Cisco DC-157 - Manuals - manualsarea.com

Page 2 - The diagrams show two processes:; EXEC and Daemon Creation on a Line with No Modem Control

Modem Signal and Line States Signal and Line State Diagrams DC-158 Cisco IOS Dial Technologies Configuration Guide The diagrams show two processes: • The “create daemon” process creates a tty daemon that handles the incoming network connection. • The “create EXEC” process creates the process that in...

Page 3 - Configuring Automatic Dialing; Configures a line to initiate automatic dialing.; Command; Configures a line to automatically answer a modem.

Modem Signal and Line States Signal and Line State Diagrams DC-159 Cisco IOS Dial Technologies Configuration Guide Configuring Automatic Dialing With the dialup capability, you can set a modem to dial the phone number of a remote router automatically. This feature offers cost savings because phone l...

Page 4 - EXEC Creation on a Line Configured for a High-Speed Modem; Supporting Dial-In and Dial-Out Connections; Automatically Answering a Modem; Configures a line for both incoming and outgoing calls.

Modem Signal and Line States Signal and Line State Diagrams DC-160 Cisco IOS Dial Technologies Configuration Guide Figure 26 EXEC Creation on a Line Configured for a High-Speed Modem Supporting Dial-In and Dial-Out Connections To configure a line for both incoming and outgoing calls, use the followi...

Page 5 - EXEC and Daemon Creation for Incoming and Outgoing Calls; Configuring a Line Timeout Interval; Note; Configures modem line timing.

Modem Signal and Line States Signal and Line State Diagrams DC-161 Cisco IOS Dial Technologies Configuration Guide Figure 27 EXEC and Daemon Creation for Incoming and Outgoing Calls Note If your system incorporates dial-out modems, consider using access lists to prevent unauthorized use. Configuring...

Page 6 - Closing Modem Connections; EXEC and Daemon Creation on a Line Configured for Continuous CTS; Configures a line to close connections.

Modem Signal and Line States Signal and Line State Diagrams DC-162 Cisco IOS Dial Technologies Configuration Guide Closing Modem Connections Note The modem cts-required command was replaced by the modem printer command in Cisco IOS Release 12.2. To configure a line to close connections from a user’s...

Page 7 - Configuring a Line to Disconnect Automatically; Configures automatic line disconnect.

Modem Signal and Line States Signal and Line State Diagrams DC-163 Cisco IOS Dial Technologies Configuration Guide Configuring a Line to Disconnect Automatically To configure automatic line disconnect, use the following command in line configuration mode: The autohangup command causes the EXEC facil...

Page 8 - Daemon Creation on a Line Configured for Modem Dial-Out

Modem Signal and Line States Signal and Line State Diagrams DC-164 Cisco IOS Dial Technologies Configuration Guide Figure 29 Daemon Creation on a Line Configured for Modem Dial-Out Lower DTR Ringing Idle state Ready and active Incoming network connection CTS raised Create daemon Raise DTR DTR high, ...