Pelco C607M-E - Manuals - manualsarea.com

Page 3 - Contents

C607M-E (2/09) 3 Contents Regulatory Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Important Safety Instructions . . . . . . . . . . . ....

Page 4 - List of Illustrations

4 C607M-E (2/09) List of Illustrations 1 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 2 Front Panel (circuit breaker model shown) . ...

Page 5 - Regulatory Notices; RADIO AND TELEVISION INTERFERENCE

C607M-E (2/09) 5 Regulatory Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired...

Page 6 - Important Safety Instructions

6 C607M-E (2/09) Important Safety Instructions Observe the following warnings before installing and using this product. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this device near water. 6. Clean with a dry cloth only. 7. D...

Page 7 - Description; MODELS

C607M-E (2/09) 7 Description The RCS Series rack mount power supply consists of a multi-output, indoor, rack mounted power supply that can provide power from a single source for 8, 16, or 32 cameras. The RCS Series is designed with transformers that minimize voltage variances across the full range o...

Page 8 - Before You Begin; PARTS LIST

8 C607M-E (2/09) Before You Begin Before you begin, verify that your unit contains all of the parts listed in Figure 1. Figure 1. Package Contents To install your RCS Series rack mount power supply, you will need the following tools (not supplied): PARTS LIST Qty Description 1 Phillips screwdriver 1...

Page 9 - Indicators and Connections; FRONT PANEL

C607M-E (2/09) 9 Indicators and Connections FRONT PANEL The front panel of the RCS Series rack mount power supply contains the following indicators and mounting holes. Figure 2. Front Panel (circuit breaker model shown) NOTE: The additional holes on the front panel are used for the optional locking ...

Page 10 - REAR PANEL

10 C607M-E (2/09) REAR PANEL The rear panel of the RCS Series rack mount power supply contains the following connectors. Figure 3. Rear Panel Connectors ì= Voltage Selector Switch: Determines the voltage of the unit. By default, the unit is equipped for 115 VAC line voltage. î Input Fuse: Make sure ...

Page 11 - Rack Installation

C607M-E (2/09) 11 Rack Installation The RCS Series rack mount power supply fits into an industry-standard 19-inch (48 cm) equipment rack. Your unit occupies 1 RU (1.75 inches or 4.5 cm) of vertical rack space. The hardware necessary to mount the power supply into a rack is supplied with the unit. Th...

Page 14 - Connecting Devices to the Power Supply

14 C607M-E (2/09) Connecting Devices to the Power Supply Before you connect devices to the power supply, refer to Table A on page 7 and Table C on page 15 to determine the output wiring needed for each device. To connect a device to the power supply: 1. Attach one output wire to the “–” (neutral), a...

Page 16 - Circuit Breakers and Fuses; RESET A CIRCUIT BREAKER

16 C607M-E (2/09) Circuit Breakers and Fuses RESET A CIRCUIT BREAKER Circuit breakers are self-setting and do not need to be reset manually. REPLACE A FUSE Each power supply is provided with extra fuses should one need to be replaced. NOTE: This power supply does not support hot swapping of fuse(s)....

Page 17 - Specifications; POWER

C607M-E (2/09) 17 Specifications POWER Power Consumption Refer to Table D on page 15 Input Voltage 115 VAC, 60Hz or 230 VAC, 50Hz (± 10%), selectable Input Fuse Varies by model and input Output Voltage 26 VAC (all models) Output Current Varies by model Output Fuse Rating 3 A Fuse Type 5 x 20 mm AG F...

Page 19 - PRODUCT WARRANTY AND RETURN INFORMATION

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective inmaterial or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years: – Fiber optic products– TW3000 ...