Worx W160E.5 - Manuals

8 3 in 1 Grass Trimmer/Edger WG160E.5 TECHNICAL DATA Voltage 20V Max* No load speed 7600/min Cutting diameter 30cm Line diameter 1.65mm Charging time 1hr Machine weight 2.6kg * Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts. Nominal voltage is 18 volts. ACCESS...

9 3 in 1 Grass Trimmer/Edger WG160E.5 ASSEMBLY 1. ASSeMBly of THe SAfeTy GUARD (See fig. A) Remove a screw from the Guard; attach the Safety Guard to the trimmer head. Align the Guard so it slides into the slots located on the trimmer head. Turn the tool over and secure the Safety Guard onto the tri...

11 3 in 1 Grass Trimmer/Edger WG160E.5 pull the trimmer head into the desired position, then lock the Pivot head Locking Knob. 9. floWeR GUARD/eDGeR GUIDe Pull the Flower Guard/Edger Guide out before trimming, as shown in Fig. I1. When edging, pull Flower Guard/Edger Guide out also, and keep to a si...

14 3 in 1 Grass Trimmer/Edger WG160E.5 To MANUAlly WIND lINe (See fig. l1-l4) Take approximately 10ft (3m) of line. Insert 5/8”(15mm) of line into the Spool holes and wind line in the direction of the arrows on the top of the Spool.Leave approximately 4” (100mm) of line unwound and place into the cl...

15 3 in 1 Grass Trimmer/Edger WG160E.5 TROUBLESHOOTING The following table gives problems and actions that you can perform if your machine does not operate correctly. WARNING: Switch the machine off and remove the battery prior to any troubleshooting. Problems Possible causes corrective Action Trimm...