FINISHED; Wait for the oven to cool down completely.

22 HOW TO STOP THE SELF CLEANING CYCLE 1. Turn the function selector to OFF (oven OFF) - If the oven cavity temperature is higher than 570 °F (300 °C) 1a. The time of day appears steadily on the programmer display. 1b. When the oven cavity temperature drops below 570 °F (300 °C): - OFF appears on th...

Page 23 - ABNORMAL SITUATIONS AND/OR OPERATION PROBLEMS; or; Caution: If the function selector is not turned to; appears during the self cleaning cycle

23 I I I I II I II I I ABNORMAL SITUATIONS AND/OR OPERATION PROBLEMS during cooking or the self cleaning cycle. 1. 30 F0 or 30 F1 appear during the cooking or self cleaning cycle Oven temperature sensor broken or not working properly. The cooling fan stays onand if the self cleaning cycle is in prog...

Page 24 - a. Turn the switch to position; KEEP ATTENTION

24 COOKING DIFFERENT DISHES AT THE SAME TIME The MULTIFUNCTION oven at positions of the function selector can cook various different foods at the same time. Fish, cakes and meat can be cooked togetherwithout the smells and flavours mixing. The only precautions required are the following: – The cooki...

Page 25 - BROILING; Do not broil without using the broiling pan; STEP

25 BROILING Very important: the broil element must always be used with the oven door closed. – Position the shelf on the first or second level from the top (fig. 4.2). – Turn on the broil element, as explained in the preceding paragraphs and let the oven preheat for about 5 minutes with the door clo...

Page 26 - ON SWITCHING ON FOR THE FIRST TIME OR AFTER A BLACK-OUT; Note: Setting the clock will zero any programmes in progress or set.; SETTING THE TIME; AUDIBLE SIGNAL; h o w t o u s e t h e e l e c t r o n i c p r o g r a m m e r

26 The electronic programmer is a device which groups together the following functions:– 12 hours clock with illuminated display (P on the display for PM time indication). – Timer (up to 23 hours and 59 minutes). – Program for semi-automatic oven cooking. – Program for automatic oven cooking. – Mana...

Page 27 - TIMER; End; SEMI-AUTOMATIC COOKING

27 The timer function is only used to count the time and does not influence oven operationor any programmes which are in progress or set. 1. Press pushbutton 1. The bell symbol will start to flash. 2. Press keys 5 or 6 to set the time required. 3. The countdown starts immediately. The bell symbol st...

Page 28 - AUTOMATIC COOKING

28 Setting 1. Set the cooking function by turning the oven selector to the function required. 2. The cooking temperature appears on the display. To change it proceed as describedin the Setting the cooking chapter. 3. Press pushbutton 2. AUTO starts to flash and 0.00 appears. 4. Press pushbuttons 5 o...

Page 29 - EXAMPLES OF PROGRAMMING AUTOMATIC COOKING; Note: if during a set programme the function selector is turned to; SELF CLEANING or oven lighting, the programme is cancelled.; CANCELLING A SET PROGRAMME

29 P A U T O 2 3 4 5 6 7 8 9 10 11 1 12 P A U T O P A U T O 2 5 6 5 3 6 Time needed to cookthe food (2 hours) Time when the food to becooked must be ready Time when cookingthe food is pro-grammed (08:00) Programmable functions Fig. 5.2 EXAMPLES OF PROGRAMMING AUTOMATIC COOKING ➂ ➁ ➀ ➀ ➁ ➂ To cancel ...

Page 30 - c l e a n i n g a n d m a i n t e n a n c e; GENERAL RECOMANDATION; ENAMELLED PARTS; STAINLESS STEEL ELEMENTS; BURNERS AND GRIDS

30 Do not use steam jet cleanersbecause the humidity couldinfiltrate into the appliance makingit dangerous. c l e a n i n g a n d m a i n t e n a n c e GENERAL RECOMANDATION ✓ Important: Before any operation of cleaning and maintenance disconnect theappliance from the electrical supply. ✓ It is advi...

Page 32 - OVEN SHELF INSTALLATION AND REMOVAL; CORRECT POSITION OF DUAL BURNERS

32 Safety catch Fig. 6.10 OVEN SHELF INSTALLATION AND REMOVAL The oven shelves are provided with a security block to prevent accidental extraction.They must be inserted operating as per figure 6.10. To pull them out remove shelf in the inverse order. Keep attention to insert the shelves correctly (s...

Page 33 - • Be sure drawer is empty before

33 REMOVING THE WARMER DRAWER (fig. 6.11) 1. Open the drawer completely (fig. 6.11) 2. Move down the lever of left guide (fig. 6.12) and up the lever of right guide (fig. 6.13). 3. Remove the drawer; the levers have to be keep moved (fig. 6.11). Fig. 6.11 Fig. 6.13 Fig. 6.12 2 2 3 FITTING THE WARMER...

Page 34 - REPLACING THE OVEN LIGHT; NOTE: Oven bulb replacement is not covered by your guarantee; REMOVING THE OVEN DOOR

34 A B Fig. 6.15 REPLACING THE OVEN LIGHT (fig. 6.15) Before any maintenance is started involving electrical parts of the appliance, it must bedisconnected from the power supply. – Let the oven cavity and the heating elements cool down; – Switch off the electrical supply; – Remove the protective cov...

DeLonghi DL 48 P6E - Manual

Table of Contents:

Summary

Other DeLonghi Models