ResMed S8 Escape II Auto - Manuals

3 Using the S8 Escape II Auto En glis h Using the S8 Escape II Auto Setting Up the S8 Escape II Auto 1 Connect the power cord to the socket at the rear of the device. 2 Plug the other end of the power cord into the power outlet. 3 Connect one end of the air tubing firmly onto the air outlet. 4 Conne...

4 How to Use the Control Panel The control panel of the S8 Escape II Auto includes an LCD screen which displays the menus and treatment screens as well as a keypad for navigating through the menus and delivering treatment. The S8 Escape II Auto keypad has the following keys: The keypad and LCD are e...

5 Using the S8 Escape II Auto En glis h 3 Alter the ramp/settle time if required. 4 To start treatment, press . 5 Fit your mask as described in the mask user instructions. ! WARNING A mask should not be used unless the S8 Escape II Auto is turned on and operating properly. Stop Treatment To stop tre...

7 Using the Data Card to Collect data En glis h Your clinician can set any of the following reminders on your LCD: Using the Data Card to Collect data If your clinician needs to review your treatment, they will ask you to use the Data Card to copy data from your S8 Escape II Auto, and to return the ...

8 Using the Data Card to Update Settings If your clinician has provided a Data Card with new device settings: 1 With the device in standby mode, insert the Data Card into the slot on the Data Card module. Updating will start automatically.The “Card Inserted Please Wait” message is displayed on the L...

9 Cleaning and Maintenance En glis h ! CAUTION • Do not hang the air tubing in direct sunlight as it may harden over time and eventually crack. • Do not use bleach, chlorine, alcohol, or aromatic-based solutions, moisturising or antibacterial soaps or scented oils to clean the air tubing or the S8 d...

10 ! CAUTION • Do not attempt to open the S8 Escape II Auto case. There are no user serviceable parts inside. • Inspection and repair should only be performed by an authorized agent. Under no circumstances should you attempt to service or repair the S8 Escape II Auto yourself. Frequently Asked Quest...

11 Troubleshooting En glis h Can I travel with the S8 Series II? Your S8 Series II has an internal power supply that enables it to operate in other countries. It will operate on power supplies of 100–240V and 50/60Hz. No special adjustment is necessary, but you will require an approved power cord fo...

13 Technical Specifications En glis h Technical Specifications . Note: The manufacturer reserves the right to change these specifications without notice. Symbols which appear on the device Attention, consult accompanying documents; Drip proof; Type CF equipment; Dangerous voltage; Class II equipment...

14 General Warnings and Cautions ! WARNINGS • Read the entire guide before using the S8 Series II. • Advice contained in this guide should not supersede instructions given by the prescribing physician. • A patient should not connect a device to the data communication port unless instructed to do so ...

15 General Warnings and Cautions En glis h Note: At a fixed rate of supplemental oxygen flow, the inhaled oxygen concentration will vary, depending on where the oxygen is introduced, the pressure settings, patient breathing pattern, mask selection, and leak rate. • Do not use the S8 Series II if the...

16 Limited Warranty ResMed warrants that your ResMed product shall be free from defects in material and workmanship for the period specified below from the date of purchase by the initial consumer. This warranty is not transferable. Note: Some models are not available in all regions. If the product ...