Pelco NET104A - Manuals

Pelco NET104A – Manual in PDF format online.

Manuals:

Manual Pelco NET104A

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12

Summary

Page 3 - BEFORE YOU BEGIN; network administrator

C2900M-QS (9/02) 3 BEFORE YOU BEGIN Installation of PelcoNet ™ requires support from your network administrator . Contact your administrator to assist with STEP 2 – Configuring PelcoNet Using HyperTerminal. Write down thefollowing information from your network administrator: 1. A unique IP address f...

Page 4 - STEP 1A; CONNECTING THE TRANSMITTER – NET104A

4 C2900M-QS (9/02) STEP 1A CONNECTING THE TRANSMITTER – NET104A 1. Plug in cameras or other video sources with composite NTSC or PAL output. 2. Set DIP switches to position 75 OHM ON (down) to terminate the inputs when the video signal is not connected to additional video equipment through a T-conne...

Page 5 - STEP 1B; Skip this step if a receiver will not be used.; VIDEO OUT; Connect a network cable from the port labeled; TRANSPARENT DATA; to the correctly wired PV130 adapter, and

C2900M-QS (9/02) 5 2 3 4 5 6 7 1 8 2 1 3 4 4800, 8, NONE, 1 12 VDC PV130 PELCONET FRONT PANEL PELCONET BACK PANEL 12 VAC RD(A)RD(B) KBD300 DIRECT MODE STRAIGHT CABLE 00684 STEP 1B CONNECTING THE RECEIVER – NET101R/R-A NOTE: Skip this step if a receiver will not be used. 1. Plug in the supplied power...

Pelco Manuals