Siemens Cooker hood - Manuals

5 Operating procedure The most effective method of removing vapours produced during cooking is to: ❑ Switch the ventilator ON as soon as you begin cooking. ❑ Switch the ventilator OFF a few minutes after you have finishedcooking. Setting the required fan speed: ❑ Press the corresponding button. Ligh...

6 3. Insert the grease filters (see removal andinstallation of the metal-mesh greasefilters). Removing the filter: The filters are removed in reverse sequence. Replacing the activated carbon filters: ❑ During normal operation (1 to 2 hoursper day) the activated carbon filtersshould be replaced appro...

7 Replacing the light bulbs 1. Switch off the extractor hood and pullout the mains plug or switch off the electricity supply at the fuse box. 2. Remove the grease filters (see Filters andMaintenance). 3. Press down the bulb cover and disconnect from the light strip. 4. Replace the bulb (standard fil...

9 Prior to installation Exhaust-air mode The exhaust air is discharged upwardsthrough a ventilation shaft or directlythrough the outside wall into the open. D Exhaust air should neither be directed into a smoke or exhaust flue that iscurrently used for other purposes, nor intoa shaft that is used fo...

10 Prior to installation ❑ Flat ducts must have an internal cross- section that equates to that of roundpipes. There should be no sharp bends. For operating in exhaust-air mode, a one-way flap should be mounted inside theextractor hood unless there is already onefitted in the outlet duct or wall ven...

11 Prior to installation Circulating-air mode ❑ With activated carbon filter if exhaust-airmode is not possible. The complete installation set can be obtained from specialist outlets. The corresponding accessory numbers canbe found at the end of these operatinginstructions. Preparing the wall ❑ The ...

12 Installation This extractor hood is intended to be mounted onto the kitchen wall. 1. Remove the grease filter (refer to Operating Instructions). 2. Draw a line on the wall from the ceilingto the lower edge of the hood at thecentre of the location where the hood isgoing to be mounted. 3. Using the...

13 Installation 0 8. Insert the other 4 screws with washers. Before the 4 screws are tightened down, align the extractor hood properly. 0 9. Connect up the air outlet pipe. 10. Connect the hood to the electricitysupply. 13. Position the lower flue duct on theextractor hood and screw the extractorhoo...

9000 159 007 Printed in Germany 0306 Es. Siemens-Electrogeräte GmbH Family Line 018 0 5-2223 3 0,12/min. DTAG Siemens-Hausgeräte Besuchen Sie uns im Internet:http://www.siemens.de/hausgeraete