Pelco cc4700-2 - Manuals

Pelco cc4700-2 – Manual in PDF format online.

Manuals:

Manual

Manual Pelco cc4700-2

Summary

Page 2 - ii; CONTENTS; Section

22 Pelco Manual C1917M (12/97) ii CONTENTS Section Page 1.0 GENERAL .................................................................................................. 1 1.1 IMPORTANT SAFEGUARDS AND WARNINGS ............................... 11.2 REGULATORY NOTICES ........................................

Page 3 - iii

Pelco Manual C1917M (12/97) 23 LIST OF ILLUSTRATIONS Figure Page 1 Location of Parts and Controls .......................................................... 4 2 Removal of Camera Cover ................................................................. 5 3 Internal Switch Settings .......................

Page 4 - iv

24 Pelco Manual C1917M (12/97) iv (This page intentionally left blank.)

Page 5 - Only use replacement parts recommended by Pelco.; The product and/or manual may bear the following marks:; RISK OF

Pelco Manual C1917M (12/97) 1 Please thoroughly familiarize yourself with the information in this manual prior to installation and operation. 1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should beobserved. 1. Installation and...

Page 6 - Unpack and inspect all parts carefully.; RECOMMENDED TOOLS

2 Pelco Manual C1917M (12/97) 1.2 REGULATORY NOTICES This equipment has been tested and found to comply with the limits for a Class Adigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference when the equipment isopera...

Page 7 - The CC4700-2 color video camera has the following features:

Pelco Manual C1917M (12/97) 3 2.0 DESCRIPTION The CC4700-2 color video camera has the following features: ImagerThe camera uses a 1/2-inch CCD (Charge Coupled Device). High SensitivityThe camera gives a clear picture even under very gloomy conditions. CCD Iris FunctionEven when a manual iris lens is...

Page 8 - LOCATION OF PARTS AND CONTROLS; Figure 1. Location of Parts and Controls

4 Pelco Manual C1917M (12/97) 3.0 LOCATION OF PARTS AND CONTROLS Figure 1. Location of Parts and Controls MOUNTING SCREW HOLES BACK FOCUSADJUSTMENTSCREW LENS MOUNT (C-MOUNT) LENS CONNECTOR (4-PIN) POWERINDICATOR VIDEO OUTCONNECTOR POWER SWITCH GROUNDTERMINAL POWERTERMINALS(24 VAC) SYNC SWITCH WHITE ...

Page 9 - AGC; Figure 2. Removal of Camera Cover; Internal Switch Settings

Pelco Manual C1917M (12/97) 5 4.0 INSTALLATION 1. Remove the six (6) Phillips screws that hold the upper cover to the camerabody and remove the cover (refer to Figure 2). 2. Set the internal switches according to the conditions in which the camera willbe used (refer to Figures 2 and 3). Switch Setti...

Page 10 - Replace the upper cover on the camera body.; Pin; Unused; Figure 4. Lens Mount

6 Pelco Manual C1917M (12/97) 3. Replace the upper cover on the camera body. 4. Make sure that you have the right type of lens to install on the camera. The lens must be a C-mount type, and the screw thread must not project morethan 9 mm (3/8-inch) from the lens mounting surface (refer to Figure 4)....

Page 12 - Figure 8. Power and Video Connections; Be sure to connect

8 Pelco Manual C1917M (12/97) 8. Connect power to the camera (refer to Figure 8). This camera must always be operated with a 24 VAC class 2 power supply. Inthe U.S.A., use a power supply that is UL Listed. In Canada, use a powersupply that is CSA Certified. Refer to Table A for wiring distances. Whe...

Page 13 - Wire Gauge; Maximum distance from transformer to load; Table A. 24 VAC Wiring Distances; otal vA; An enclosure that re-; Distances are calculated in

Pelco Manual C1917M (12/97) 9 Wire Gauge Maximum distance from transformer to load Table A. 24 VAC Wiring Distances The following are the recommended maximum distances for 24 VAC applicationsand are calculated with a 10-percent voltage drop. (10-percent is generally the maxi-mum allowable voltage dr...

Page 14 - Table B. Video Coaxial Cable Wiring Distances; Maximum Distance

10 Pelco Manual C1917M (12/97) 9. Connect a video cable to the VIDEO OUT connector on the camera (refer toFigure 8). Refer to Table B for the type of video coaxial cable to use. 10. Set the SYNC (synchronization) switch. INT (internal): for using the internal synchronizing signal. L.L. (line lock): ...

Page 15 - Turn on the camera power and make the following adjustments.; Figure 9. White Balance Setting

Pelco Manual C1917M (12/97) 11 4.1 ADJUSTMENTS Turn on the camera power and make the following adjustments. 4.1.1 White Balance After fitting the lens and making all the installation connections, use a monitor tocheck the picture and set the white balance as described below (refer to Figure 9). AWB ...

Page 17 - Zoom Lens Models; With the camera operating, view an object at least 75 feet away.

Pelco Manual C1917M (12/97) 13 Zoom Lens Models 1. With the camera operating, view an object at least 75 feet away. 2. Make sure the lens iris is wide open.* If outdoors use a neutral density filter infront of the lens to insure that the iris is fully open. 3. Set the lens focus to infinity. 4. Adju...

Page 20 - Avoid operating or storing the unit in the following locations:; Extremely hot or cold places (operating temperature 14

16 Pelco Manual C1917M (12/97) 7.0 MAINTENANCE Be careful not to spill water or other liquids on the unit, or to get combustible ormetallic material inside the body. Foreign material inside the camera could cause itto fail or be a cause of fire or electric shock. Avoid operating or storing the unit ...

Page 22 - NOTE: VALUES IN PARENTHESES ARE CENTIMETERS ALL OTHERS ARE INCHES

18 Pelco Manual C1917M (12/97) Dimensions: See Figure 10 Weight: 660 g approx. (1 lb 7 oz) Fuse: 125 VAC, 500 mA (Design and product specifications subject to change without notice.) Figure 10. CC4700-2 Dimension Drawing BACK FOCUS LENS COLOR VIDEO CAMERA Hi Resolution 6.50 (16.51) 6.12 (15.54) 1.59...

Page 23 - NOTES

Page 24 - WARRANTY; RETURNS; WARRANTY AND RETURN INFORMATION

20 Pelco Manual C1917M (12/97) Pelco, the Pelco logo, Camclosure, Esprit,Genex, Legacy, and Spectra are registeredtrademarks of Pelco.Endura and ExSite are trademarks of Pelco. © Copyright 1997, Pelco. All rights reserved. WARRANTY Pelco will repair or replace, without charge, any merchandise proved...