Metra 95-7504 - Manuals

3 95-7504 KIT ASSEMBLY A B C DOUBLE DIN RADIO PROVISION Slide the Double DIN radio into thebracket/radio housing assembly andsecure the radio to the assembly usingthe screws supplied with the radio.Snap the trim plate onto the front ofthe radio housing. (Figure B) 2 Attach the (2) PC-7503 panel clip...

95-7504 KIT ASSEMBLY 4 A B STACKED ISO UNITS PROVISION Snap the Double DIN brackets to theinside edge of the radio housing. (Figure A) 1 Slide the stacked ISO units into thebracket/radio housing assembly andsecure the units to the kit using thescrews supplied with the units. Snapthe trim plate onto ...

Note: When inserting the 99-7504 into the sub dash be aware of the locations pointed out in Figure B . If the 99-7504 does not snap in correctly the result will be a noticeable gap on eachside of the installation kit. (Figure C) 95-7504 FINAL ASSEMBLY FINAL ASSEMBLY (A) Strip wire ends back 1/2"...

FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with thehead unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electric...