WEN 6510T - User Manual

1. TOOL PURPOSE. This sander is designed to sand wood or wood-like products only. Sanding or grinding other materials could result in fire, injury, or damage to the workpiece. Using the machine for any other pur-pose for which it is not designed may result in serious injuries, machine damage and voi...

SPECIFIC RULES FOR THE SPINDLE SANDER 11. FEEDING THE WORKPIECE.• Allow spindle to reach full speed before feeding the workpiece. Do not turn on the machine while the sand-ing sleeve is contacting the workpiece. • Be aware of the direction of the spindle’s rotation (counterclockwise). Only feed the ...

1. EXAMINE EXTENSION CORD BEFORE USE. Make sure your extension cord is properly wired and in good condition. Always replace a damaged extension cord or have it repaired by a qualified person before using it. 2. DO NOT ABUSE EXTENSION CORD. Do not pull on cord to disconnect from receptacle; always di...

KNOW YOUR SPINDLE SANDER Dust Port Accessory Storage (On 3 sides of the machine) Spindle Spindle Upper Washer Sanding Drum & Sleeve Throat Plate Circuit Breaker ON/OFF Switch with Safety Key Work Table Rubber Sanding Drums Mounting Holes UNPACKING With the help of a friend or trustworthy foe, ca...

ASSEMBLY & ADJUSTMENTS Before using the spindle sander, you must configure the machine by installing the appropriate sanding drum, sanding sleeve, throat plate and spindle washer for your operation. Check your packing list against the dia- gram below. If any part is damaged or missing, please co...

ASSEMBLY & ADJUSTMENTS WARNING: Do not plug in or turn on the tool until it is fully assembled according to the instruc- tions. Failure to follow the safety instructions may result in serious personal injury. 11 ACCESSORY SELECTION Refer to the packing list diagram on page 10 to ensure that you ...

ASSEMBLY & ADJUSTMENTS MACHINE MOUNTING For safe operation, the machine must be secured onto a flat, secure workbench or stand. The base of the ma- chine has four 6 mm mounting holes. Place the sander on the mounting surface, and insert a pencil through the mounting holes to mark the hole locati...

OPERATING THE SPINDLE SANDER 1. Make sure that the machine has been securely mounted, and all accessories have been properly installed according to the instructions in the "ASSEMBLY & ADJUSTMENTS" sec- tion. 2. Plug in and turn ON the sander. Let the spindle reach full speed. OPERATION O...

MAINTENANCE ROUTINE INSPECTION Before each use, inspect the general condition of the tool. If any of these following conditions exist, do not use until parts are replaced or the sharpener is properly repaired. Check for: • Loose hardware or improper mounting,• Misalignment or binding of moving parts...

PROBLEM CAUSE SOLUTION Sander does not turn on 1. Power cord or extension cord dam- aged or not properly plugged in. 2. Safety key is removed from power switch. 3. Defective power switch, defective motor or wiring, short circuit or loose connections. 4) Circuit breaker is tripped. 5) Worn carbon bru...

EXPLODED VIEW & PARTS LIST 17 1 2 (113, 114, 115) 3 (102, 103, 104, 105, 106, 107) 4 (108, 109, 110, 111, 112) 5 (96, 97, 98, 99, 100, 101) 6 7 8 9 10 12 65 4142434445464748495051525354 55565759605861626364 73 74 75 76 79 80 81 82 83 85 86 87 88 89909192 93 94 11 118 117 68 116 131415 1716 1819 ...

WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN CONSUMER POWER TOOLS PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser ...