WEN 20401 - Manuals

GENERAL SAFETY RULES 7. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. POWER TOOL USE AND CARE 1. Do not force the power tool. Use the correct power tool fo...

6 MOUSE SANDER SAFETY WARNINGS WARNING! Do not operate the power tool until you have read and understood the following instructions and the warning labels. MOUSE SANDER SAFETY 1. Hold your power tool by the insulated gripping sur- faces, especially when performing an operation where the accessory co...

7 ELECTRICAL INFORMATION (CHARGER) AMPERAGE REQUIRED GAUGE FOR EXTENSION CORDS 25 ft. 50 ft. 100 ft. 150 ft. 2A 18 gauge 16 gauge 16 gauge 14 gauge IMPORTANT: Servicing a double-insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personne...

• Avoid dangerous environments – Do not charge the battery pack in rain, snow or in damp or wet locations. Do not use the battery pack or charger in the presence of explosive atmospheres (gaseous fumes, dust or flam- mable materials) because sparks may be generated when inserting or removing the bat...

BATTERY & CHARGER SAFETY WARNINGS ABOUT THE BATTERY 1. The battery pack has to be charged completely before you use the tool for the first time.2. For optimum battery performance, avoid low discharge cycles by charging the battery pack frequently.3. Lithium-ion batteries are subject to a natural...

10 Accessories Components UNPACKING & PACKING LIST UNPACKING Carefully remove the mouse sander from the packaging and place it on a sturdy, flat surface. Make sure to take out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list below to ...

11 KNOW YOUR MOUSE SANDER ON / OFF Switch TOOL PURPOSE Easily sand corners and very tight spaces with your WEN Mouse Sander. Refer to the following diagrams to become familiarized with all the parts and controls of your mouse sander. The components will be referred to later in the manual for assembl...

12 OPERATION CHARGING THE BATTERY PACK (CONT.) The battery pack is equipped with three LED battery life indication lights. Press and hold the power button on the rear of the battery to check the battery’s charge status. Battery Life Indication: • Three Lights: The battery is fully charged. • Two Lig...

13 OPERATION WORKPIECE AND WORK AREA SET UP 1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury. We know your cat is super cute, but pay attention to your project.2. Secure loose workpieces using vises or clam...

14 MAINTENANCE ROUTINE INSPECTION Before each use, inspect the general condition of the tool. If any of these following conditions exist, do not use until parts are replaced. Check for: • Loose hardware, • Damaged battery pack, • Cracked or broken parts, and • Any other condition that may affect its...

15 Problem Common Causes Solution Deep sanding grooves or scars in workpiece. 1. Sandpaper grit is too coarse. 1. Use a finer-grit sandpaper. 2. Workpiece sanded across the grain. 2. Sand with the grain of the wood. 3. Too much sanding force on workpiece. 3. Reduce pressure on workpiece while sandin...

16 EXPLODED VIEW & PARTS LIST NOTE: Not all parts may be available for purchase. Parts and accessories that wear down over the course of normal use are not covered under the warranty.

17 EXPLODED VIEW & PARTS LIST No. Part No. Description Qty. 1 Battery Terminal 1 2 Switch 1 3 Switch Cover 1 4 Motor 1 5 Motor Plate 1 6 Spring Washer, 4mm 2 7 Spindle 1 8 Screw, M4x6 2 9 Bearing, 6900 1 10 Fan 1 11 Flywheel 1 12 Dust Port, Upper 1 13 Dust Port, Lower 1 14 20401- 014ASM Dust Bag...

WARRANTY STATEMENT WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser on...