Pelco BB5T - Manuals - manualsarea.com

Page 2 - REVISION HISTORY; CONTENTS; LIST OF ILLUSTRATIONS

2 Pelco Manual C1488M-B (2/99) REVISION HISTORY Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Revised the manual to incorporate Spectra™Lite material. C1448M-B 2/99 Rev B. Revised the input power ratings, certifications,and operating temperatures. Revised model numbers fo...

Page 3 - IMPORTANT SAFEGUARDS AND WARNINGS; Only use replacement parts recommended by Pelco.; The product and/or manual may bear the following marks:; RISK OF; Please thoroughly familiarize yourself with the information

Pelco Manual C1488M-B (2/99) 3 1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should beobserved. 1. Installation and servicing should only be done by qualified service personneland conform to all local codes. 2. Unless the unit...

Page 4 - REGULATORY NOTICES; Reorient or relocate the receiving antenna.

4 Pelco Manual C1488M-B (2/99) 1.2 REGULATORY NOTICES NOTE: This equipment has been tested and found to comply with the limits of aClass B digital device, pursuant to part 15 of the FCC rules. These limits are de-signed to provide reasonable protection against harmful interference in a residen-tial ...

Page 5 - Back Box Parts; UNPACKING INSTRUCTIONS; PENDANT MODELS; RECOMMENDED TOOLS

Pelco Manual C1488M-B (2/99) 5 Figure 1. Back Box Parts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING& LOCK NUT T-RAIL CLIP 1.3 UNPACKING INSTRUCTIONS Unpack and inspect all parts carefully. Be sure to save the shipping box and any inserts. They are the safest material inwhich to make future shipm...

Page 7 - CEILING AND BACK BOX PREPARATION; Carefully cut the circle out of the ceiling.; Be careful; Compass Tool

Pelco Manual C1488M-B (2/99) 7 3.0 INSTALLATION FOR IN-CEILING MODELS This manual covers the installation of the BB5A-F, BB5A-PB, BB5A-PG, BB5A-PG-E,BB5T-F, BB5T-PG, and BB5T-PG-E back boxes only. For complete installation andoperating instructions for the SD5 Series of Spectra™ (Software Version 3....

Page 8 - The ceiling; Cable Type* Maximum Distance

8 Pelco Manual C1488M-B (2/99) 3.1.2 Suspended Ceiling 1. Remove the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remove the compass tool from the parts bag (refer to Figure 2). Press thestu...

Page 9 - HARD CEILING

Pelco Manual C1488M-B (2/99) 9 Figure 4. Installing Back Box Figure 5. Fastening Back Box HARD CEILING OR CEILING TILE T-RAIL CLIPFORCEILING TILE HARD CEILING OR CEILING TILE T-RAIL CLIPFORCEILING TILE

Page 10 - THUMBSCREW; Wiring Diagram for SpectraTM Lite

10 Pelco Manual C1488M-B (2/99) Figure 6. Wiring Diagram for Spectra™ (Ver. 3.0) and Spectra II™ THUMBSCREW Figure 7. Wiring Diagram for Spectra™ Lite CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL RELAY (WIRING EXAMPLE)

Page 11 - Table B.; 4 VAC Wiring Distances; Wire Gauge

Pelco Manual C1488M-B (2/99) 11 Table B. 24 VAC Wiring Distances The following are the recommended maximum distances for 24 VAC with a 10-percent voltage drop. (Ten percent is generally the maximum allowable voltage dropfor AC-powered devices.) Wire Gauge 20 18 16 14 12 10 30 vA 94 ft 150 ft 238 ft ...

Page 12 - BACK BOX INSTALLATION; Install the ceiling; If; Interconnect Door

12 Pelco Manual C1488M-B (2/99) 3.3 BACK BOX INSTALLATION 1. Suspended Ceiling Only (for hard ceiling, go to step 2) – Install the ceiling tile with the back box. Attach a T-rail clip on each side of the ceiling tile asshown in Figure 5. 2. Install a safety chain or cable (not supplied) that will su...

Page 13 - BACK BOX CONNECTIONS; Connect earth ground to the middle connector on the power; Make sure; Transformer Wiring; If each dome

Pelco Manual C1488M-B (2/99) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, refer to either Figure 10 or 11 to attach the wiring to theinterconnect circuit board inside the back box. Also refer to Figure 6 or 7 if necessary. 1. Earth Ground - Connect earth ground to the middle connector ...

Page 14 - Interconnect Circuit Board for SpectraTM Lite; Connect only a low volt-

14 Pelco Manual C1488M-B (2/99) From controller To 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ 4. Control - If you are using a Coaxitron ® controller, control signals will be trans- mitted over the video coax. If you are using RS-422 (P or D) control signals, connect the control...

Page 15 - INSTALLATION FOR PENDANT MODELS; If outdoors, apply Duct

Pelco Manual C1488M-B (2/99) 15 4.0 INSTALLATION FOR PENDANT MODELS 4.1 PENDANT-MOUNT INSTALLATION 1. Install the pendant dome mount. Refer to the instructions provided with themount. If the mount is outdoors, make sure it is properly sealed to keep mois-ture out. 2. Bring the wiring for the dome th...

Page 16 - To remove the back box electronic assembly:

16 Pelco Manual C1488M-B (2/99) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red power LED on the door of the interconnect circuit board in the back boxdoes not light: 1. Turn off power. 2. Open the door to the interconnect circuit board and check the fuse. Refer toFigure 10 for the locat...

Page 18 - SD5 Series Dimension Drawing; Weight

18 Pelco Manual C1488M-B (2/99) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NOTE: VALUES IN PARENTHESES ARE CENTIMETERS, ALL OTHERS ARE INCHES. 5 . 9 0 ( 1 4 . 9 9 ) 1 0 . 9 02 7 . 6 9 6 . 7 5 ( 1 7...

Page 19 - NOTES

Page 20 - WARRANTY AND RETURN INFORMATION; WARRANTY; RETURNS

20 Pelco Manual C1488M-B (2/99) 7.0 WARRANTY AND RETURN INFORMATION Pelco, the Pelco logo, Camclosure, Esprit,Genex, Legacy, and Spectra are registeredtrademarks of Pelco.Endura and ExSite are trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved. WARRANTY Pelco will repair or replace, w...