Worx wx427 - Manuals - manualsarea.com

Page 2 - Compact circular saw; General PoWer Tool

2 Compact circular saw WX427 General PoWer Tool SafeTy WarninGS WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE. The term "pow...

Page 3 - SafeTy inSTrucTionS

3 Compact circular saw WX427 of these devices can reduce dust-related hazards. 4. POWER TOOL USE AND CARE a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the ...

Page 7 - furTher SafeTy

7 Compact circular saw WX427 furTher SafeTy inSTrucTionS for abraSive cuTTinG-off oPeraTionS kickback and related warnings Kickback is a sudden reaction to a pinched or snagged rotating wheel. Pinching or snagging causes rapid stalling of the rotating wheel which in turn causes the uncontrolled powe...

Page 8 - SyMbolS

8 Compact circular saw WX427 SyMbolS To reduce the risk of injury, user must read instruction manual. Warning Double insulation Wear eye protection Wear ear protection Wear dust mask Laser radiation Do not stare into beam RCM marking

Page 11 - Technical daTa

11 Compact circular saw WX427 Technical daTa Voltage 230-240V ~ 50Hz Rated power 710W No load (rated) speed 3700/min Blade size TCT blade 120mmx9.5mmx1.2mmx24T HSS blade 115mmx9.5mmx1.2mmx60T Diamond disc 115mmx9.5mmx1.6mmx60G Cutting capacity Cutting Depth at 90° 46mm Cutting Depth at 45° 30mm Arbo...

Page 12 - oPeraTinG inSTrucTionS

12 Compact circular saw WX427 oPeraTinG inSTrucTionS NOTE: Before using the tool, read the instruction book carefully. INTENDED USE: The tool is intended for ripping and cross-cutting wood and other materials in straight cutting lines, while resting firmly on the work piece. 1. SAFETy ON/OFF Your sw...

Page 14 - WorKinG hinTS for your Tool

14 Compact circular saw WX427 airborne dust. It also keeps dust out of the working elements of the guard. 7. USING THE LASER The laser is used as a cutting guide and should form a red line on the material surface that is exactly aligned with the blade alignment indicator (23).Press down the laser on...

Page 15 - MainTain ToolS WiTh

15 Compact circular saw WX427 the tooth count of the saw blade. Therefore, use only sharp saw blades that are suited for the material being cut.Choice of blades: 24 teeth for general work, approx. 40 teeth for finer cuts, more than 40 teeth for very fine cuts into delicate surfaces, diamond for tile...

Page 16 - TroubleShooTinG

16 Compact circular saw WX427 TroubleShooTinG Symptom Possible Causes Possible Solution Tool will not start when operating the on/off switch. Power cord not plugged in.Power cord is broken.Carbon brush has worn down. Check to make sure power cord is connected well into a working outlet.Unplug the po...