Pelco C2429M - Manuals - manualsarea.com

Page 2 - CONTENTS; LIST OF ILLUSTRATIONS

2 Pelco Installation Manual C2429M (3/01) CONTENTS IMPORTANT SAFEGUARDS AND WARNINGS ......................................................................................................... 3 DESCRIPTION ..................................................................................................

Page 3 - IMPORTANT SAFEGUARDS AND WARNINGS; Only use replacement parts recommended by Pelco.

Pelco Installation Manual C2429M (3/01) 3 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. C A U T I O N : RISK OF ELECTRIC SHOCK. DO NOT OPEN. 1. Installation and servicing should only be done by qualified service personnel ...

Page 4 - DESCRIPTION; MODELS; Back Box Model

4 Pelco Installation Manual C2429M (3/01) DESCRIPTION The Heavy-duty Spectra is perfect for installations where structural integrity and vandalism are a priority. The system features barrelkey locks, heavy-duty construction and a thick acrylic lower dome. The in-ceiling model has a reinforced bracke...

Page 5 - STEP 3 - INSTALL THE BACK BOX

Pelco Installation Manual C2429M (3/01) 5 b. Tur n the thumbscrew and open the hinged door to the back box. Pull wiringinto the back box through the conduitfitting. Refer to Tables A and B in theAppendix for wiring distances. 00535 c. Compress the spring clips on the backbox and push it through the ...

Page 6 - STEP 4 - WIRE CIRCUIT BOARD; If the LED does not light, refer to the; STEP 5 - INSTALL DOME DRIVE; TO USE YOUR DOME, REFER TO THE OPERATION AND; a. Set the DIP switches for SW1 and SW2 on the bottom of the; STEP 6 - INSTALL LOWER DOME; inch screws that secure the back box to the mounting ring.; b. Insert both keys in the barrel locks. Turn keys clockwise to the; d. Place lower dome over back box. Hold and turn both keys to

6 Pelco Installation Manual C2429M (3/01) STEP 4 - WIRE CIRCUIT BOARD Attach the wiring to the circuit board inside the back box. Whenfinished, close the door to the back box and turn on the power.The red LED will light. IMPORTANT: If the LED does not light, refer to the Trouble- shooting section. N...

Page 7 - a. Install the mount for the pendant dome. Refer to the instruc-; STEP 2 - WIRE CIRCUIT BOARD

Pelco Installation Manual C2429M (3/01) 7 INSTALLATION PENDANT MODELS STEP 1 - MOUNT AND INSTALL THE BACK BOX NOTE: If installing outdoors make sure the installation is properly sealed to keep moisture out. a. Install the mount for the pendant dome. Refer to the instruc- tions supplied with the moun...

Page 8 - STEP 3 - INSTALL DOME DRIVE; b. Line up the green and red tabs with the green and red labels.; STEP 4 - INSTALL LOWER DOME; the groove on the trim ring of the lower dome.; Environmental Model only:; Plug the two-pin heater

8 Pelco Installation Manual C2429M (3/01) STEP 3 - INSTALL DOME DRIVE TO USE YOUR DOME, REFER TO THE OPERATION AND PROGRAMMING MANUAL. b. Line up the green and red tabs with the green and red labels. Push in on the tabs. Insert the side with the green tab, then theside with red tab. Continue pushing...

Page 9 - TROUBLESHOOTING

Pelco Installation Manual C2429M (3/01) 9 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Unit does not operate.The controller is notcommunicating withthe Spectra unit. Fan does notoperate. Vertical roll on monitorwhen switchingbetween cameras. DOME 1POWER DOME 2POWER DOME 3POWER Check to see if the...

Page 10 - APPENDIX; Video Coaxial Cable Wiring Distances

10 Pelco Installation Manual C2429M (3/01) APPENDIX Table A. Video Coaxial Cable Wiring Distances Cable Type* Maximum Distance RG59/U 750 ft (229 m) RG6/U 1,000 ft (305 m) RG11/U 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance. All-copper center conductor.95% braided copper shield. ...

Page 14 - SPECIFICATIONS; MECHANICAL

14 Pelco Installation Manual C2429M (3/01) SPECIFICATIONS MECHANICAL Construction Back box: Aluminum Dome drive: Aluminum, ABS plastic Lower dome: Acrylic Cable Entry In-Ceiling: .75-inch (1.91 cm) conduit fitting Pendant: Through 1.5-inch (3.81 cm) NPT pendant mount Pan Movement: 360 ° continuous p...

Page 15 - GENERAL; Back Box

Pelco Installation Manual C2429M (3/01) 15 GENERAL Environment In-Ceiling: Indoor only Pendant: Indoor/outdoor Operating Range In-Ceiling: 32 to 140 ° F (0 to 60 ° C) intermittent operation; 32 to 122 ° F (0 to 50 ° C) continuous operation Pendant Without Heater: 32 to 140 ° F (0 to 60 ° C) absolute...

Page 16 - REVISION HISTORY; Date; PRODUCT WARRANTY AND RETURN INFORMATION

16 Pelco Installation Manual C2429M (3/01) REVISION HISTORY Manual # Date Comments C2429M 3/01 Original version. Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. Endura and ExSite are trademarks of Pelco. Loctite is a registered trademark of L...