Cisco DC-157 - Manual
Cisco DC-157 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The diagrams show two processes:; EXEC and Daemon Creation on a Line with No Modem Control
- Page 3 – Configuring Automatic Dialing; Configures a line to initiate automatic dialing.; Command; Configures a line to automatically answer a modem.
- Page 4 – EXEC Creation on a Line Configured for a High-Speed Modem; Supporting Dial-In and Dial-Out Connections; Automatically Answering a Modem; Configures a line for both incoming and outgoing calls.
- Page 5 – EXEC and Daemon Creation for Incoming and Outgoing Calls; Configuring a Line Timeout Interval; Note; Configures modem line timing.
- Page 6 – Closing Modem Connections; EXEC and Daemon Creation on a Line Configured for Continuous CTS; Configures a line to close connections.
- Page 7 – Configuring a Line to Disconnect Automatically; Configures automatic line disconnect.
- Page 8 – Daemon Creation on a Line Configured for Modem Dial-Out
DC-157
Cisco IOS Dial Technologies Configuration Guide
Modem Signal and Line States
This chapter describes modem states in the following section:
•
Signal and Line State Diagrams
To identify the hardware platform or software image information associated with a feature, use the
Feature Navigator on Cisco.com to search for information about the feature or refer to the software
release notes for a specific release. For more information, see the “Identifying Supported Platforms”
section in the “Using Cisco IOS Software” chapter.
For a complete description of the modem support commands in this chapter, refer to the Cisco IOS
Modem Command Reference. To locate documentation of other commands that appear in this chapter,
use the command reference master index or search online.
Signal and Line State Diagrams
The following signal and line state diagrams accompany some of the tasks in the following sections to
illustrate how the modem control works:
•
•
Automatically Answering a Modem
•
Supporting Dial-In and Dial-Out Connections
•
Configuring a Line Timeout Interval
•
•
Configuring a Line to Disconnect Automatically
•
Supporting Reverse Modem Connections and Preventing Incoming Calls
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Modem Signal and Line States Signal and Line State Diagrams DC-158 Cisco IOS Dial Technologies Configuration Guide The diagrams show two processes: • The “create daemon” process creates a tty daemon that handles the incoming network connection. • The “create EXEC” process creates the process that in...
Modem Signal and Line States Signal and Line State Diagrams DC-159 Cisco IOS Dial Technologies Configuration Guide Configuring Automatic Dialing With the dialup capability, you can set a modem to dial the phone number of a remote router automatically. This feature offers cost savings because phone l...
Modem Signal and Line States Signal and Line State Diagrams DC-160 Cisco IOS Dial Technologies Configuration Guide Figure 26 EXEC Creation on a Line Configured for a High-Speed Modem Supporting Dial-In and Dial-Out Connections To configure a line for both incoming and outgoing calls, use the followi...
