Smeg PGF95BE-1- Manuals

Page 2 - Introduction; INSTRUCTIONS FOR SAFE AND PROPER USE

Introduction 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB. ALSO ...

Page 4 - Instructions for the installer; POSITIONING OF THE HOB; Create an opening with the

Instructions for the installer 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood, as long as they ...

Page 6 - Apply a layer of “waterproof primer” to the milled surface.

Instructions for the installer 2.2 Attachment to support structure, flush-mounting model Create an opening with the dimensions shown in the figure in the work surface, observing a minimum distance of 50 mm from the rear edge. The lower part of the protective cover must be fully accessible when the a...

Page 8 - connection; Do not use reducers, adapters or shunts.

Instructions for the installer 2.3 Electrical connection Make sure that the voltage and capacity of the power supply cable conform to the data shown on the plate located under the protective cover. Do not remove this plate for any reason. The power supply cable plug and the wall socket must be of th...

Page 9 - requirements

Instructions for the installer 2.4 Ventilation requirements The appliance may be installed only in rooms with permanent ventilation, as required by UNI-CIG 7129 / 7131 standards. The room in which the appliance is installed must have sufficient air flow to satisfy the requirements of normal gas comb...

Page 11 - ADJUSTMENT TO DIFFERENT TYPES OF GAS; Replacement of nozzles on the hob; Replace the burners in the correct position.

Instructions for the installer 3 ADJUSTMENT TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, unplug theappliance from the mains. The hob is set for natural gas G20 (2H) at a pressure of 20 mbar. In the case of functioning with other types of gas the burner nozzles must b...

Page 12 - Burner and nozzle characteristics table; Arrangement of burners on cooking hob; Auxiliary

Instructions for the installer 3.2 Burner and nozzle characteristics table Burner Rated heating capacity (kW) LPG – G30/G31 30/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flow rate (W) Flow rate g/h G30 Flow rate g/h G31 Auxiliary (1) 1.05 50 27 (*) 28 (**) 350 76 75 Semi rapid (2) 1.8...

Page 13 - FINAL; Regulation of minimum for town gas and natural gas

Instructions for the installer 4 FINAL OPERATIONS After carrying out the above adjustments, remount in reverse order to the instructions given in paragraph “3.1 Replacement of nozzles on the hob”. After adjustment to a different kind of gas from the one for which the appliance has been tested, repla...

Page 14 - Instructions for the user; USING; Ignition of the burners; the high flame symbol

Instructions for the user 5 USING THE HOB 5.1 Ignition of the burners Before turning on the burners, make sure that the flame-spreader crowns and respective caps are properly fitted in their housings. Ensure the flame-spreader holes A are aligned with the ignition plugs and the thermocouples. Pansta...

Page 15 - Practical advice for using the burners

Instructions for the user 5.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered cooking receptacles that have a flat, smooth bottom and are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “5.3 Dia...

Page 16 - CLEANING; Before any intervention, disconnect the appliance from the mains.; Cleaning the stainless steel; Routine daily cleaning; Cleaning of cooking hob components

Instructions for the user 6 CLEANING AND MAINTENANCE Before any intervention, disconnect the appliance from the mains. 6.1 Cleaning the stainless steel To keep stainless steel in good condition it should be cleaned regularly after use. Let it cool first. 6.1.1 Routine daily cleaning To clean and pre...