Page 2 - CONTENTS; LIST OF ILLUSTRATIONS
2 Pelco Manual C933M (7/99) CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS ................................................................ 3 DESCRIPTION ................................................................................................................... 3 MODELS ...............
Page 3 - IMPORTANT SAFEGUARDS AND WARNINGS; The product and/or manual may bear the following marks:; DESCRIPTION; MODELS; INSTALLATION; SURFACE MOUNT; Follow the instructions that accompany the rack kit.; Do
Pelco Manual C933M (7/99) 3 IMPORTANT SAFEGUARDS AND WARNINGS Observe the following warnings before installing and using this product. 1. Installation and servicing should be done by qualified installation and service personnelonly. 2. Installation should be done according to all local and national ...
Page 4 - Single-Monitor Installation; MULTIPLE-MONITOR INSTALLATION; Cable; Video Coaxial
4 Pelco Manual C933M (7/99) CONNECTIONS SINGLE-MONITOR INSTALLATION Refer to Figure 1 and Table A for the following instructions. 1. Set the impedance switch on the back of the monitor to 75 ohms. 2. Connect a 75-ohm video cable from the video source, such as a camera, to the BNCconnector labeled IN...
Page 5 - OPERATION; LED Power Indicator -; On the back of the
Pelco Manual C933M (7/99) 5 FROM OUTPUT TO INPUT FROM OUTPUT TO INPUT FROM VIDEO SOURCE TO INPUT REAR PANEL OF MONITOR 3 IMPEDANCE 75 Ω HI IN OUT FUSE NOTE: SET IMPEDANCE SWITCHES AS APPROPRIATE FOR THENUMBER OF MONITORS INYOUR CONFIGURATION IMPEDANCE SWITCH SET TO "HIGH" IMPEDANCE SWITCH SE...
Page 6 - This control permits adjustment of horizontal stability. If the; Vertical Roll; To operate a monitor:; MAINTENANCE; Use a damp cloth to clean the screen.
6 Pelco Manual C933M (7/99) Contrast Control - This control adjusts the contrast between the black and white portions of the picture. When properly adjusted, you will be able to observe a fine gradation betweenblacks, grays, and whites. Vertical Hold Control - This control permits adjustment of vert...
Page 7 - SPECIFICATIONS; ELECTRICAL
Pelco Manual C933M (7/99) 7 SPECIFICATIONS ELECTRICAL Input Voltage: PMM1501 120 VAC, 60 Hz PMM1501-X 230 VAC, 50 Hz Power Consumption: PMM1501PMM1501-X 48 W Input Signal: 0.5 to 2.0 V peak-to-peak composite video, negative synchronization Input Impedance: 75 ohms or high (switchable) Bandwidth: 100...
Page 8 - REVISION HISTORY; REGULATORY NOTICES; Reorient or relocate the receiving antenna.
8 Pelco Manual C933M (7/99) REVISION HISTORY Manual # Date Comments C933M 2/97 Original version. 7/99 Revised Figures 1 and 2 to show external fuse. Updated to new format. Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. © Copyright 1999, Pelc...