WEN BG625V - Manuals

GENERAL SAFETY RULES 7. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. POWER TOOL USE AND CARE 1. Do not force the power tool. Use the correct power tool fo...

BENCH GRINDER SAFETY 1. This bench grinder is designed for sharpening and honing cutting tools, using the appropriate accessories. Using the machine for any other purpose for which it is not designed may result in serious injuries, machine damage and voiding of the warranty. 2. Grinding wheel safety...

ELECTRICAL INFORMATION AMPERAGE REQUIRED GAUGE FOR EXTENSION CORDS 25 ft. 50 ft. 100 ft. 150 ft. 2.5A 18 gauge 16 gauge 16 gauge 14 gauge 3. Check with a licensed electrician or service personnel if you do not completely understand the grounding instructions or whether the tool is properly grounded....

UNPACKING & PACKING LIST UNPACKING With the help of a friend or trustworthy foe, carefully remove the Bench Grinder from the packaging. Make sure to take out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list below to make sure you have...

KNOW YOUR BENCH GRINDER Eye Shield TOOL PURPOSE Sharpen bits, drill bits, chisels, gouges, and other cutting tools all with your WEN Bench Grinder. Refer to the fol- lowing diagrams to become familiarized with all the parts and controls of your bench grinder. The components will be referred to later...

12 3 4 5 6 12 3 4 5 6 QUENCHING TRAY Insert the tab on the rear of the quenching tray into the slot on the front of the bench grinder’s base. The quenching tray is great for holding water, oil, or whatever quenching liquid is needed for the job at hand. TOOL RESTS Two different tool rests are includ...

WORKLIGHT The bench grinder provided has a flexible work light to maximize visibility during operation. A light bulb for the flexible work light is not included. Use a 120 volt, 40 watt or less track light bulb (type R20, medium base) for the onboard lamp. Make sure the bulb does not protrude past t...

OPERATION SHARPENING GUIDE: SCISSORS - If possible, take the scissors apart to make the sharpening operation easier and safer. Remove material only from the outside surface and work from the heavy end of the blade toward the tip. KNIVES - Remove metal from both faces of most knives, working from the...

1 2 3 4. In normal use, grinding wheels may become cracked, grooved, rounded at the edges, chipped, out of true or loaded with foreign material. Cracked wheels should be replaced IMMEDIATELY. While any of the other conditions can be remedied with a dressing tool (included). New wheels sometimes requ...

PROBLEM CAUSE SOLUTION The motor won’t start. 1) Low voltage 2) Blown fuse/breaker. 3) Loose connections or open circuit in the motor. 4) Bad PCB. 1) Make sure the power source is providing the proper voltage. 2) Replace the fuse or reset the breaker. 3) Inspect the motor for loose or open connec- t...

EXPLODED VIEW & PARTS LIST NOTE: Not all parts may be available for purchase. Parts and accessories that wear down over the course of normal use are not covered under the warranty. 16

WARRANTY STATEMENT WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser on...