Pelco EH5700 - Manuals - manualsarea.com

Page 2 - CONTENTS; LIST OF ILLUSTRATIONS

2 Pelco Manual C1432M-C (11/99) CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS ................................................................ 3 DESCRIPTION ................................................................................................................... 4 MODELS ...........

Page 3 - IMPORTANT SAFEGUARDS AND WARNINGS; Only use replacement parts recommended by Pelco.

Pelco Manual C1432M-C (11/99) 3 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and con-form to all local codes. 2. Unless the unit is specific...

Page 4 - DESCRIPTION; MODELS; INSTALLATION; Window Wiper Kit Modification; WINDOW WIPER KIT MODIFICATION; Wiper Modification

4 Pelco Manual C1432M-C (11/99) DESCRIPTION Window wiper kits in the WW57 Series are for installation in the EH5700 Series andEH5700L Legacy ® Series environmental enclosures. MODELS WW5723-1 Window wiper kit for EH5723/EH5723L, 120 VAC, 15 watts WW5723-2 Window wiper kit for EH5723/EH5723L, 24 VAC,...

Page 5 - Wiper Circuit Board Component Locations; Remove diodes D1 through D6.; Window Wiper Kit Installation

Pelco Manual C1432M-C (11/99) 5 R2 D1-D6 C3 ADD GREEN WIRE HERE JP1 Figure 2. Wiper Circuit Board Component Locations PCB9000275 REV. E P14719 CUTTRACEHERE X Figure 3. Circuit Side of Wiper Board 2. Remove diodes D1 through D6. 3. Replace resistor R2 with a 1/4-watt 470-ohm resistor. 4. Remove capac...

Page 6 - iper Driver Schematic

6 Pelco Manual C1432M-C (11/99) JP1 P1 1 2 3 1 2 3 R1 15K 5W CHANGE T O 470 Ω YEL VIO BR R3 22 U1 4N26 1 2 P4 1 2 3 4 5 6 JP2 110–220 110–220 JP3 JP4 JP5 3 2 1 3 2 1 3 2 1 3 2 1 F1 1.0A TRIP RV 2 D20 D22 D21 D23 D19 D18 D17 D16 D15 D14 D13 D12 D11 D10 D9 D8 R4 1K 3 U3 LM78L05 GND Vin Vo 2 1 +5 + C7 ...

Page 7 - WINDOW WIPER KIT INSTALLATION

Pelco Manual C1432M-C (11/99) 7 WINDOW WIPER KIT INSTALLATION For the following instructions, refer to Figure 10, if necessary. Table B lists the parts shownin Figure 10. 1. Turn off power to the enclosure. 2. Unlatch and raise the enclosure lid. The gas spring will hold the lid in place when it isf...

Page 9 - If you

Pelco Manual C1432M-C (11/99) 9 15. Remove the two screws on the bottom of the enclosure under the window and install the wiper assembly with two Allen cap screws that are supplied in the parts bag. Makesure the shaft of the wiper arm goes through the green bushing on the front of the en-closure. 16...

Page 11 - Wiper On/Off Connection

Pelco Manual C1432M-C (11/99) 11 Figure 8. Component Locations for Optional Circuit Board (O/I-PCB) Figure 9. Wiper On/Off Connection

Page 12 - Wire Gauge; Maximum distance from transformer to load; 4 VAC Wiring Distances; otal vA; An enclosure

12 Pelco Manual C1432M-C (11/99) Wire Gauge Maximum distance from transformer to load Table A. 24 VAC Wiring Distances The following are the recommended maximum distances for 24 VAC applications and arecalculated with a 10-percent voltage drop. (Ten percent is generally the maximum allowablevoltage ...

Page 13 - Exploded Assembly Diagram for Window Wiper

Pelco Manual C1432M-C (11/99) 13 6 4 A 16 SUPPLIED WITH BLOWER KIT Figure 10. Exploded Assembly Diagram for Window Wiper

Page 14 - Exploded Assembly Parts List for Window Wiper; Item

14 Pelco Manual C1432M-C (11/99) Table B. Exploded Assembly Parts List for Window Wiper Item Qty Description Part Number 1 1 Cam Assembly WW57001000ASSY 2 1 Wiper Arm Assembly MF00-5701-016 3 1 Wiper Shaft (EH5729 Series) MF00-5701-015 1 Wiper Shaft (EH5723 Series) MF00-5701-029 4 1 Wiper Driver Cir...

Page 15 - MAINTENANCE; SERVICE MANUAL

Pelco Manual C1432M-C (11/99) 15 MAINTENANCE As necessary, clean the window with a mild non-abrasive detergent in water and a soft clothto maintain picture clarity. To order replacement wiper blades, use the part number WW570010050 (3 inches). SERVICE MANUAL If you need to service the wiper assembly...

Page 16 - ® Pelco and the Pelco logo are registered trademarks of Pelco.; REVISION HISTORY; PRODUCT WARRANTY AND RETURN INFORMATION

16 Pelco Manual C1432M-C (11/99) ® Pelco and the Pelco logo are registered trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved. REVISION HISTORY Manual # Date Comments C1432M 10/95 Original manual. C1432M-A 4/96 Revision A. Revised installation instructions. C1432M-B 3/98 Added Section...