Cisco 4840G - Manual
Cisco 4840G – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Using the Console Port or a Management Port; Connecting a Modem; Using Passwords
- Page 3 – Configuring the Management Port; Command
- Page 4 – Displaying the Operating Configuration; Enabling Fast Ethernet Client
- Page 5 – Configuring a Host Name
- Page 6 – Formatting a Flash PC Card; format; Copying the Startup Configuration File to the Flash PC Card
- Page 7 – Viewing the Contents of Flash Memory; Determining the Current File System Device; Moving Between Flash Memory Media; Listing the Flash Memory Directory Contents; Deleting Files from Flash Memory
- Page 8 – Booting from a Flash PC Card
- Page 9 – Backing Up a System Image to a TFTP Server
- Page 10 – Copying a System Image from a TFTP Server to a Flash PC Card
C H A P T E R
3-1
Catalyst 4840G Software Feature and Configuration Guide
78-10416-02
3
Configuring the Catalyst 4840G Processor
This chapter describes how to configure the Catalyst 4840G processor so it can be accessed by other
devices. For further information about the commands used in this chapter, see Appendix A, “Command
Reference.”
This chapter includes the following sections:
•
Before Starting Up the Catalyst 4840G, page 3-1
•
Configuring the Management Port, page 3-3
•
Displaying the Operating Configuration, page 3-4
•
Enabling Fast Ethernet Client, page 3-4
•
Configuring a Host Name, page 3-5
•
Using Flash PC Cards, page 3-5
Note
You are at Step 2 in the suggested procedure for configuring your Catalyst 4840G switch.
See the “Switch Configuration Steps” section on page 2-1.
Before Starting Up the Catalyst 4840G
Before starting up the Catalyst 4840G switch, you should verify the following:
•
The cables are connected to the switch.
•
A console terminal is connected to the switch.
For instructions, refer to the Catalyst 4840G Chassis Installation Guide
.
When you start up the switch, the CLI prompts you whether to enter the initial configuration dialog.
Answer
no
to this prompt:
Would you like to enter the initial dialog? [yes]:
no
You see the following user EXEC prompt:
SLB-Switch>
You can now begin configuring the SLB switch.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3-2 Catalyst 4840G Software Feature and Configuration Guide 78-10416-02 Chapter 3 Configuring the Catalyst 4840G Processor Before Starting Up the Catalyst 4840G Using the Console Port or a Management Port You can configure the Catalyst 4840G switch from a direct console connection to the console por...
3-3 Catalyst 4840G Software Feature and Configuration Guide 78-10416-02 Chapter 3 Configuring the Catalyst 4840G Processor Configuring the Management Port Configuring the Management Port The management port on the Catalyst 4840G SLB switch allows multiple simultaneous Telnet or SNMP network manageme...
3-4 Catalyst 4840G Software Feature and Configuration Guide 78-10416-02 Chapter 3 Configuring the Catalyst 4840G Processor Displaying the Operating Configuration The Catalyst 4840G SLB switch should now be operating correctly. You can now use Telnet to remotely assign and verify configurations. Disp...
