Worx WX424 - Manual

Mini multi-function saw WX424 WX424.1 5 unprotected, rotating blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware of the time it takes for blade to stop after ON/OFF switch is released. addiTional SafeTy ruleS for your circular Saw 1. Only use saw blades recommended...

Mini multi-function saw WX424 WX424.1 6 SymBolS To reduce the risk of injury, user must read instruction manual Warning Double insulation Wear eye protection Wear ear protection Wear dust mask RCM approval mark Laser radiation Do not stare into beam

Mini multi-function saw WX424 WX424.1 9 Technical daTa Voltage 230-240V~50Hz Power input 310W No load speed 2800/min Blade diameter 76x10mm Cutting capacity 22mm Protection class /ll Machine weight 1.5kg acceSSorieS Vacuum adaptor 1 Non-scratch base cover 1 Parallel guide 1 Hex key 2 Blade: ø76 x ø ...

Mini multi-function saw WX424 WX424.1 10 oPeraTion inSTrucTionS NOTE: Before using the tool, read the instruction book carefully. 1. INSTALL /CHANGE THE BLADE (See Fig. A) WARNING: Be sure to wear protective work gloves while handling a saw blade. The blade can injure unprotected hands. WARNING: Thi...

Mini multi-function saw WX424 WX424.1 11 allow the blade clamping washer to engage with the flat side of the spindle. 2. MAKING DEPTH OF CUT ADJUSTMENTS (See Fig. D) NOTE: Always use the correct blade depth setting. The correct blade depth setting for all cuts should not be more than 6 mm below the ...

Mini multi-function saw WX424 WX424.1 12 (See Fig. F) to locate the 3 different positions. When the handle moves into 1 of the 3 positions the adjustment button will snap out and the handle will lock into position. When adjusting the handle, Always be sure that the button has snapped out and the han...

Mini multi-function saw WX424 WX424.1 13 6. STARTING A CUT (See Fig. J,K,L1,L2) a) Set-up and clamp your work piece and mark your cut line. b) Set the handle on the saw to the desired angle for your cutting application. c) Set the depth of cut (with corresponding length of cut). d) Position the fron...

Mini multi-function saw WX424 WX424.1 14 7. MAKING CROSS CUTS AND RIP CUTS (See Fig. M1, M2) a) Always use your saw with your hands positioned correctly (See Fig. M1, M2). WARNING: Always maintain proper control of the saw to make sawing safer and easier. Loss of control of the saw could cause an ac...

Mini multi-function saw WX424 WX424.1 15 9. INSTALLING AND USING THE PARALLEL GUIDE (Fig. N1,N2,N3) Your saw comes with a parallel guide that is 7-inches long on the guide edge. It allows you to make accurate parallel cuts when trimming a work piece. It attaches to the saw’s base. The arm of the par...

Mini multi-function saw WX424 WX424.1 16 10. PLUNGE OR POCKET CUTTING (Fig. Oa, Ob, Oc) Cutting into a solid base surface One of the major benefits of this saw is its ability to make plunge cuts directly into the middle, or interior of a work piece, or plunge cut directly into a solid base surface s...

Mini multi-function saw WX424 WX424.1 18 worKinG hinTS for your Tool If your power tool becomes too hot, please run your circular saw no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very low speeds.Protect saw blades against impact and shock. Excessive feed significantly reduces ...