Pelco EH66X - Manuals - manualsarea.com

Page 2 - ii

TABLE OF CONTENTS Section Page 1.0 WARNINGS ........................................................................................................................................ 1 2.0 SCOPE ..............................................................................................................

Page 3 - iii

LIST OF ILLUSTRATIONS Figure Page 1 EH66/EH66X Dimension Drawing ................................................................................................. 2 2 Wiring Diagram for Window Defroster, Wiper/Washer and Blower/Heater Assemblies ................. 4 3 EH66 Enclosure with Wall Mount ....

Page 5 - prior to installation and operation.; CAUTION; Only use replacement parts recommended by Pelco.; literature accompanying this unit.; RISK OF ELECTRIC SHOCK.

Pelco Manual C411M-D (1/96) 1 Please thoroughly familiarize yourself with the information in this manual prior to installation and operation. This symbol indicates that dangerous voltageconstituting a risk of electric shock is present within this unit. CAUTION : TO REDUCE THE RISK OF ELECTRICALSHOCK...

Page 6 - Models With The Letters “HB”; in the suffix come; Models With The Letter “L”; in the suffix include; Figure 1

2 Pelco Manual C411M-D (1/96) 2.0 SCOPE The information contained within this manual coversthe EH66/EH66X Series environmental enclosure. 3.0 DESCRIPTION The EH66 Series is an all-weather environmental enclo-sure for 2/3" and 1" cameras with a maximum camera/lens size of 7" W x 7" H ...

Page 8 - Figure 2; to control

4 Pelco Manual C411M-D (1/96) Figure 2 . Wiring Diagram for Window Defroster, Wiper/Washer and Blower/Heater Assemblies to control

Page 9 - FIXED ENCLOSURE MOUNTING; Instructions for mounting the enclosure are as follows:; Figure 4; . EH66 Enclosure with; Figure 3; . EH66 Enclosure with Wall Mount

Pelco Manual C411M-D (1/96) 5 4.3 FIXED ENCLOSURE MOUNTING The are two types of mounts that can be used with theEH66 enclosure: wall, or pedestal/ceiling (see Figures3 and 4). Instructions for mounting the enclosure are as follows: 1. Select the appropriate mount (WM2000 for wallmounting or PM2000/P...

Page 10 - Figure 5; Wall Mount; Figure 6; Pedestal/Ceiling Mount

6 Pelco Manual C411M-D (1/96) 4.4 PAN/TILT ENCLOSURE MOUNTING The EH66 enclosure can also be mounted to a pan/tiltassembly in addition to the wall or pedestal/ceilingmount. To include the pan/tilt assembly in your configuration,perform the following steps: 1. Select the appropriate mount (WM2000 for...

Page 11 - WINDOW WIPER INSTALLATION; Connect cable to wiper box.; Figure 8; . Mounting Hole Dimensions

Pelco Manual C411M-D (1/96) 7 4.5 WINDOW WIPER INSTALLATION To install the window wiper kit, perform the followingsteps and refer to Figures 7 and 8: 1. Turn the EH66 enclosure over so the bottom isfacing up. 2. If necessary, lay out the locations of the four (4).171-inch diameter mounting holes usi...

Page 13 - Figure 9; . EH66 Enclosure Exploded Assembly Diagram; EXPLODED ASSEMBLY DIAGRAMS

Pelco Manual C411M-D (1/96) 9 Figure 9 . EH66 Enclosure Exploded Assembly Diagram 6.0 EXPLODED ASSEMBLY DIAGRAMS See Figures 9 and 10 for exploded assembly diagrams of the EH66 enclosure and WW66, WW66-5/220 wiper assembly.

Page 16 - WINDOW WIPER ASSEMBLY

12 Pelco Manual C411M-D (1/96) 7.2 MECHANICAL PARTS LIST FOR WW66 AND WW66-5/220 WINDOW WIPER ASSEMBLY Item No. Qty Description Part Number 1 3 Bearing 776003 2 1 Diode DIOPT40F 3 — Not used — 4 1 Switch SWIV3L 5 1 Spacer, 1/4" Hex x .6254-40 tap SPA8404 6 1 Transformer TRF21162.01.0CM 7 1 Pump ...

Page 18 - : When a single power source is; POWER REQUIREMENTS FOR; Assuming 7 watts

14 Pelco Manual C411M-D (1/96) 9.1 RECOMMENDED CABLE SIZE CAUTION : When a single power source is used for both the camera and accessories, thecamera power consumption must be taken intoconsideration when determining the wire gauge. The following cable sizes are the minimum recom-mended for use with...

Page 20 - Pelco

16 Pelco Manual C411M-D (1/96) Pelco 3500 Pelco Way, Clovis, CA 93612-5699 • (559) 292-1981 • (800) 289-9100 FAX (559) 292-3827 • (800) 289-9150 • www.pelco.com International customers call 1-559-292-1981 or FAX 1-559-348-1120 (Product specifications subject to change without notice.) C411M-D ®