Cisco SFS 3001 - Manual

vii CAUTION: Never place your hand inside an empty card or module bay. You should never have cause to place a hand anywhere inside the Topspin chassis. Unused card and module bays should always have a Topspin cover over the bay to ensure proper safety, ventilation, and cooling. General Cautions CAUT...

viii Laser Specs Contact Information Table III-1: Topspin P/N Application Optical Parameters 48-00001-01 Fibre Channel *CDRH/IEC Laser Class: 1/1 Maximum Data Rate: 2.125 GB/s Wavelength: 850nm I/O connector: * Standards used: CDRH - 21CFR Chapter I §1040.10; IEC - IEC60825-1:1994 Table III-2: Custo...

1 1 Topspin 90 Quick Start This document describes the basic steps required to install and configure the Topspin 90 system. For more detailed information about the Topspin 90 server switch, we recommend that you have the Topspin 90 Hardware Guide available. • “Prepare the Site” on page 1 • “Install ...

2 5. Prepare the physical environment for the Topspin 90. a. Make sure that you have an approved grounding wrist-strap. b. Make sure the system has the right cables and sufficient ventilation.c. Unpack the Topspin 90 package, using the packing list provided. d. Verify that you have all of the items ...

5 If the brackets do not slide easily, the alignment may be off. Pull the switch back toward you and realign the brackets. Figure 1-5: Sliding the Switch Into the Rack 8. Secure the switch with your screws through the front of the rack, as show in Figure 1-6 . Figure 1-6: Secure Switch with Screws t...

6 Connect InfiniBand Cables 1. Plug InfiniBand Cables from the InfiniBand-enabled host to the InfiniBand switch ports. This can also be done in a later step. Refer to step 5 . 2. Plug InfiniBand cables from the Topspin 90 to any additional InfiniBand switches that you want to connect. (Optional) Con...

8 f. Enter the option dhcp command. The chosen method will be persistent across module reboots. g. Enable the management port by entering the no shutdown command. h. Save the configuration to preserve it between reboots. i. Use the show interface mgmt-ethernet command to view your IP address:. Conne...

11 • 300 Mhz processor • 800x600 screen resolution, 16bit color depth 2. Insert the Topspin CD-ROM into the CD-ROM drive of a server that has network access to a Topspin management port. 3. Access the top folder of the CD-ROM. The GUI can be found in the following location on the CD-ROM.• Linux/inst...

12 4. Chassis Manager loads in your browser window. Figure 1-10: Chassis Manager Opening Display for the Topspin 90 Server Switch Configure Additional Settings You can now fully manage the device with CLI over Telnet/SSH or the GUI.1. Verify that you are running the latest version of software. a. Re...

13 • In the CLI, enter the configuration mode and enter the ntp command with the IP address of the NTP server. Example 3. Configure administrators and privilege levels. See Creating User Accounts in the User Guide . (Optional) Configure the Ethernet Gateway Configure the Ethernet Gateway if you have...

15 Configure the Fibre Channel Gateway (Optional) To configure ITLs, perform the following steps:1. Log in to your host.2. Enter the /etc/init.d/ts_srp stop command at the host CLI to force the host to log out of any storage. You must disable connections now and enable them later in this process. 3....

Index B basic connectivity ...................................................6 C chassis manager launching .........................................................11 configure basic connectivity ...................................6 connectivity, basic .................................................