Bunn G9 HD - Manual

Bunn G9 HD

Bunn G9 HD – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – The grind is preset at the factory to; drip; WARRANTY; manship for two years from the date of installation.
  • Page 3 – entrance to the grind chamber.; OPERATING CONTROLS; OFF; Placing the switch in this position initiates a timed grind cycle.; URN
  • Page 4 – Insert the funnel into the funnel rails and push until it stops.; ADJUSTMENTS; Burr Adjustment; Unplug the grinder and empty all beans from the hopper.; COAR
  • Page 5 – APPROXIMATE TIMER SETTINGS IN SECONDS; WEIGHT
  • Page 6 – Remedy
  • Page 8 – SERVICE; Component Access
  • Page 9 – Motor; GRN to Chassis Ground
  • Page 11 – BLK to Cordset; CORDSET CONNECTOR
  • Page 12 – Relay; TAN
  • Page 13 – Timer; WHI/GRN to Relay Coil
  • Page 14 – SCHEMATIC WIRING DIAGRAM G9; SINGLE PHASE; SCHEMATIC WIRING DIAGRAM; WIRING DIAGRAM
  • Page 15 – GREEN; TIMER; GREEN; TIMER
Loading the manual

OPERATING & SERVICE MANUAL

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: (217) 529-6601 FAX: (217) 529-6644

10171.0000 5/00 © 1986 Bunn-O-Matic Corporation

BUNN

®

G9 HD

G9T HD

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - The grind is preset at the factory to; drip; WARRANTY; manship for two years from the date of installation.

2 CONTENTS Introduction --------------------------------------------------- 2Warranty ------------------------------------------------------- 2User Notices --------------------------------------------------- 3Electrical Requirements -------------------------------------- 3Initial Set Up ------------...

Page 3 - entrance to the grind chamber.; OPERATING CONTROLS; OFF; Placing the switch in this position initiates a timed grind cycle.; URN

3 USER NOTICES Carefully read and follow all notices on the grinder and in this manual. They were written for your protection. All notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels. #05876.0000 #20545.0000 ELECTRICAL REQUIREMENTS This grinder has an at...

Page 4 - Insert the funnel into the funnel rails and push until it stops.; ADJUSTMENTS; Burr Adjustment; Unplug the grinder and empty all beans from the hopper.; COAR

4 CLEANING The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the windows with any abrasive mate-rial. Regular cleaning will keep your grinder looking new for years. COFFEE...

Other Bunn Models

All Bunn Other