Smooth Fitness 9.35HR - Manuals

www.smoothfitness.com 5 SUPPLIED COMPONENTS This list identifies the major components you will use to assemble this product. No. Description Qty. A1 Computer 1 A2 Front Handlebar Assembly 1 A3 Handlebar 2 A4 Upright Assembly Left 1 A5 Upright Assembly Right 1 A6 Main Frame Assembly 1 G Chest Belt 1 ...

6 9.35HR TREADMILL SUPPLIED HARDWARE This list identifies the hardware you will use to assemble the product. To help distinguish between the various types of screws and bolts, use the scale below to measure them and compare them to the sizes listed. No. Description Qty. 804 M8x16mm Bolt 2 805 M8x50m...

www.smoothfitness.com 7 COMPLETE PARTS LIST Item No. Description Qty. Part No. 9.35HR-100 Complete Computer Console 101 Overlay 1 9.35HR-101 102 Computer Plastic Insert 1 9.35HR-102 103 Console PC Board 1 9.35HR-103 104 Console Housing – Upper 1 9.35HR-104 105 Console Housing – Bottom 1 9.35HR-105 1...

8 9.35HR TREADMILL COMPLETE PARTS LIST Item No. Description Qty. Part No. 315 Adjustable Cylinder Cover - Upper 2 9.35HR-315 318 Fixing Inserts 2 9.35HR-318 9.35HR-400 Complete Base Frame Components 401 Base Frame 1 9.35HR-401 402 Safety Key Wire – Lower 1 9.35HR-402 403 8pin Computer Wire – Lower 1...

www.smoothfitness.com 9 COMPLETE PARTS LIST Item No. Description Qty. Part No. 605 Side Rail End Cap – Right 1 9.35HR-605 9.35HR-700 Complete Deck Frame Components 701 Deck Frame 1 9.35HR-701 702 Front Roller Shaft 1 9.35HR-702 703 Front Roller 1 9.35HR-703 704 Roller Bearing 6203 4 9.35HR-704 705 R...

10 9.35HR TREADMILL COMPLETE PARTS LIST Item No. Description Qty. Part No. 840 M10x40mm Bolt 1 9.35HR-840 841 M6x10mm Screw 2 9.35HR-841 842 M10x30mm Allen Head Bolt 2 9.35HR-842 843 M8x15mm Allen Head Bolt 4 9.35HR-843 845 13x42mm Shaft 2 9.35HR-845 846 8x23x2mm Washer 2 9.35HR-846 848 3x8mm Screw ...

www.smoothfitness.com 11 PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE-ASSEMBLED

12 9.35HR TREADMILL PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE-ASSEMBLED.

18 9.35HR TREADMILL ASSEMBLY STEP 1 : UNPACKING AND INVENTORY (A)Remove your treadmill from the carton and place it on the floor in an open area. (B)Remove the treadmill and all the components and hardware from the box. (C)Check the quantities of all components and hardware with the component and ha...

www.smoothfitness.com 19 ASSEMBLY STEP 2 : ASSEMBLE UPRIGHT NOTE: MAKE SURE ALL WIRES ARE RECESSED INTO THE FRAME. DO NOT TRAP OR PINCH. DO NOT TIGHTEN BOLTS UNTIL STEP9. (A) Connect the Lower and middle section wire as seen below (307 to 402)(308 to 403). (B) Insert any extra cable length into the ...

20 9.35HR TREADMILL ASSEMBLY STEP 3 : ASSEMBLE THE SIDE HANDLEBARS NOTE: SIDE RAILS ARE INTERCHANGEABLE FOR USE IN BOTH RIGHT AND LEFT SIDES. MAKE SURE ALL WIRES RECESSED INTO THE FRAME. DO NOT TRAP OR PINCH. (A) Connect the Left Motion Control lower wire to the middle wire (207 to 309). As Shown in...

www.smoothfitness.com 21 ASSEMBLY STEP 4 : ASSEMBLE FRONT HANDLEBAR (A) Place the front handlebar (203) on top of the left and right uprights (301). (B) Now secure the front handlebar with four M8x50mm bolts (805). (C) Tighten all handlebar hardware (be sure not to pinch wires). 805 X4

22 9.35HR TREADMILL ASSEMBLY STEP 5 : ATTACHING THE UPRIGHT COVER AND CONNECT COMPUTER CABLE NOTE: BE CAREFUL NOT TO DAMAGE THE WIRES WHEN SECURING THE UPRIGHT COVERS. (A) Attach the Upright Cover – LR (304) to the Left upright (301), and secure using the two 4x15mm Screws (807). (B) Repeat the abov...

www.smoothfitness.com 23 ASSEMBLY STEP 6 : Attach the Outside Upright Covers NOTE: CAREFULLY FOLD THE COMPUTER CABLES AND TUCK THEM BETWEEN THE PLASTIC RIDGES OF PARTS 304 AND 305 SO THEY WILL NO BE PINCHED. (A) Secure the ground wire onto the Right upright with one 4x15mm Screw (807). (B) Attached ...

24 9.35HR TREADMILL ASSEMBLY STEP 7 : ATTACH ADJUSTABLE CYLINDER TO TREADMILL FRAME WARNING: THE PATENTED HYDRASUSPENSION SYSTEM REQUIRES THE ADJUSTABLE CYLINDER TO BE TIGHT FITTING. PLEASE BE PATIENT WITH THIS ASSEMBLY STEP. (A) Put Adjustable Cylinder Cover-Upper (315) into Adjustable Cylinder (31...

www.smoothfitness.com 25 ASSEMBLY STEP 8 : ASSEMBLE FRONT PLASTIC SHROUDS (A) Attach the outer Left Upright Plastic Shroud – LL (311) , the inner Left Upright Plastic Shroud – LR (312) and the Adjustable Cylinder Cover – Upper 315 to the Left Upright (301) and secure with five M8x20mm Screws (806) a...

26 9.35HR TREADMILL ASSEMBLY STEP 9 : Securing of the Upright Tubes NOTE: ONLY TURN BOLTS CLOCKWISE. The Allen Bolt Sets (412) have been pre-assembled in the Base Frame (401). (A) Secure The Upright Tubes by tightening the Allen Bolt (412), located in the Upright Tube, clockwise.

www.smoothfitness.com 27 STABILIZER ADJUSTMENT FOLLOW THESE INSTRUCTIONS TO LEVEL YOUR TREADMILL : An uneven floor or improper stabilizer level can cause the treadmill to wobble during use as well as the incline adjustment to function incorrectly. Please follow the procedure described below to make ...

28 9.35HR TREADMILL FEATURES Serial Number Location Insert safety key The safety key must be inserted for the treadmill to function. The safety key clip should be worn at all times when the treadmill is in use. This safety feature is designed to prevent injury.

www.smoothfitness.com 29 MOTION CONTROL OPERATION MOTION CONTROL : Walking belt speed can be increased, decreased or stopped using the Motion Control sensors on the handlebars. To do this follow the instructions below: 1. Press the button on the console to switch the motion control function on and o...

30 9.35HR TREADMILL MAINTAINENCE HOW TO MAINTAIN THE 9.35HR TREADMILL : Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY coverage. • Importan...

www.smoothfitness.com 31 MAINTAINENCE CLEANING : Routine cleaning of your treadmill will extend the product's life. • Warning : To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is unplugged from the wall electrical outlet before attempting any cleaning or mai...

32 9.35HR TREADMILL WARRANTY LIMITED HOME USE WARRANTY – SMOOTH FITNESS Treadmills Warranty Warranty Coverage : EVO Fitness and Smooth Fitness, Inc. ("Smooth Fitness") warrants to the original owner that each new product to be free from defects in workmanship and material, under normal use a...

www.smoothfitness.com 33 IMPORTANT STEPS Warning : Before using this product, please consult your personal physician for a complete physical examination. Frequent and strenuous exercise should be approved by your doctor first. If any discomfort should result from your use of this product, stop exerc...

34 9.35HR TREADMILL TARGET HEART RATE Finding your pulse : To make sure your heart is beating in its target zone, you’ll need to know how to monitor your heart rate. The easiest way is to feel the pulse in the carotid artery on either side of your neck, between the windpipe and the large neck muscle...

www.smoothfitness.com 35 MUSCLE CHART Targeted muscle groups : The exercise routine that is performed on this product will develop primarily lower body muscle groups. These muscle groups are shown in gray color on the chart below. MUSCLE GROUPS A Shoulder muscles Calf muscles G B Pectoral muscles Tr...

36 9.35HR TREADMILL STRETCHING ROUTINE Warm up and cool down : A successful exercise program consists of a warm-up, aerobic exercise, and a cool-down. Do the entire program at least two and preferably three times a week, resting for a day between workouts. After several months, you can increase your...

www.smoothfitness.com 37 TROUBLESHOOTING NOTE : Do not touch any internal electric wires without consulting the manufacturer. Treadmill will not start : Symptom Resolution Treadmill will not power up Check the following: Make sure the power cord is plugged into a surge protector, the surge protector...