Pelco BB08 - Manuals - manualsarea.com

Page 2 - CONTENTS; REVISION HISTORY; Manual revised to include updated wiring information.; LIST OF ILLUSTRATIONS

2 Pelco Manual C456M-D (1/98) CONTENTS Section Page 1.0 GENERAL .................................................................................................. 3 1.1 IMPORTANT SAFEGUARDS AND WARNINGS ............................... 31.2 UNPACKING INSTRUCTIONS ........................................

Page 3 - Only use replacement parts recommended by Pelco.; The product and/or manual may bear the following marks:; RISK OF

Pelco Manual C456M-D (1/98) 3 Please thoroughly familiarize yourself with the information in this manual prior to installation and operation. 1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should beobserved. 1. Installation and...

Page 5 - The BB08 Series of back boxes is part of the IDS08 Intercept

Pelco Manual C456M-D (1/98) 5 2.0 DESCRIPTION The BB08 Series of back boxes is part of the IDS08 Intercept ® Series of domes. The IDS08 Series is an integral system that includes a back box (BB08), domedrive (DD08), dome receiver/driver (DRD08), and imager/optics package (IOP08). This manual covers ...

Page 6 - SUSPENDED CEILING; are

6 Pelco Manual C456M-D (1/98) 3.0 INSTALLATION 3.1 SUSPENDED CEILING 1. Remove the ceiling tile from the ceiling. If you are installing the back box into a2' x 4' (61 x 122 cm) ceiling grid, cut the tile in half and install an additional “T”bar for support. Reinstall one of the 2' x 2' (61 x 61 cm) ...

Page 7 - Video Coaxial Cable Requirements; Maximum Distance; Wire Gauge; Maximum distance from transformer to load; 4 VAC Wiring Distances; otal vA consumed; An enclosure that re-

Pelco Manual C456M-D (1/98) 7 Table A. Video Coaxial Cable Requirements Cable Type* Maximum Distance RG59/U 750 ft (229 m) RG6/U 1,000 ft (305 m) RG11/U 1,500 ft (457 m) * Minimum cable requirements: 75 ohmsAll-copper center conductorAll-copper braided shield with 95% braid coverage Wire Gauge Maxim...

Page 8 - “T-Bar” Clip Installation

8 Pelco Manual C456M-D (1/98) 3. To create an opening for the wiring, use a hammer and punch to remove oneof the knockouts in the top of the back box. If it is necessary to work inside theback box, remove the trim ring and dome by inserting a screwdriver or yourfingers between the trim ring and the ...

Page 9 - 4 VAC Back Box Wiring Diagram

Pelco Manual C456M-D (1/98) 9 Figure 2. 24 VAC Back Box Wiring Diagram

Page 10 - 20 VAC Back Box Wiring Diagram

10 Pelco Manual C456M-D (1/98) Figure 3. 120 VAC Back Box Wiring Diagram

Page 11 - The length of pipe may cause

Pelco Manual C456M-D (1/98) 11 12. If you are not using Coaxitron ® control, connect the control wiring to RXD+ and RXD-. From controller To 4-wire terminal inside back box TXD+ RXD+ TXD- RXD- 13. Back box installation is now complete. Proceed with the installation of the dome drive unit. Refer to t...

Page 12 - not; using Coaxitron

12 Pelco Manual C456M-D (1/98) 13. If you are not using Coaxitron ® control, connect the control wiring to RXD+ and RXD-. From controller To 4-wire terminal inside back box TXD+ RXD+ TXD- RXD- 14. The bezel and dome assembly can be attached to the back box at this time, or it can be done after the d...

Page 13 - BB08A120 Back Box Exploded Assembly Diagram; EXPLODED ASSEMBLY DIAGRAMS

Pelco Manual C456M-D (1/98) 13 Figure 4. BB08A120 Back Box Exploded Assembly Diagram 4.0 EXPLODED ASSEMBLY DIAGRAMS E F A B 4 C D 6 2 3 5 7 8 1

Page 15 - BB08A120 Back Box Exploded Assembly Parts List (Figure 4)

Pelco Manual C456M-D (1/98) 15 Table C. BB08A120 Back Box Exploded Assembly Parts List (Figure 4) Item Quantity Description Part Number 1 1 Trim ring, white 8082ASSY 1 Dome seal (not shown) 80810007 1 Fixed dome, smoked (not shown) 80810008-4 1 Sound quieting ring (not shown) 8083001 2 1 Back box 80...

Page 16 - Back Plate Exploded Assembly Diagram

16 Pelco Manual C456M-D (1/98) Figure 6. Back Plate Exploded Assembly Diagram

Page 17 - Back Plate Exploded Assembly Parts List

Pelco Manual C456M-D (1/98) 17 Table E. Back Plate Exploded Assembly Parts List Item Quantity Description Part Number 1 2 Latch backup plate 8004244COMP 2 2 Latch 8004105COMP 3 2 Latch bracket 8004143COMP 4 1 Transformer (120 VAC model only) TRF21243.30.70F 5 1 25-position connector plug CON10P025Z4...

Page 20 - WARRANTY AND RETURN INFORMATION; WARRANTY

20 Pelco Manual C456M-D (1/98) 6.0 WARRANTY AND RETURN INFORMATION Pelco, the Pelco logo, Camclosure, Esprit,Genex, Legacy, and Spectra are registeredtrademarks of Pelco.Endura and ExSite are trademarks of Pelco. © Copyright 1998, Pelco. All rights reserved. WARRANTY Pelco will repair or replace, wi...