Pelco C1498M-A - Manuals - manualsarea.com

Page 2 - CONTENTS

2 Pelco Manual C1498M-A (7/99) LIST OF ILLUSTRATIONS Figure Page 1 System Components (In-Ceiling Model Shown) ................................................ 3 2 Backlight ........................................................................................................... 12 LIST OF TABLES T...

Page 3 - MODELS; INSTALLATION; For Coaxitron; must

Pelco Manual C1498M-A (7/99) 3 IMPORTANT SAFEGUARDS AND WARNINGS Observe the following warnings before installing and using this product. 1. Installation and servicing should only be done by qualified service personnel andconform to all local codes. 2. Unless the unit is specifically marked as a NEM...

Page 4 - Make; Table A. Switch Settings for SW1

4 Pelco Manual C1498M-A (7/99) 2. Set the switches on the bottom of the dome drive. Refer to Table A for the settings forSW1, and Table B and Table C for SW2. 3. Install the dome drive in the back box. Line up the green tab and red tab on the domedrive with the green label and red label on the back ...

Page 5 - Table C. Switch Settings for SW2 – D-Type Control

Pelco Manual C1498M-A (7/99) 5 Receiver Address Switch Setting SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-8 1 ON OFF OFF OFF OFF OFF OFF OFF 2 OFF ON OFF OFF OFF OFF OFF OFF 3 ON ON OFF OFF OFF OFF OFF OFF 4 OFF OFF ON OFF OFF OFF OFF OFF 5 ON OFF ON OFF OFF OFF OFF OFF 6 OFF ON ON OFF OFF OFF OF...

Page 9 - OPERATION; The dome will stop

Pelco Manual C1498M-A (7/99) 9 225 ON OFF OFF OFF OFF ON ON ON 226 OFF ON OFF OFF OFF ON ON ON 227 ON ON OFF OFF OFF ON ON ON 228 OFF OFF ON OFF OFF ON ON ON 229 ON OFF ON OFF OFF ON ON ON 230 OFF ON ON OFF OFF ON ON ON 231 ON ON ON OFF OFF ON ON ON 232 OFF OFF OFF ON OFF ON ON ON 233 ON OFF OFF ON ...

Page 10 - For American

10 Pelco Manual C1498M-A (7/99) PAN AND TILT FUNCTIONS Use your controller ’s joystick to control pan and tilt operation. • Fixed-Speed Controllers - Pan and tilt operation is at a fixed speed; the controller determines the speed. • Variable-Speed Controllers - Depending on the joystick’s position, ...

Page 12 - Compensation

12 Pelco Manual C1498M-A (7/99) CM9750 1. Turn the KEY SWITCH to the ON position. 2. Press the PROG key. PROGRAM appears on the LCD screen. 3. Press the PRES key. The PRESET prompt appears. 4. Enter 95 and press the ENTER key. The main menu appears. 5. Turn the KEY SWITCH to the OFF position. CM9760...

Page 14 - SHUTTER SPEED

14 Pelco Manual C1498M-A (7/99) 2. If the cursor (>) is not beside Camera, move the joystick up or down to position thecursor beside Camera. 3. Press the Iris Open button to enter the Camera submenu. 4. Move the joystick up or down to position the cursor beside Auto-Iris. 5. Press the Iris Open b...

Page 15 - AUTO WHITE BALANCE -

Pelco Manual C1498M-A (7/99) 15 SHARPNESS The two modes for adjusting the picture sharpness are automatic and manual. To changethe mode: 1. On the main menu, move the joystick up or down to position the cursor (>) beside Camera. 2. Press the Iris Open button to enter the Camera submenu. 3. Move t...

Page 16 - AUTO FLIP; MANUAL LIMIT STOPS

16 Pelco Manual C1498M-A (7/99) • Park – The dome moves to preset 1 when the power-up sequence finishes. The only text on the screen is the preset label (if any). • Scan Auto – The dome initiates scan mode when the power-up sequence finishes. Again, there is no text. • Scan Frame – The dome initiate...

Page 17 - SCAN LIMIT STOPS; PARK TIME MINUTES; TROUBLESHOOTING; NOTE

Pelco Manual C1498M-A (7/99) 17 SCAN LIMIT STOPS Refer to the documentation for your control system for programming presets, then do thefollowing: 1. Make sure limit stops are turned ON (refer to the Limit Stops section), then exit the menu. 2. Push the joystick left until you reach the limit you wa...

Page 18 - BACK BOX ELECTRONIC ASSEMBLY REMOVAL

18 Pelco Manual C1498M-A (7/99) 4. Remove the dome drive: Push in on the green drive eject tab on the side of the domedrive and gently rock the dome drive to release the latch. When the green latchreleases, pull the dome down. 5. Do one of the following: • If your problem was that the unit would not...

Page 19 - SPECIFICATIONS; MECHANICAL

Pelco Manual C1498M-A (7/99) 19 SPECIFICATIONS MECHANICAL Pan Movement: 360 ° continuous pan rotation Vertical Tilt: Unobstructed +2 ° to -92 ° Manual Pan Speed: 0.5 ° -80 ° /sec manual operation, 150 ° /sec turbo Manual Tilt Speed: 0.5 ° -40 ° /sec Preset Speeds Pan: 250 ° /sec Tilt: 200 ° /sec Fix...

Page 20 - REVISION HISTORY; WARRANTY AND RETURN INFORMATION; REGULATORY NOTICES

20 Pelco Manual C1498M-A (7/99) REVISION HISTORY Manual # Date Comments C1498M 2/99 Original version. 3/99 Removed reference to line synchronization. Added material on auto iris. Added FCC notice. C1498M-A 7/99 Revised the preset tilt speed from 100 to 200 degrees/second. Added model number and spec...