Bunn H5E - Manual
Bunn H5E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The agents, dealers or employees of BUNN
- Page 3 – Hot Water
- Page 4 – DUAL VOLT TOGGLE SWITCH
- Page 5 – Programming; PLUMBING REQUIREMENTS; COLD WATER
- Page 7 – LEVEL 2 PROGRAMMING
- Page 8 – OPERATING CONTROLS - PORTION CONTROL ONLY; BUTTON; ADJUSTING DISPENSE VOLUMES
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visit
the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain
the latest catalog and manual updates. Contact Bunn-O-Matic Corporation at 1-800-286-6070 to obtain
a paper copy of the required Illustrated Parts Catalog mailed via U.S. Postal Service.
39338.0001B 09/10 © 2009 BUNN-O-MATIC CORPORATION
H10X/H5X
H5E/DV PC
With Digital Control Board
Supercedes:
10420.0001; 10889.0001; 39338.0000
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 39338.1 051910 BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) All equipment other than as specifi ed below: 2 years parts and 1 year labor.2) Electronic circuit and/or control boards: parts and labor for 3 years.3) Compresso...
3 CONTENTS Warranty .......................................................2 Introduction ..................................................3 User Notices .................................................3 Electrical Requirements ................................4 Plumbing Requirements .................
4 ELECTRICAL REQUIREMENTS WARNING - The dispenser must be disconnected from the power source until specifi ed in Initial Set-Up. Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. 39338.1 072409 208 & 240 volt ac models Note: This electrical...
