Bunn FMD-1 - Manual
Bunn FMD-1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – workmanship for two years from the date of installation.; USER NOTICES
- Page 4 – ELECTRICAL REQUIREMENTS; CAUTION; PLUMBING REQUIREMENTS; COLD WATER
- Page 5 – LIQUID LEVEL CONTROL; NOTE
- Page 6 – Set the tank heater switch to the off position.
- Page 7 – DRAINING THE HOT WATER TANK
- Page 8 – TROUBLESHOOTING; WARNING –
- Page 13 – SERVICE; WARNING
- Page 14 – Wash components in a mild solution of dish deter-
- Page 39 – SINGLE PHASE; SCHEMATIC WIRING DIAGRAM FMD-1
BUNN
®
OPERATING & SERVICE MANUAL
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
29112.0000 5/00 ©1998 Bunn-O-Matic Corporation
FMD-1
FMD-2
S/N FMD0013000-UP
RELEA
SE BUT
TON W
HEN CUP IS
2/3 FU
LL
PLACE
CUP HER
E
PU
SH
an
d H
OL
D B
UT
TO
N U
NT
IL C
UP
IS
2/3
FU
LL
, T
HE
N R
EL
EA
SE
RELEASE BU
TTON
W
HEN C
UP IS 2/3 FULL
PLA
CE
CU
P HE
RE
PLACE
CU
P HE
RE
PU
SH
an
d H
OL
D B
UT
TO
N U
NT
IL C
UP
IS
2/3
FU
LL
, T
HE
N R
EL
EA
SE
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 INTRODUCTION This equipment dispenses hot beverages or soups on demand from powered product. It is for indoor use onlyon a sturdy counter or shelf. WARRANTY Bunn-O-Matic Corp. (“Bunn”) warrants the equipment manufactured by it to be commercially free from defects in material and workmanship existi...
4 INITIAL SET-UP 1. Locate the drip tray assembly beneath the dispenser nested in the packing material. 2. Remove the drip tray and the drip tray cover and set them aside. 3. Remove the water strainer assembly from the drip tray and set it aside. 4. Remove the four legs from the packaging material, ...
5 INITIAL FILL & HEAT CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Turn-on the water supply and connect the dispenser to the power source.2. Water will automatically flow into the tank to the prope...
