Page 6 - in 1 Grass Trimmer/Edger
6 3 in 1 Grass Trimmer/Edger EN 1. REaR HaNdlE 2. BaTTERy PaCk 3. TElESCoPiC SHaFT 4. PivoT HEad loCkiNG kNoB 5. SaFETy GuaRd 6. FlowER GuaRd/EdGER GuidE 7. auxiliaRy HaNdlE 8. TElESCoPiC SHaFT adjuSTmENT TRiGGER 9. loCk oFF BuTToN 10. oN/oFF SwiTCH 11. auxiliaRy HaNdlE loCkiNG lEvER 12. EdGER/TRimm...
Page 7 - TECHNICAL DATA
7 3 in 1 Grass Trimmer/Edger EN TECHNICAL DATA wG160 wG160.1 wG175 Voltage 20V Max* 32V Max** No load speed 7600/min Cutting diameter 12” Line diameter 0.065” Charging time 3hr approx. Machine weight 5.7lbs 6.2lbs * Voltage measured without workload. Initial battery voltage reaches maximum of 20 vol...
Page 8 - sAFETY INsTrUCTIoNs
8 3 in 1 Grass Trimmer/Edger EN sAFETY INsTrUCTIoNs waRNiNG! Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemical...
Page 9 - ADDITIoNAL sAFETY
9 3 in 1 Grass Trimmer/Edger EN 2) Do not use battery-operated appliance in rain. 3) When replacing batteries, all batteries should be replaced at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the discharge battery (ies). (Applies to products ...
Page 10 - sYMBoLs; oPErATIoN INsTrUCTIoNs
10 3 in 1 Grass Trimmer/Edger EN Warning Read the manual Do not expose to rain or water Do not burn Always charge the battery pack between temperatures 40°F (4.5°C)-105°F (40.5.°C). Do not dispose of batteries, return exhausted batteries to your local collection or recycling point BATTERY PACK REMOV...
Page 11 - oPErATIoN
11 3 in 1 Grass Trimmer/Edger EN permit charging. Allow time for the battery to cool down before recharging. 3. To REmovE oR iNSTall BaTTERy PaCk (See Fig. C) Depress the battery release button to remove Battery Pack (2) from your trimmer. After recharging, insert the Battery Pack onto trimmer’s bat...
Page 13 - MAINTENANCE
13 3 in 1 Grass Trimmer/Edger EN Cutting Head (21). Keep the Spool Cap Cover and the inside of the Cutting Head clean from debris. To replace the Spool Cap Cover, press it firmly onto the Spool Holder. Ensure that it is correctly connected by trying to remove it without depressing the two Cap Releas...
Page 14 - TroUBLEsHooTING
14 3 in 1 Grass Trimmer/Edger EN 15 14 TroUBLEsHooTING The following table gives problems and actions that you can perform if your machine does not operate correctly. If these do not identify and correct the problem, contact your WORX Customer Service at 1-866-354-WORX. waRNiNG: Switch the machine o...