Bunn JDF-2S - Manual
Bunn JDF-2S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
www.bunn.com
JDF-2S & 4S
Control Board
Replacement Instructions
#39422.1000
INTRODUCTION:
The control board for the JDF-4S (BUNN P/N: 39422.1000) can be used to replace the control board in the JDF-2S (BUNN
P/N: 38587.1000). This can be accomplished by completing the following instructions.
KIT CONTENTS:
39422.1000
Control Board
40511.0000
Instructions
40511.0000A 10/07 ©2007 Bunn-O-Matic Corporation
INSTRUCTIONS:
Step 1: Remove the drip tray and set aside.
Step 2: Remove the splash panel and set aside.
Step 3: Locate the control board and disconnect the seven
connectors. (Eleven connectors on JDF-4S)
Step 4: Remove the four, star nuts that are securing the
existing control board in place. Set the star nuts aside for
later use. Remove the control board from the machine.
Step 5: Remove the two white nylon spacers from the
old board and insert them onto the new replacement
board.
Step 6: Place the replacement board into the machine
and secure in place with the four, star nuts that you set
aside earlier.
Step 7: Reconnect all connectors to the replacement
board (seven for JDF-2S and eleven for JDF-4S). Use the
image to insure all the wires are connected to the correct
location. If this is not done correctly the machine will not
operate properly.
*Note: When using the JDF-4S control board in a JDF-2S
machine the middle right and right knobs are not used.
See *NOTE
J7
J1
J2
J5
J6
J3
Red & Black
J9
Black & White
Gray & White/
Black
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
