Metra GMLAN29-100 - Manual
Metra GMLAN29-100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – TABLE OF CONTENTS
- Page 4 – From the 22 way harness:; Connect the Black wire to the ground wire of the aftermarket radio
- Page 5 – PROGRAMMING SWC; Turn on the ignition
- Page 6 – NOTES
- Page 8 – REV; INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
1-800-221-0932
axxessinterface.com
INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100
The GMLAN29-100 is designed to and MUST be used with the
GMOS-100i (SOLD SEPERATELY)
. Please refer to GMOS-100i
for 20 pin connector instructions
*Read Important Warning On Page 1
Before Attempting Any Installation*
APPLICATIONS
GMLAN29-100
BUICK
Enclave 2007-10
Lucerne 2006-10
CADILLAC
Escalade 2007-10
DTS 2006-10
SRX 2007-09
CHEVROLET
Avalanche 2007-10
Equinox 2007-09
Express 2008-10
Impala 2006-2010
Monte Carlo 2006-2007
Silverado (new body) 2007-10
Suburban 2007-09
Tahoe 2007-09
Traverse 2009
GMC
Acadia 2007-10
Savanna 2008-10
Sierra (New body) 2007-10
Yukon 2007-10
HUMMER
H2 2008-09
PONTIAC
Torrent 2007-09
Vibe 2009
SATURN
Outlook 2007-09
Vue 2008-09
SUZUKI
XL-7 2007-09
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installing The Interface .............................................................. 1 Installing The GMLAN29-100 ................................................. 1 Programming SWC ..................................................................... 2 Testing The GMLAN29-100 ......................
*Important: Before beginning any of the following, disconnect the negative battery terminal to prevent an accidental short circuit. INSTALLING THE INTERFACE From the 22 way harness: Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis • Connect the 3.5mm jack to...
PROGRAMMING SWC Turn on the ignition • The LED will begin to blink rapidly • Turn on the aftermarket radio • Press volume up until radio responses • TESTING THE GMLAN29-100 Turn the ignition on, and then turn the aftermarket radio on. • Push the Onstar button, the radio should turn off (radio will m...
