Pelco eh8106l - Manuals

Pelco eh8106l – Manual in PDF format online.

Manuals:

Manual Pelco eh8106l

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12

Summary

Page 4 - Installation; MOUNTING

4 C1420M-G (12/04) Installation MOUNTING To attach the enclosure to the pan and tilt unit, perform the following installation steps. 1. Make sure the tilt shaft on the pan and tilt unit is near horizontal so that the connector in the tilt shaft is pointing upward. 2. Lift the housing over the pan an...

Page 6 - MATING CONNECTOR ASSEMBLY; Control Cable

6 C1420M-G (12/04) MATING CONNECTOR ASSEMBLY To assemble the 16-pin mating connector, perform the following steps: 1. Discard the white plastic sleeve that is included with the connector assembly. Thread the cable through the compression nut/strain relief and connector shell. 2. Prepare the cabling ...

Page 7 - RECHARGING THE ENCLOSURE; POWER CONNECTION; Operation

C1420M-G (12/04) 7 RECHARGING THE ENCLOSURE You may use your own charging equipment or Pelco’s EH8000RKIT to recharge the enclosure. If you are using your own equipment, adjust the regulator for an output pressure of 12 psi (83 kPa). If you are using the EH8000RKIT, it uses a regulator with a fixed,...

Pelco Manuals