Quadra-Fire 1100-I - Manuals

LISTINGS AND SPECIFICATIONS QUADRA-FIRE 1100-I pellet inserts are safety tested and listed with Warnock Hersey International to UL 1482, ULC S627, APFI, and Oregon Administrative rules 814-23-900 through 814-23-909. INSTALLATION MASONRY AND ZERO CLEARANCE A Insert side to combustible 2” (50mm) B Ins...

FLOOR PROTECTION This unit may be installed on combustible flooring, providing there is 1 1/2” (37mm) of air space from the base tocombustible floor, or it is placed on nominal 4” (100mm) hollow concrete blocks or any insulating material with a minimumR value of 2.5. CHIMNEY AND EXHAUST CONNECTIONS ...

FEED ADJUSTMENT INSTRUCTIONS 1) Remove any fuel in the hopper. 2) Loosen set screw. 3) Loosen wing nut. 4) Adjust the fuel feed by pulling the rod back to increase the feed, and sliding it forward to decrease the feed. 5) Tighten the set screw and the wing nut. NOTE: Adjust fuel after the convection...

OPERATING INSTRUCTIONS 1. FUEL SIZE AND MATERIAL Fuel pellets are made from sawdust or wood by-products. If the source material is hardwood, pellets will have a higher mineralcontent, creating a heavier ash. Minerals and other noncombustible materials, such as sand, will turn into glass when heated ...

1. FIREPOT A. It takes very little time to clean the firepot. We recommend that you clean the firepot at least once a week. However, if the fuel you are burning has a high dirt content, it will be necessary to clean the firepot more often. Dirty fuel will cause clinkers to form in thefirepot. A clin...

1. POWER SUPPLY Check the wall receptacle for 120 volt, 60 Hz (standard current).Make sure the outlet is grounded and has the correct polarity.When operating with a generator, be sure you have at least 700watts of power available for the insert during the start cycle. 2. FUSE The fuse is located on ...

1. PLUG IN INSERT, NO RESPONSE A. Check the power supply for 120 volts AC.B. Check the fuse in the junction box (7 amp, 120 volt fuse AGC-7). C. Check snap disc #3 (unplug insert before checking). Push reset on snap disc #3. D. Control box (consult your dealer). 2. CALL LIGHT ON, NO FIRE, NO FUEL IN...

Aladdin Hearth Products, warrants their pellet heating appliances to the original purchaser for the lifetime of the appliance, to be free from defects inmaterial and workmanship. This warranty gives you specific legal rights; you may have other rights which may vary from state to state. This limited...