Jacuzzi J-315 - Manuals

1 J-300 1.0 Important spa owner Information Your Jacuzzi J-300 Collection spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for efficient operation, an uncovered spa surfa...

2 J-300 3.0 Important safety Instructions for all spa owners reaD anD Follow all InsTruCTIons CareFullY! This spa was manufactured to meet the standards and specifications outlined in the “Virginia Graeme Baker Pool and Spa Safety Act” (VGB Safety Act). When installing and using this spa, basic safe...

5 J-300 10. CauTIon: To DeCrease rIsK oF proDuCT DamaGe. Maintain water chemistry in accordance with manufacturer’s • instructions. Proper chemical maintenance of spa water is necessary to maintain • safe water and prevent possible damage to spa components. 11. noTe: This spa is not intended nor des...

9 J-300 4.0 Choosing a location ImporTanT: Because of the combined weight of the spa, water and users, it is extremely important that the base upon which the spa rests be smooth, flat, level and capable of uniformly supporting this weight, without shifting or settling, for the entire time the spa is...

12 J-300 5.0 General electrical safety Instructions Your new Jacuzzi spa is equipped with a “state-of-the-art” equipment system. It contains the most advanced safety and self-protective equipment in the industry. Nonetheless, this spa must be installed properly to insure dependable usage. Please con...

14 J-300 export J-335, J-345, J-355, J-365 and J-375 Models (50 hz) 230V/20A* 230V/30A** 230V/40A*** Circuit Breaker: 20A 30A 40A Number of Wires: 3 3 3 Frequency: 50 Hz 50 Hz 50 Hz Current Draw: 15A 23A 29A * In 20A configuration, the heater will not operate while either jets pump is running in hig...

15 J-300 7.0 electrical wiring Instructions ImporTanT noTICe: The electrical wiring of this spa must meet the requirements of the National Electrical Code/USA (NEC) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local bu...

16 J-300 ANSI/NFPA 70. The disconnecting means must be readily accessible to the spa’s occupant but installed at least 5 feet (1.5m) from spa water. 7. The electrical circuit supplied for the spa must include a suitable ground fault circuit interrupter (GFCI) as required by NEC/USA Article 680-42. 8...

17 J-300 Figure B Control Box TB1 3 2 1 1. Terminal Block 2. Bonding Lug 3. Grounding Terminal GRN WHT WHT BLK BLK BLK RED 1 2 3 Figure-C TB1 to Circuit Board Power In GRN WHT WHT BLK BLK BLK RED RED RED 1 2 3 Figure-D TB1 to Circuit Board Power In Move Red Wire Here north american Convertible model...

18 J-300 8.0 spa Fill up procedure For best results, read each step in its entirety before proceeding with that step. 1. prepare The spa For Filling Clear all debris from the spa. (Although the spa shell has been • polished at the factory, you may want to treat it with a specially formulated spa cle...

22 J-300 warnInG: rIsK oF personal InJurY. To decrease the risk of injury, entrapment or drowning, • never leave your hot tub unattended for any reason, es- pecially if while the cover is open and accessible to small children and animals! To decrease the risk of • contracting a waterborne illness (e...

23 J-300 9.0 Control Functions 9.1 Control panel A. leD Display: Can display current water temperature (default display), water temperature set point, selected filtration/ heating mode, and error messages. B. warmer ( ) Button: Increases water temperature set point. C. Cooler ( ) Button: Decreases w...

24 J-300 9.2 General spa Features and Controls 1 7 8 11 2 2 2 2 2 5 5 3 4 6 13 13 13 13 15 15 14 5 10 10 10 12 9 6 17 17 17 16 16 16 16 Control Panel 1. Toggle Air Controls 2. Filter/Skimmer Grill 3. PowerPro MX Jets 4. Therapy Jets 5. Massage Selector Valves 6. Therapy Seat 7. Spa Light 8. Vertical...

25 J-300 10.0 operating Instructions The spa control system has automatic functions that operate upon start-up and normal operation to protect the system. Upon power up, the readout displays the following information:1. Control panel displays current software release (e.g. 3.57), then; 2. Control pa...

26 J-300 10.3 light on/off button Pressing this button activates the waterfall, footwell light, lighted cup holders, and backlit pillows lights in unison as follows: high - medium - low - off. note: Lights automatically turn off after 2 hours. 10.4 light mode Button This button offers 4 light modes ...

28 J-300 11.0 automatic Filtration Cycles Your new spa includes a 24-hour circulation pump which filters the water continuously. The circulation pump draws water through the skimmer bag and one of two filter cartridges to effectively remove small debris in your spa. note: The 24-hour circulation pum...

30 J-300 12.0 spa maintenance Proper and regular maintenance of your spa will help it retain its beauty and performance. Your authorized Jacuzzi dealer can supply you with all the information, supplies, and accessory products you will need to accomplish this. DanGer: rIsK oF severe InJurY or DrownIn...

33 J-300 Periodically, the filter cartridge will need a more thorough cleaning to remove imbedded oils and minerals. For this, we suggest cleaning as illustrated in step “F”, followed by soaking the filter overnight in a plastic container filled with a solution of water and specially formulated filt...

36 J-300 CauTIon: Turn oFF power To HoT TuB! 1. Turn off power to the spa. 2. Follow the directions on page 33 for draining the spa. 3. Turn the massage/diverter selector(s) into the middle combo position to allow the water in the plumbing lines to drain, see page 27. 4. Turn the waterfall valve(s) ...

37 J-300 hot tub investment. For specific guidance on maintaining water quality, consult your Authorized Jacuzzi dealer who can recommend appropriate chemical products for sanitizing and maintaining your hot tub. warnInG: FaIlure To maInTaIn waTer QualITY wIll: Increase risk of contracting a waterbo...

40 J-300 Contact your authorized Jacuzzi dealer or qualified service technician. To correct condition: Remove the spa's cover and allow your spa to cool down. • Program the filter settings for Economy Mode (page • 28). Raise water temperature setting to cancel Summer Logic condition (page 38). If th...

42 J-300 16.0 Circuit Board Diagrams 16.1 north american J-335, J-345, J-355, J-365 and J-375 Dedicated power models (60 Hz) This wiring diagram is used for all North American, 240V (60 Hz) dedicated power models. Optional Stereo And Power Supply (not of fered on J-325 Models) Power Supply O ZO N AT...

43 J-300 16.2 north american J-315 and J-325 Convertible Power Models (60 Hz) This wiring diagram is used for all North American 120/240V 60 Hz convertible power models. note: Optional 120/240 VAC 4-wire connection enhances heater output from 1kW to 4kW. O zo na to r (O pt io na l) O 3 GRN TB1 Stand...

44 J-300 16.3 export J-335, J-345, J-355, J-365 and J-375 Models (50 hz) This wiring diagram is used for all Export 230 VAC 50 Hz spa models. Optional Stereo And Power Supply Power Supply O ZO N AT O R (o pt io na l) O 3 GRN TB1 230 V AC 3-W ire Connection (50Hz, 1-Phase Service) USE COPPER CONDUCT ...

46 J-300 17.0 optional stereo receiver Functions 17.1 stereo receiver Control Functions SAT INFO AS-PS XBAS 2 ZONE SUBW BAND SE AR CH INT RPT RDM AUDIO ENTER MODE MULTI- ENVIRONMENT PLAYER TOP MENU AQ-CD-3 9 8 7 6 2 3 4 1 10 5 11 12 13 14 18 15 16 17 19 20 21 22 models equipped with the stereo optio...

49 J-300 mIDDle (middle level) • : User has 5 seconds to use the Volume Up or Down button to adjust the desired Middle level range from -6 to +6. mID-CFQ (middle Cent • er Frequency) : User has 5 seconds to use the Volume Up or Down button to adjust the desired Middle Range Center Frequency to 500 H...

50 J-300 SAT INFO AS-PS XBAS 2 ZONE SUBW BAND SE AR CH INT RPT RDM AUDIO ENTER MODE MULTI- ENVIRONMENT PLAYER TOP MENU AQ-CD-3 9 8 7 6 2 3 4 1 10 5 11 12 13 14 18 15 16 17 19 20 21 22 FaDer: • User has 5 seconds to use Volume Up or Down button to adjust the Fader between the front and rear speakers ...

52 J-300 SAT INFO AS-PS XBAS 2 ZONE SUBW BAND SE AR CH INT RPT RDM AUDIO ENTER MODE MULTI- ENVIRONMENT PLAYER TOP MENU AQ-CD-3 9 8 7 6 2 3 4 1 10 5 11 12 13 14 18 15 16 17 19 20 21 22 20. Preset 6/uP button: In Tuner mode, any station can be stored as preset 6 by simply pressing and holding this but...

54 J-300 General Power ................................................................................ DC 11.5 -14.4V Pre Output Voltage ................................................................................ 5V Current Consumption .............................................................

56 J-300 2. File/Folder Repeat play : Press the M3 button more than 3 seconds during playing MP3/WMA • disc for “repeat play” for all files of the current folder and keep on repeat playing the current folder until “repeat play” is disabled. To disable current folder “repeat play”, long press M3 butt...

58 J-300 ERROR Mechanism Error Press the eject button to correct the problem. If the error code does not disappear, consult your nearest service dealer Disc Error Maybe disc dirty/disc scratched/disc upside down Replace the disc 17.5 standard wireless remote Control Functions A remote control is sup...

60 J-300 17.7 wireless remote Battery replacement procedure 1. Turn the remote unit over and locate the battery door (Figure A). 2. Rotate the battery door, with a coin, counterclockwise until the dot aligns with the Open arrow (Figure B). 3. Remove battery door using coin to pry the door upward (Fi...