Smeg SNL34AX1- Manuals

Smeg SNL34AX1– Manual in PDF format online.

Manuals:

Manual

Manual Smeg SNL34AX1

Summary

Page 2 - Introduction; INSTRUCTIONS FOR SAFE AND PROPER USE

Introduction 24 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE...

Page 3 - DO NOT PUT; The manufacturer declines all responsibility

Introduction 25 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDE...

Page 4 - Instructions for the installer; POSITIONING OF THE HOB; Attachment to support structure

Instructions for the installer 26 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as the...

Page 5 - Fixing 90 cm hobs on 60 cm base unit

Instructions for the installer 27 Bracket ‘ A ’ in the 1st slot Bracket ‘ A ’ in the 2nd slot Bracket ‘ B ’ 2.2 Fixing 90 cm hobs on 60 cm base unit If a 90 cm hob is to be bracketed to a 60 cm base unit, 2 central brackets “ A ” have to be used in addition to the side brackets “ B ” as shown in the...

Page 6 - ELECTRICAL CONNECTION; The plug on the end of the supply cable and the wall socket must be

Instructions for the installer 28 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same t...

Page 7 - GAS CONNECTION; rigid copper

Instructions for the installer 29 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and conforming to the provisions defined by standard regulations in force. To facilitate connection, fitting A on the rear of the appliance may be adjusted late...

Page 8 - Connection to LPG; Use a pressure regulator and make the connection to the tank; Ventilation of rooms; Discharge of combustion products must be guaranteed by means of

Instructions for the installer 30 4.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions of standards regulations in force. Make sure that feed pressure conforms to the levels shown in the table in paragraph “5.3 Regulation for LPG”. 4.2 Ventil...

Page 9 - ADAPTATION TO DIFFERENT TYPES OF GAS; appliance from the electrical socket.; natural gas; Removing the separable control panel

Instructions for the installer 31 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, disconnect the appliance from the electrical socket. The hob has been inspected for G25 (2L3B/P) natural gas at a pressure of 25 mbar. For functioning with other types of gas ...

Page 10 - Regulation for LPG

Instructions for the installer 32 5.3 Regulation for LPG Check that the connection has been made as described in the “Gas connection” section. Undo the screw “ D ” and push the air regulator “ C ” fully down. Use a spanner to remove the nozzles “ B ” and fit those of suitable type following the inst...

Page 11 - Regulation for G25/25 mbar; Methaangas – G25

Instructions for the installer 33 5.4 Regulation for G25/25 mbar The hob has been inspected for G25 (2L3B/P) at a pressure of 25 mbar. To allow the unit to work with this type of gas, perform the same operations described in paragraph “5.3 Regulation for LPG”, but choose the nozzles and regulate the...

Page 12 - Regulation of primary air; Referred to distance “; 0 cm hobs with separable control panel.

Instructions for the installer 34 5.5 Regulation of primary air Referred to distance “ A ” in mm. 60 cm hobs with separable control panel. Burner G25 25 mbar G30/G31 28/37 mbar Auxiliary (1) 2.5 2.5 Semirapid r (2) 0.5 2.0 Semirapid l (3) 0.5 1.5 Rapid large (4) 0 2.5 Ultrarapid (5) 2.0 4.0 90 cm ho...

Page 13 - FINAL OPERATIONS; Regulation of minimum for natural gas; Regulation for LPG”.

Instructions for the installer 35 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “5.1 Removing the separable control panel / 5.2 Removing the hob”. 6.1 Regulation of minimum for natural gas Replace the compone...

Page 14 - Arrangement of the burners on the hob; BURNERS

Instructions for the installer 36 6.3 Arrangement of the burners on the hob (Hob with separable control panel) 60 cm. hob BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid large 5. Ultrarapid 90 cm. hob BURNERS 1. Auxiliary 2. Semirapid 3. Rapid 4. Fish burner 5. Ultrarapid

Page 15 - Auxiliary; Lubrication of gas taps; This operation must be done

Instructions for the installer 37 6.4 Arrangement of the burners on the hob (Hob with built-in control panel). 60 cm. hob BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid 5. Ultrarapid 6.5 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clea...

Page 16 - Instructions for the user; USING THE HOB; must be aligned with pin; Ignition of the burners; In models with safety valve, the knob; Practical advice for using the burners; To avoid overcooking or damage to the surface top

Instructions for the user 38 7 USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with woks (Chinese pans). Adapter D comes only wi...

Page 17 - Diameter of the pans; Electric elements

Instructions for the user 39 while cooking, all pans or griddles must be positioned within the cooking hob perimeter and must be a minimum distance of 3-4 cm from the knobs. 7.3 Diameter of the pans Burners Ø min. and max. (en cm.) Auxiliary 12-14 Semirapid 16-20 Rapid medio 22-26 Rapid large 22-26 ...

Page 18 - WARNING; Using a griddle plate

Instructions for the user 40 or fish. 5 Strong For roasts, steaks and large boiled joints. 6 Very strong To boil large amounts of water, to fry. WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humidity fro...

Page 19 - CLEANING AND MAINTENANCE; Never use a steam jet to clean the appliance.; Cleaning; Regular daily cleaning of the hob; pour the product on a damp cloth and wipe the surface,; Food stains or residues

Instructions for the user 41 8 CLEANING AND MAINTENANCE Never use a steam jet to clean the appliance. Before any intervention, disconnect the power supply of the device. 8.1 Cleaning Clean the cooking top regularly every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of...

Page 20 - Cleaning of cooking hob components; Ignition plugs and safety devices

Instructions for the user 42 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishwasher. In normal use of the hob, the stainless steel burner caps and pan-stands tend to be burnished by the high temperature. Clean these parts using very fine abrasive sponges or simi...